Zanussi CHI 6029 Instruction Manual
Contents
1. be required by them 43239612. your own safety always switch off your cooker hood at the mains supply point and unplug the mains lead from the wall if fitted with a plug before opening and removing the grille assembly for maintenance or cleaning WORKTOP LIGHTING If a lamp fails to function at any time first check that it is fully screwed into the holder When changing the lamp an identical replacement must be fitted to ensure the safe working of the cooker hood Replacement lamps are specified 240Volts 40Watt clear globe shape with small Edison E14 screw thread cap CLEANING For your own safety and in the interests of hygiene your cooker hood needs to be kept clean A build up of grease or fat from cooking could cause a fire hazard Never use excessive amounts of water when cleaning particularly around the control panel area The metal casing and inlet grille should be cleaned at least once a month to keep it looking like new Wipe over the hood with a soft cloth wrung out in hot water and containing a mild household cleaner and dry with a soft cioth Always wear protective gloves when cleaning the hood NOTE Never use scouring pads or abrasive cleaners as they might scratch or damage the surface CHARCOAL FILTER The charcoal filter cannot be cleaned lt should be replaced at least once every three months or more frequently if the cooker hood is used for more than three hours a day To remove the charcoal filter open the metal inlet grille The
3. CANOPY COOKER HOOD CHI 6029 INSTRUCTION BOOKLET CONTENTS Warnings General Information Electrical Connection Installation 0 Operating Instructions Maintenance and Cleaning Do s and Don ts Zanussi Guarantee Peace of Mind for Twenty Four Months TECHNICAL SPECIFICATIONS DIMENSIONS Width Height Depth WEIGHT Gross Net ELECTRICAL CONNECTION Voltage 50Hz FAN LAMP CONSUMPTION Electricity DUE 20 0202 Sy xc MN E X UJ i an cm 52 cm 15 cm 28 4 kg 5 5 kg 5 9 240 V 115 W 40 W 155 W OO Y N O A A CQ N WARNINGS It is most important that this instruction book should be retained with the appliance for future reference Should the appliance be sold or trans ferred to another owner or should you move house and leave the appliance always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the func tioning of the appliance and the relevant warnings Please ensure that you have read the whole instruction book before using the appliance and that you follow the recommendations given These warnings are provided in the interest of sa fety You must read them carefully before installing or using the appliance B his appliance is designed to be operated by adults Children should not be allowed to tamper with the controls or play with the appliance m Any installation work must be undert
4. aken by a qua lified electrician or a competent person B t is dangerous to alter the specifications or modify the product in any way M This product should be serviced by a Zanussi Servi ce Centre and only genuine Zanussi spare parts must be used m l the steam is to be extracted through a ventilation system you must ensure that the ducting for the appliance is not connected to any existing ventilation system which is being used for any other purpose m Read the installation instructions carefully m Under no circumstances should you attempt to repair the appliance yourself Repairs carried out by an inexperienced person may cause injury and or serious malfunctioning Refer to your local Zanussi service Centre Always insist on genuine Zanussi spare parts GENERAL INFORMATION This cooker hood can be used to extract odours to the outside or recirculate the air within the kitchen after passing through a cleansing charcoal filter which is supplied as standard The hood is supplied specified for installation in the recirculation mode The hood can be converted to the extraction mode for ducting to the outside by removing the charcoal filter This hood is designed for use beneath a chimney housing or wall cabinet which should be constructed from fire retardant material If any doubt as to the suitability of the housing contact the manufacturer of the housing for specific instructions The housing should have a minimum d
5. domestic purposes only and in accordance with the manufac turers operating and maintenance instructions M The appliance has not been serviced maintained repaired taken apart or tampered with by any person not authorised by us B The appliance is still in the possession of the original purchaser All service work under this guarantee must be under taken by a Zanussi Service Centre Home visits are made between 8 30am and 5 30pm Monday to Friday Visits may be available outside these hours in which case a premium will be charged Any appliance or defective part replaced shall become the property of this company Exclusions This guarantee does not cover Damage or calls resulting from transportation im proper use or neglect the replacement of any light bulbs or removable parts of glass or plastic Costs incurred for calls to put right appliances improperly installed or calls to machines outside the United Kingdom Appliances found to be in use within a commercial environment plus those which are the subject of rental agreements Products of Zanussi manufacture which are NOT marketed by Zanussi Ltd EEC Countries The standard guarantee is applic able but is subject to the owner s responsibility and cost to ensure the appliance meets the standards set by the country to which the product is taken The Zanussi Company in the country concerned will be pleased to advise further Sight of your purchase receipt will
