Woodstock D2258 User's Manual
Contents
1. INTERNATIONAL INC D2258 SHOP FLASH INSTALLATION INSTRUCTIONS The Woodstock Model D2258 Shop Flash is an extremely useful accessory for the home or shop providing the oppor tunity to have both a visual and an audio warning when there are incoming telephone calls First determine where you want to mount the Shop Flash unit It can either be mounted to a wall or laid flat on a table or bench top If you are planning to utilize the flashing light feature it will be most easily visible if it is wall mounted The unit should be within 15 feet of the telephone receiver to allow connection of the audio sensor You will also need access to a 110V outlet to plug in the power transformer The unit should be located at least 5 feet away from the nearest machine s If the machine is too close the ambient sound from the machine can override the audio sensor connected to the phone and cause the Shop Flash to activate when the machine starts If mounting to a wall use the template enclosed to mark the position for the two screws included Drill a starter hole 1 46 to 4 in the center of the circular portion of the two template marks Drive the screws in leaving about 14 of the threads extending out Hang the Shop Flash unit on the two screws using the slotted recesses in the back Next take the audio sensor and peel the adhesive backing off and attach the sensor to the side or underside of the phone The Shop Flash is not designed2. signed for interior use only and should not be used in wet or extremely humid conditions It can be cleaned with a damp cloth to remove dust or dirt The light in the Shop Flash is not user replaceable IF YOU NEED ASSISTANCE Should you have any question about this product or its use please contact the dealer where you purchased it or you can call the Woodstock International Technical Department at 1 800 840 8420 between the hours of 7 00 am to 5 00 pm PST 2000 Woodstock International Inc D2258 300 04 2000
3. to be used with cordless phones It may be necessary to experiment with the placement of the sensor on the phone until you find the point of maximum sensitivity to the internal ringer of the phone Make sure the phone s ringing volume is set to the maximum level if it has an adjustment Plug the other end of the audio sensor into the side of the Shop Flash unit marked Telephone Sensor Plug the adapter into the wall outlet and the other end into the opening with 12V next to it Set the switch on the front of the unit for either flashing light only bell only or both light and bell Turn the Shop Flash unit on with the other front mounted switch Test the unit by dialing the phone to which the unit is connected and make sure it is activated The volume of the bell on the wall unit can be adjusted with a thumbwheel on the bottom of the unit If the unit does not activate try relocating the placement of the audio sensor on the phone base and make sure the volume is set to the maximum level If being installed in a shop environment test again with several of the machines running to make sure the unit is still activated only by the phone and not by any ambient noise coming from those machines If ambi ent noise does cause activation it may be necessary to relocate the unit If it is placed too near a corner of the room or near a structure which allows sound to reverberate it can be activated by other sounds in the room This unit is de
Download Pdf Manuals
Related Search