Winegard RP-SK95 User's Manual
Contents
1. the plate O Using a 1 2 wrench loosen and remove the four bolts holding the reflector bracket and stiffener plate to the skew housing At the same time carefully remove the stiffener plate and LNB arm assembly Set aside the stiffener plate and four bolts you will need these later Reflector bracket Stiffener plate ee 7 E a Lo pal y Cable harness Bolts holding reflector bracket and stiffener plate to skew housing one not shown Installing the Replacement LNB Assembly Identify the fourth outer hole in the adapter plate The fourth hole marks the bottom of the adapter plate Adapter plate Numbered outer holes in adapter plate Note as the antenna raises and turns the adapter plate may become skewed and the fourth hole may not be directly at the bottom of the plate If unsure of the fourth hole remove the four screws from the center of the adapter plate a small post is located directly above the fourth hole Approximate location of post on back side of plate Installing the Replacement LNB Assembly 2 Position the reflector bracket of the replacement LNB assembly against the adapter plate Make sure the fourth outer hole in the adapter plate is centered in the bottom slot of the reflector bracket The third and fifth outer holes should be close to opposite edges of the bottom slot Bottom slot of the reflector bracket Stiffener plate Place the stiffener plate inside t2. a WINEGARD TRAV LER Automatic Multi Satellite TV Antenna Replacement Back up and Feed Arm Assembly with LNB and Coax Cable Instruction Manual for Model RP SK95 For help email helo winegard com or call 1 800 788 4417 www winegard com mobile 2452290 Raising the Antenna Press and hold POWER for two seconds to turn on the interface box Wait until the interface box finishes connecting to antenna The TRAV LER antenna may enter the search routine after ten seconds Pay attention to the pinch points as the antenna raises Wait until the antenna has at least raised to a position in which the LNB arm is parallel to the roof Then press POWER and SELECT at the same time The antenna should stop moving Unplug the interface box Removing the LNB Assembly Remove the four reflector nuts and bolts with a 2 wrench and remove the reflector Set the reflector reflector nuts and reflector bolts aside you will need these later Disconnect the coaxial cable from port C on the top of the turret Coax cable disconnected from port C of turret Using a 1e wrench remove the screw holding the p clamp to the lift arm and detach the p clamp from the lift arm Set the screw aside you will need this later Hole in lift arm for cable harness 4 If there is not already a line marking the top of the stiffener plate draw a line on the stiffener plate to mark the top of
3. he reflector bracket Make sure the second and third outer holes in the stiffener plate are centered in the bottom slot of the reflector bracket The second and third outer holes in the stiffener plate should additionally align with the third and fifth outer holes in the adapter plate Install bolts through the four outer holes in the stiffener plate and tighten O Connect the coaxial cable from the LNB assembly to port C of the turret QO Align the hole in the p clamp with the hole in the lift arm and make sure the hole in the p clamp is positioned above the cable Install the screw through the p clamp and lift arm and tighten 7 Install the reflector bolts through the four corresponding holes in the reflector and reflector bracket Install the reflector nuts and tighten Stowing the Antenna 1 Plug in the interface box 2 Press and hold POWER for two seconds to turn on the interface box Then press the Power button again to stow the antenna Winegard Company 3000 Kirkwood St Burlington IA 52601 2000 1 800 788 4417 FAX 319 754 0787 www winegard com Printed in U S A e 2013 Winegard Company 4 13 2452290 Winegard and TRAV LER are registered trademarks of Winegard Company
Download Pdf Manuals
Related Search