Alsa Refinish SG-01 Instructions / Assembly
Contents
1. algar nish APPLICATION GUIDE SUPER GLOW PAINT ADDITIVE How to Apply Application Steps 1 If your piece is already painted with a base coat you can proceed to step 15 Make sure you have good conditions for spraying The best temperature for spraying this paint is 70 80 degrees F and humidity of no greater than 50 3 Always apply paints in a well ventilated area and wear a NIOSH approved respirator to avoid breathing any fumes 4 lf your piece is already base coated you can proceed to step 14 5 Prepare and prime your part first Epoxy primers are best for bare metal and primer surfacers are best for plastics fiberglass or wood Some plastics may require an adhesion promoter but most plastics like ABS plastic are fine without adhesion promoters 6 Before applying your primer remove all dirt grease oil salt and chemical contaminants by washing the surface with a commercial detergent or other suitable cleaning method 7 Rinse with fresh water and allow to completely dry 8 Remove any existing loose paint or rust etc with a wire brush or sand paper 9 Lightly sand glossy surfaces to create a surface profile for adhesion 10 Apply your primer to the surface according to the manufacturer s specifications for your particular primer 11 Let your primer cure according to the manufacturer s specifications for your particular primer 12 Lightly scuff your primer with 800 1000 grit sand paper or you can also us2. e a red scotch brite pad to create a surface profile for adhesion 13 Apply your base coat color over the primer according to the manufacturer s specifications for your particular base coat using steady even passes until you achieve coverage 14 Let your base coat flash for 10 15 minutes and then you are ready to apply the Super Glow 15 If your piece is already base coated and cured then lightly scuff your base coat with 800 1000 grit sand paper or a red scotch brite pad to create a surface profile for adhesion 16 Mix your Super Glow powder into your choice of clear carrier at a ratio of 4 6 ounce per pint of ready to spray carrier 17 Once you have your Super Glow mixed into your carrier begin applying this over your white base coat as you would any clear coat Apply 3 5 coats with 10 15 minutes dry time between coats depending on how strong you want the effect You can then expose the piece to light for a few minutes and then check it ina dark room for desired effect If additional coats are desired you can add them as needed 18 Keep shaking or stirring the paint as this powder is very heavy and will settle in the cup of your pant gun if not kept moving 19 Once the desired strength of effect is achieved let that last coat dry for an additional 10 15 minutes and then apply one FINAL coat of just clear coat such as Alsa s Speed Clear to add depth and an additional layer of protection
Download Pdf Manuals
Related Search