Home
        Vector VEC248 User's Manual
         Contents
1.   Lift off the Battery Pack and place it into position on the Canister Vac     Make sure it snaps into position     Operate the ON OFF rocker switch so it is in the  1  ON position       The Battery Status LEDs on the Canister Vac should indicate a full charge on the Battery  Pack  or relative voltage level of the DC adapter      6  Turn OFF  0  the Rocker Switch and move the Canister Vac to the work location   NOTE  If the DC adapter is used  install the DC adapter exactly as the battery pack is installed     O   BR    ND          REMOVING THE DIRT CONTAINER FOR CLEANING    e There are two lift latches that lock the dirt container to the upper motor assembly  The lift  latches must be carefully moved away from the dirt container to release the dirt container   It is easiest to release one lift latch at a time     CLEANING THE DIRT CONTAINER AND FILTERS          e Empty dry dirt container contents into a plastic bag for disposal   e Dirty water can be poured down a sink drain     e Clean with a wet cloth or with mild detergent and water only  Do not clean with paint  thinner or chemical solutions that might damage the unit     e Replace dirt container by snapping it back in place     FILTER CLEANING       The filters can be easily cleaned using water with a little dishwashing detergent  There is an  outer cloth filter supported by an inner foam filter     Cleaning should be done when the outer cloth filter becomes clogged with dust and dirt   Remove the motor assembly from th
2.   Plug the barrel connector into the barrel receptacle on the Battery Pack Recharge unit     3  Release the Battery Pack from the canister by simultaneously pressing the two Battery  Release Tabs   4  Place the Battery Pack onto the Battery Pack Charging unit  making sure the battery  locks  snaps  into position   The red LED should indicate the charge is sear When charging is complete  the green  LED will light  Disconnect the battery when it is fully charged   NOTE  It is normal for the AC DC adapter to get warm while operating     USING THE DC ADAPTER    The DC adapter is used when the vacuum is used in an RV  vehicle  or boat that has 12 volts  DC available from an accessory outlet  The 9 foot cord allows freedom of movement  Powering  the canister vac from a 12 volt accessory socket allows long run times without discharging the  canister s battery        The DC cord and the plug are all stored inside the battery shaped shell   The DC adapter may be connected to the battery pack charging unit for storage   This will protect the contacts so no dust  dirt or moisture will collect on the contacts          FIGURE 4   DC Adapter CORD STORAGE       9 FOOT LONG    CORD    BATTERY    RELEASE TAB    C PLUG TO  7 ACCESSORY OUTLET    HOW TO OPERATE       Make sure the Battery Pack is fully charged  The green LED should be lit on the charging unit              Disconnect the Battery Pack from the Battery Pack Charging unit by simultaneously  pressing the two Battery Release Tabs     
3. NS  This warranty does not cover accessories  bulbs  fuses and batteries  defects resulting from normal wear and  tear  including chips  scratches  abrasions  discoloration or fading due to usage or exposure to sunlight    accidents  damage during shipping to our service facility  alterations  unauthorized use or repair  neglect  misuse  abuse   failure to follow instructions for care and maintenance  fire  flood and Acts of God     If your problem is not covered by this warranty  call our Technical Support Department 954 584 4446 or toll free  866 584 5504 for general repair information and charges if applicable  You may also contact us through our website  www vectormfg com     STATE LAW RIGHTS  This warranty gives you specific legal rights  Some states do not allow limitations on how long  an implied warranty lasts or the exclusion or limitation of incidental or consequential damages  so the exclusions or  limitations stated herein may not apply  This warranty gives the purchaser specific legal rights  other rights  which vary from state  to state  may apply     TO REQUEST WARRANTY SERVICE FOR THIS PRODUCT  Contact Vector Manufacturing Technical Support by telephone   fax or mail  We suggest that you keep the original packaging in case you need to ship the unit  When returning a product   include your name  address  phone number  dated sales receipt  or copy  and a description of the reason for return and  product serial number  After repairing or replacing the unit  we wi
