Pittsburgh Corning 100745.0 Instructions / Assembly
Contents
1. window using 10 x 3 1 2 long flat head treated wood screws Spacing of the screws shall be as follows Start within 1 from each corner and spaced no more than 7 on center per each of four sides Be sure to screw through Existing Wood Buck If window is Anchor window using ordered with a 2x8 wood frame the n a 2x8 can serve as the wood buck treated 10 x 3 1 2 long Shim flat head wood screws 8 x8 x4 THICKSET 90 Block SSSSSSSSSESSESSUSESSASUSSSCHSSSSSSSSSSSSSSTASD Existing CMU Substrate Bead of caulking Pa Exterior Finish CMU Wall Detail Anchor window using treated 10 x 3 1 2 long Shim flat head wood screws Existing Wood Stud 8 x8 x4 el 90 Block all shims Pre drill all holes All screws must be driven perpendicular to the frame All screw heads should be flush or countersunk optional to the wood frame Properly caulk and seal the window Clean and maintain the glass block with any common household glass cleaner lt PITTSBURGH CORNING pittsburghcorning com Existing 2x6 Stud Wall A Sheathing Board Caulking eol Exterior Finish Siding or Brick Trim Moulding Caulking Wood Framing Wall Detail WFHW INSTALL 01 6 082. PITTSBURGH CORNING CORPORATION LIGHTWISE RESIDENTIAL SYSTEMS Wood Framed Hurricane Resistant Glass Block Window INSTALLATION INSTRUCTIONS Materials Included co One 1 Pittsburgh Corning Wood Framed Hurricane Resistant Glass Block Window Installation Instructions Window installation standards such as ASTM E2112 Standard Practice for Installation of Exterior Windows Doors and Skylights should be followed where applicable Maintain window in an upright position during shipping storage and while on site Immediately before installation carefully remove all protective wrapping and support lumber from window Caution Remove only the support lumber not the window frame Lift or hoist window from the bottom Caution Do not lift the window from the top as this could damage the window Place window into opening with flush side toward the exterior Shim window level and plumb and secure shims Window must be anchored from the interior side Refer to the Rough Opening Chart for window opening dimensions NOTE In masonry or concrete walls the window openings must be fitted with wood bucks to accommodate anchorage of the window Secure wood bucks into masonry or concrete using 3 16 x 1 embedment depth Hilti Kwik Con II fasteners or equal at 6 to 7 on center spacing Countersink all fastener heads into wood buck frame All rough opening dimensions apply to within wood buck framing Anchor
Download Pdf Manuals
Related Search