Unique Home Designs 5WG810BLACKFORK Installation Guide
Contents
1. A i i Interior Wall D Hex Bolt CUT CABLE SHIELD ONLY BE CAREFUL NOT TO DAMAGE CABLE USE FILE TO CUT SHIELD COIL REMOVE EXCESS SHIELD Position window guard to be centered with the window l opening Take care to center and level window guard with Close and level window guard window opening Position hinges by pulling in and out of window guard frame so holes are centered with framework of home around the window opening j Fasten cables to stand off with cable clamp Caution Do not PY Center on 2 x 4 stud Center bullets on 2 x 4 and mark Tar pinch cables TEST THE RELEASE MECHANISM Make sure guard stays Measure 5 8 above bullet Remove slack from cables Cut SEVERAL TIMES TO INSURE PROPER centered and even all marks and make another cables equally approx 4 below OPERATION around the opening Mark mark Using a 7 16 drill bit drill cable shield center of hinge holes with through the wall CA i 5 THE GUARD SHOULD SPRING FREE pencil and place window l OF OPENING UPON ACTUATION AND guard to the side Feed cables through holes at top of CLOSE EASILY pedal and under clamp on backside lll Pre drill holes using a 3 10 DO NOT SLAM GUARD TO CLOSE drill bit To assemble hinge insert offset Place window guard back bracket into slot of pedal and mount up lining up hinge holes with a lag screw B through the with the pre drilled holes bottom hole of the stand of2. Foot Operated Release Kit mea n sta lation n structions P UNIQUE HOME DESIGN S ined A Install lock bodies on bullets and i cables Ka wall 7 UW IMPORTANT USE LONG Tool List 7 WITTIIT Close guard inserting post on backside of lock body into CABLES FOR UPPER LATCH USE SHORT CABLE FOR LOWER LATCH i 7 16 hole TN i eo 2x 4 stud OC cC With window guard and lock body in i place pre drill holes with 3 16 drill bit Drill D Secure lock bodies with one way Cordless or electric 3 16 Bit 7 16 Bit One way Driver Wrench or socket set Tape Measure Phillips bit File Sen Interior Wall e 7 16 hole Caution Do not kink cables e a F a st ener Li st Insert hinges and lock bullets into horizontal bars of Align stand off on interior wall with lock body that is on the window guard as shown outer wall and with the cables that have been fed through the wall Pre drill both holes at this time using a 3 16 drill bit This will make is easier to install the second screw in step 8 l l l y l 9 Mount cable clamp stand off i f l I S Ab N Use only one lag screw B in Install aluminum covers with Phillips screws provided C Hold cables IL to stand off and mark with file mark cable shields approx 1 4 below stand off the top of the stand off at this lock bullets Same stud used by lock bodies N Approx 6 above floor Q
3. f Secure hinges with one IMPORTANT TO INSURE PROPER Way Screws A RELEASE OPERATION AN ACCURATE Y A E Raise pedal to highest position and hy VIEW INSTALLATION VIDEOS AT ALIGNMENT BETWEEN LOCK BODY AND i i LOCK BULLET MUST BE MADE tighten hex nut D on back of pedal helpmeinstallit com
Download Pdf Manuals
Related Search