6. ed In the recirculation mode contaminated air enters the cooker hood and passes through the grease and charcoal filter and out into the kitchen through a recirculation grille in the housing When installed in the recirculation mode it will be necessary for the installer to fabricate a chimney from the ducting spigot on the top of the hood to a terminal in the chimney wall cabinet housing The ducting used must be 100mm 4ins and should be manufactured from fire retardant material conforming to the relevant British Standard or DIN 4102 B1 DUCTING FITTING The hood is supplied specified for installation in the recirculation mode with the charcoal filter fitted To convert the hood from recirculation to extraction open the metal inlet grille and remove the charcoal filter Remove the thumb screw through the centre of the charcoal filter from the motor support The charcoal filter can now be removed When installed in the extraction mode the charcoal filter is not required To fit the ducting spigot align the flat side on the spigot with the recesses in the top of the casing Insert and snap fix the spigot into the aperture on the top of the casing ensuring air tight connection The ducting used must be 100mm 4 diameter and where flexible ducting is fitted it should not be turned through very tight bends as this may impair the perfor mance of the cooker hood Maximum length of ducting including one 90 bend should be 3 m
7. epth of 29 cm 11 3 8ins excluding the cabinet door if fitted into a wall cabinet IMPORTANT When installed above an electric cooking appliance the minimum distance between the surface of the hob elements and the lower grille of tne cooker hood must be 65cm 25 1 2ins When installed above a gas cooking appliance the minimum distance between the surface of the pan supports and the grille of the cooker hood must be 70cm 27 1 2ins When installed above a cooking appliance with a high level grill the distance between the upper casing and the grille of the cooker hood must be 45cm 17 3 4ins WARNING When installed between adjoining wall cabinets the wall cabinets must not overhang the hob and the distance between the underside of the cabinets and the worktop must be 45cm 15 3 4ins WARNING The fan motor of this appliance incorpo rates a thermal cut out device which will operate if the hood is installed below the minimum heights recom mended above or if the motor becomes overheated If the cut out device is activated switch off the fan motor and allow the hood to cool The cut out device will reset itself when the fan motor has cooled sufficiently When used in the extraction mode the cooker hood must not be connected to a flue which is used for exhausting fumes from appliances supplied with energy other than electric such as central heating flue or water heating flue if the room where the hood is to be used contai
8. etres to be reduced by 1 metre for each addition 90 bend installed in the duct run OPERATING INSTRUCTIONS The cooker hood functions are controlled by three slide switches located centrally in the front edge of the metal grille panel The three slide switches control the worktop lighting and the fan speed Ensure the hood is plugged in or wired in and the power supply switched on WORKTOP LIGHTING The slide switch marked with the lamp symbol and numbered 0 1 controls the worktop lighting Position 0 indicates the light is switched off Position 1 indicates the light is switched on FAN The switch marked with the fan symbol and numbered 0 1 controls the power to the fan Position 0 indicates the fan is switched off Position 1 indicates the fan is switched on The switch marked 1 2 3 should be used in conjunction with the switched marked with the fan symbol to control the speed 1 Low 2 Normal and 3 Boost Position 1 Should be selected when simmering or when using one pan Position 2 Should be selected for normal coo king up to four pans Position 3 Should be selected when frying or cooking food with strong odour To obtain the best performance it is advisable to switch ON the cooker hood a few minutes before you start cooking and leave it running for approximately 15 minutes after finishing The cooker hood is more efficient when used in the ducting mode MAINTENANCE AND CLEANING WARNING For
9. grille will hinge open from the back Carefully remove the screw through the centre of the charcoal filter from the motor support while holding the filter securely The charcoal filter can now be removed Clean the inlet grille and motor support before replacing the charcoal filter GREASE FILTER The grease filter is fitted to absorb grease and dust during cooking to help keep the appliance clean inside METAL GREASE FILTER The grease filter should be cleaned once a month after normal usage It may be washed in hot water and mild detergent or liquid soap or it may be washed in a dishwasher It should not be bent Make sure the grease filter is dry before refitting To remove the grease filter open the metal inlet grille Carefully ease out the metal retaining wire clips to remove the grease filter Clean the metal grille and clips before replacing the grease filter Please ensure that the wire clips are handled with care and keep away from children as the wire clips have sharp points IMPORTANT There could be a possible fire hazard if the grease and charcoal filters are not replaced according to these instructions Replacement charcoal filters grease filters and light bulbs can be obtained from your local Zanussi Service Centre whose details can be found in the Customer Care Booklet DO S AND DON TS Do s Do take extra care when frying Do keep heating areas on your hob covered over with pots and pans when using the h
