Woodstock D3614 User's Manual
Contents
1. Model D3614 ZERO CLEARANCE TABLE SAW INSERT WARNINGS Disconnect the saw from the power source before fitting or removing the insert Always wear eye protection Ensure that the blade is NOT in contact with the insert before turning the saw ON Do not attempt to tilt the arbor while the blade is in the insert The blade will bind causing severe damage and possible injury For beveled cuts a separate dedicated insert must be prepared Pre set the angle and then proceed as instructed below e The insert must be covered by a board that is securely clamped down before plunging the blade up e If you are using blade stabilizers check the clearance before raising the blade INSTALLING AND FITTING YOUR INSERT 1 Lower the blade completely 2 Place the insert in the throat opening so the blade starter pocket is directly over the blade 3 Using a medium grit sanding block LIGHTLY sand all four fitting bumps Also lightly bevel the bottom edges of the FRONT bumps to ease entry Sand test and repeat to achieve a TIGHT WEDGE fit 4 Adjust the four leveling screws until the insert is flush with the table top 5 SPLITTER If the insert is to be used with a splitter you will need to finish cutting out the pre routed optional splitter slot using a saw or router then smooth over the sharp edges with fine sandpaper CUTTING THE BLADE SLOT KERF 1 Check that the insert is fitted properly and that there is clearance between the2. ONAL INC Printed in USA
3. blade and the insert Using a stick reach under the table and rotate the blade manually to check for blade clearance 2 Fully cover the insert with a board and clamp the board at each end to the table saw top 3 Re connect power to the saw Turn the saw ON then slowly and cautiously raise the blade up to cut through the insert KEEP HANDS OFF OF TABLE TOP STAY CLEAR AND WEAR EYE PROTECTION Raise the blade to the maximum height 4 Lower the blade turn the saw OFF and remove the board Your insert is now ready for use IMPORTANT TIPS FOR USE e Only recommended for use with carbide tipped cutters e DADO BLADE Use same procedures outlined above but use additional caution due to excessive mate rial being machined from the insert during the slotting procedure e Under certain conditions an undesirable scraping noise may be generated by your saw blade Planer type blades excessive arbor run out and or blade distortion may intermittently cause blade insert contact To remedy this remove the insert and slightly widen the slot using a file or sanding paddle e Ideally a separate insert should be used with each blade dado stack or angle set up This will ensure a true zero clearance effect and give you maximum benefit from your inserts COPYRIGHT JANUARY 2006 BY WOODSTOCK INTERNATIONAL INC WARNING NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT 7879TR THE WRITTEN APPROVAL OF WOODSTOCK INTERNATI
Download Pdf Manuals
Related Search