Xantech Mouse 283M User's Manual
Contents
1. Consult the owner s manual of the unit or the manufacturer for the exact IR sensor window location e Double sided adhesive tape is included If you move the emitter to a different component use this tape to replace the current adhesive layer for best adhesion e The shell though dark in appearance is transparent to infrared light allowing commands from a handheld remote control to pass through it This permits direct control of the equipment from a handheld remote as well as from the 283M es XC Le 9 e m 3 ct ct 0 P 0 p 0 m 0 ct P Hn BLACK IR OPAQUE MOUSE SHIELD e An optional shield available from Xantech as model MS 1 fits over the 283M and the sensor window Fig 3 of the controlled component It prevents unwanted external IR signals from passing through or leaking past it e Use the MS 1 when you want the equipment to respond only to the 283M such as in zone controlled systems e Install it according to the instructions that come with the MS 1 CONNECTING THE EMITTERS Fig 3 MS 1 Mouse Emitter Shield Adhesive Layer Controlled Component 283M MS 1 and 283M installed Top View Side View Emitter over IR sensor window e Simply insert the mono mini plug of the 283M emitter into the EMITTERS or OUT jacks on any of the Xantech Connecting Blocks or Controllers e CAUTION DO NOT plug emitters into the IN OUT or HIGH OUT jacks on the 790 00 and 791 44 Connecting Blocks To do so wi2. Ses INSTALLATION INSTRUCTIONS e8 3M BLINK IR MOUSE EMITTER DESCRIPTION The 283M Blink IR Mouse Emitter contains a small Infrared LED housed in a miniature mouse shaped black appearing injection molded plastic shell Unlike other emitters the 283M emits visible red light in addition to IR infrared control signals when activated by IR commands sent to it by IR receivers or other Xantech controllers The 283M is designed to be installed directly on the IR sensor window of the controlled device Model 283M Blink IR Mouse Emitter Assembly Side View y NOTE White striped A 3 5mm mono side is positive 1 4 mini plug y Top View y 5 16 A lt 9 16 7 FT ee eee _ Fig 1 INSTALLATION ATTACHING THE EMITTERS TO IR SENSOR WINDOWS e Each emitter has a clear adhesive layer on the bottom flat surface of the shell The rounded side faces the user and emits visible red light when a command is sent Fig 2 e Simply peel off the adhesive cover and affix the emitter to the center of the IR sensor window on the controlled component s front panel ar gt IR amp Red da gt Light Output Output a made gt Component Side Emitter gt Clear adhesive Shell layer Replace if necessary Mini wi with a short piece of the Ini wire 2 sided tape supplied Fig 2 lad 7 pened e In some cases it may be difficult to find the location of the IR sensor on the component
3. ll destroy the emitters e Fig 4 illustrates a typical basic system using 283M emitters e The 283M visible mouse emitter will also indicate the presence of stray IR or RF interference by randomly blinking when no IR control signal is being sent Reposition the IR receiver or the interfering source to eliminate or reduce the random blinking The more the random blinking is reduced the better the system will function 2 Fig 4 781RG Satellite Receiver Power Suppl To 120 VAC Window unswitched 789 44 283M Enitter 20000 283M Emitter AV Receiver 283M Bliink IR Mouse Emitter EQUIPMENT CABINET CLOSET ETC 291 00 IR Receiver Hand Held Remote 5 18 00 A OCh a 223 M
Download Pdf Manuals
Related Search