Toledo Fine Locks V190E-JA-US15 Instructions / Assembly
Contents
1. TQ2 ie INSTRUCTIONS FOR INSTALLATION OF TUBULAR LEVERSETS Latch Backset Adjustment Backset is a distance from the door edge to the centre of the hole on door face Some locks are supplied with adjustable latch which can fit 2 3 8 60mm or 2 3 4 70mm backset Just follow the steps shown below to change backset A does B ee C a This latch is set for b Keep spindle cam in correct c Your latch is now set for 2 3 4 70mm backset 2 3 8 60mm backset position as illustrated To reset 2 3 8 60mm backset just push spindle Pull spindle cam all the way cam back to left side to right Please make sure that the cams are staying with square shape Latch Face Plate Some locks are supplied with 4 way latch which can fit mortise in or drive in Er p a This latch is for mortise in b Rotate latch face clockwise 20 c This latch is for drive in and pull out latch face 2 Drill Holes O Start 36 914mm from floor fold and apply template a Drill 2 1 8 54mm hole on door face from both sides to from floor mark centre of door edge avoid wood splitting Select 2 3 8 60mm or 2 3 4 70mm backset as b Drill 1 25 4mm hole for latch desired and mark centre of hole on door face refer step 3c for drive in latch 3 Install Latch a Insert latch in hole mark outline of faceplate and chisel 5 32 4mm deep b Insert latch and tighten screws c Fo2. m 2 1 8 FOR BACKSET 60mm 2 3 8 J Fold on dotted line and fit on door edge Fold on dotted line and fit on door edge JIN 45 40 35 1 3 4 1 9 16 1 3 8 Make 1 25 4mm hole at center of door edge 5 5mm 7 32 x 2 hole for metal door only Rev 13 10 2011
3. r drive in latch drill 31 32 24 6mm hole and press latch until it is flush with door edge TQ2 TQ2 4 Reversible Levers TQ2 Insert spindle through latch LEFT RIGHT Press flush against door HAND DOOR HAND DOOR 6 Install Inside Lever Handle can be only installed when the timing of emergency release is set in the position shown below a Please check the levers are unlocked Entrance sets only Depressing lever catch with hand tool to release outside lever and pulling lever off Taking apart off the and cylinder from outside lever b Reversing the levers from outside to inside inside to out side putting the cylinder on the outside lever Entrance sets only Please do the same procedures for inside lever c Pushing handles in until catch clicks Make sure levers are retained by lever 7 Install Strike a Close door to make horizontal centre line of strike b Measure one half of door thickness from door stop and mark vertical centre line of strike Drill 1 25 4mm hole 1 2 13mm deep at intersection of horizontal and vertical line of strike Match screw holes on strike with WY Install inside lever and tighten screws until lock is firm centre lines on jamb Mark outline and chisel 1 16 1 6mm deep for strike c Install strike and tighten screws TEMPLATE FOR BACKSET 70mm 2 3 4 54m
Download Pdf Manuals
Related Search