10. ns a fuel burning appliance such as a central heating boiler then its flue must be of the room sealed or balanced flue type If other types of flue or appliances are fitted ensure that there is an adequate supply of air to the room All installations must comply with the local authorities requirements for the discharge of exhaust air If the cooker hood is installed for use above a gas appliance then the provision for ventilation must be in accordance with the latest Gas Safety Installation amp Use Regulations and the relevant building regulations Details are contained in the following British Codes Of Practice BS 6172 BS 5440 and BS 6891 Current Edition This cooker hood has been designed for installation over an electric hotplate with a maximum input of 7kW or a gas hotplate with a maximum input of 10kW when fitted in accordance with the height recommended in this booklet ELECTRICAL CONNECTION WARNING THIS APPLIANCE MUST BE EARTHED The manufacturer declines any liability should this safety measure not be observed This cooker hood comes with a 3 core mains lead and should be connected to the electricity mains supply using either of the methods as follows A Permanently wired via a double pole switch which should have contacts with a minimum clearance of 3mm in both poles or B Connected by a 13Amp BS 1363 plug fitted with a 3Amp fuse BS 1362 ASTA Approved to a standard 13Amp household mains socket An
11. ob and cooker hood simultaneously Don ts Don t leave naked flames under the hood Don t leave frying pans unattended during use as over heated fats and oils may catch fire Don t do flambe cooking under this cooker hood Service details adhesive label When you return your guarantee card to Zanussi Ltd you will receive a Appliance Guarantee And Mainte nance Record together with an adhesive label con taining the telephone number of your local Zanussi Service Centre The label can be adhered to the machine or adjacent furniture Please note that proof of purchase is required for any in guarantee service calls The engineer will make a charge if the fault is not a mechanical or electrical breakdown PEACE OF MIND FOR TWENTY FOUR MONTHS Zanussi guarantee conditions This guarantee is in addition to your statutory and other legal rights which will not be excluded or in any way diminished by the return of this guarantee card We Zanussi Ltd undertake that if within twenty four months from the date of the purchase this ZANUSSI appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials the company will at its option repair or replace the same FREE OF ANY CHARGE for labour materials or carriage on condition that amp The appliance has been correctly installed and used only on the electricity supply stated on the rating plate W The appliance has been used for normal
12. rective No 82 499 on Radio Interference Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown INSTALLATION INSTRUCTIONS UNPACKING Care should be taken when unpacking to ensure that the fixing kit ducting spigot and literature pack are retained with the hood The fixing kit comprises 1 10 N 15mm round headed screws FITTING Before fitting the cooker hood beneath any canopy or wall cabinet housing ensure it is firmly fixed to the wall in accordance with the manufacturers instructions Measure the underside of the housing to mark the position for the cut out The cut out should measu re width 497mm 19 9 16ins by depth 261mm 10 5 16ins IMPORTANT Check the positioning of the hole is correct with the measurements above before making the cut out The hood is fixed using the holes located in the rim around the base of the casing visible when the inlet grille is in the open position Open the grille panel using the slide catches and the grille will hinge open Raise the cooker hood into the cut out and mark the position for the fixing screws Pilot drill the fixing holes and fit the cooker hood using the screws supplied Ensure that provision is made for the mains lead and ducting before the cooker hood is secured to the housing RECIRCULATION The hood is supplied specified for installation in the recirculation mode with the charcoal filter fitt
13. y permanent electrical installation must comply with the latest I E E Regulations and local electricity board regulations For your own safety this should be undertaken by a qualified electrician e g your local Electricity Board or a contractor who is on the roll of the National Inspection Council for Electrical Installation Contracting NICEIC INCORRECT INSTALLATION COULD AFFECT THE SAFETY OF THIS COOKER HOOD FITTING A 13AMP PLUG WARNING THIS APPLIANCE MUST BE EARTHED IMPORTANT The wires of this mains lead are coloured in accordance with the following code Green and Yellow Earth Blue Neutral Brown Live As the colours of the wires in the mains lead of this cooker hood may not correspond with the coloured markings identifying the terminals in your plug proceed as follows GREEN amp YELLOW 13 AMP FUSE CORD CLAMP The wire which is coloured Green and Yellow must be connected to the terminal in the plug marked with the letter E or with the earth symbol or coloured Green or Green and Yellow The wire which is coloured Blue must be connected to the terminal marked with the letter N or coloured Black The wire which is coloured Brown must be connected to the terminal which is marked with the letter L or coloured Red If a 13Amp plug is used fit a 3Amp fuse If any other type of plug is used protect with a 5Amp fuse in the plug adapter or at the main fuse box This appliance conforms to the EEC Di
Download Pdf Manuals
Related Search