gripSTIK CAP235 Instructions / Assembly
Contents
1. te HILLIP 9 Installation Recommendations MANUFACTURING CO Engineered to Perform ESIK gt gripSTIK Vinyl 2 Way 3 4 Bullnose Splay Corner Caps Installation Recommendations Phillips recommends installation in accordance with applicable ASTM standards and using prevalent industry standards General Installation Guidelines Phillips grip STIK vinyl 3 4 2 way bullnose splay corner caps are designed to finish where 2 Outside 3 4 Bullnose Splay Corners intersect and can be installed using a variety of methods The method listed below is a guideline Outside i Outside Method Spray Adhesive Spla gripSTIK Spray Adhesive Recommended Splay p ay 1 For 3 4 radius bullnose corner beads and corner caps installation drywall must be set back so it does not interfere with bullnose radius 2 The installation of gripSTIK vinyl 3 4 2 way bullnose splay corner caps Drawing must occur before the installation of the 3 4 bullnose splay corner beads Not to Scale see separate installation guide 3 Puta coat of spray adhesive on the back of the corner cap a Immediately apply cap to drywall and position in place b If the adhesive dries too long it will be hard to reposition c At some point the adhesive will lose tackiness and will not bond If this happens reapply adhesive to cap 4 The rate at which the adhesive dries varies depending on heat and humidity Test in your conditions 5 Use handle of your taping2. knife or installation tool to apply pressure along mud flanges perforated sections Bond strength is greatly enhanced with this crucial step 6 Staple each mud flange perforated sections with several 1 2 crown staples 7 Pressure the mud flanges again see step 5 8 Install 3 4 bullnose splay corner bead following corner bead installation instructions see separate installation guide 9 No primer is needed Finish as usual 10 For cold weather winter applications please refer to the installation recommendations in the Gypsum Association GA 220 06 of 40 F or warmer With Phillips gripSTIK vinyl beads trims and corner caps No mud additives needed No primer needed Made in the U S A Phillips is proud that all our beads trims and accessories are made in the United States of America 2012 Phillips Manufacturing Company p Version 1 0 Page 1 of 1 PHILLIPSmrc com
Download Pdf Manuals
Related Search