4. WECTO R  VEC248    WET DRY CANISTER  VACUUM CLEANER    CORDED   CORDLESS   RECHARGEABLE  1 GALLON CAPACITY  WASHABLE FILTERS  UPHOLSTERY BRUSH AND CREVICE TOOLS    OWNER   S MANUAL  amp  WARRANTY INFORMATION       THIS MANUAL CONTAINS IMPORTANT INFORMATION REGARDING SAFETY   OPERATION  MAINTENANCE AND STORAGE OF THIS PRODUCT  BEFORE USING   READ AND UNDERSTAND ALL CAUTIONS  WARNINGS  INSTRUCTIONS AND  PRODUCT LABELS  PLUS YOUR VEHICLE S BATTERY MANUFACTURER GUIDELINES   FAILURE TO DO SO COULD RESULT IN INJURY AND OR PROPERTY DAMAGE        4140 SW 28th Way  FT  LAUDERDALE  FL 33312  Tel 954 584 4446   TOLL FREE  866 584 5504    Fax 954 584 5556  www vectormfg com    IMPORTANT SAFETY INSTRUCTIONS         Do not use Canister Vac to pick up burning objects     Do not use in an area where dangerous items are stored     Do not apply lubricants to the motor       When you remove the battery  please make sure it s not placed near high heat or near  a risk of short circuit       Do not use to pick up flammable fluids     6  Do not use canister vac as a water pump  Although it s designed to pick up  minor water spills  it s NOT DESIGNED to replace or act as a sump pump or any other  pump designed to remove standing water     RON        nn    7  This is not a toy  please keep away from children   8  Do not allow Canister Vac to freeze or be submerged in water   NOTES   e The Canister Vac has a runtime of 15 minutes on a completely charged battery   e Do NOT run battery completely down  
5. aint thinner or chemical solutions    e Do not disassemble or reassemble the battery pack    e Always bring unit to a professional technician or shop for repair     e Skin or eye contact with a leaking battery  rinse the contacted area immediately with  water and consult a physician immediately  D     e Lead Acid Batteries contain substances that pollute the environment         PLEASE dispose of properly    oy  e To dispose of battery properly  refer to the local ordinances     RECYCLE  LEAD ACID   SPECIFICATIONS  Hegre 13 5   Wah 9 57  LENG  renier sui 2 date an adhd eabaven ave E 11   Weight with accessories                                        7 05 lbs   AC DC Adapter Output                              12 Volts DC 300 mA  le SN Cloth and foam  Battery Pack                           12 VDC  3 AH  sealed  non spillable  Hose length   jessssddsskeaaspaddet Hadad editions 3 0 Ft    DC Adapter Cord length                                         9 0 ft          1 YEAR LIMITED WARRANTY PROGRAM    This limited warranty program is the only one that applies to this product  and it sets forth all the responsibilities of Vector  Manufacturing  Lid   regarding this product  There is no other warranty  other than described herein     This Vector Manufacturing  Lid  product is warranted  to the original purchaser only  to be free of defects in materials  and workmanship for one year from the date of purchase without additional charge  The warranty does not extend to  subsequent purcha
6. e dirt container  Make sure the container is emptied of dirt   dust and any dirty liquid      Remove the rubber retaining ring by sliding it off the cloth filter   see Figure 5A    2  Remove the cloth filter    3  Carefully remove the foam part of the filter           Wash both the cloth and the foam filters and the retaining ring in detergent and water    see Figure 5B            Rinse in clear water and wash again in clean in water if necessary    Pat the cloth and foam filters with a large dry bath towel to remove most of the water   Allow several hours for the filter to dry if using for dry dust and dirt      Reassemble foam  cloth and retaining ring on the filter assembly           NO      Replace the top part of the unit on the canister     FIGURES 5A AND 5B   Filter assembled and disassembled       FOAM FILTER  RETAINING    RING    CLOTH FILTER      CLOTH FILTER  yi kl      LG NE  x   lt     RETAINING  RING              LEAD ACID BATTERY INFORMATION  Under normal conditions  and i following recharge recommendations  the Canister Vac  battery will give years of service  If the battery should ever need replacing  follow the Removal    and Handling Instructions  Replacement battery packs can be ordered from Vector  Manufacturing  Order Part Number VEC202     BATTERY PACK HANDLING PRECAUTIONS           e Do not place battery in high heat or in an area where high risk of short circuit or fire   e Do not short the terminals    e Do not clean or wipe the battery casing with p
7. ll make every effort to return it to you within four weeks     WARRANTY ACTIVATION  Please complete Warranty Activation Card and mail to Vector Manufacturing  Enter   VEC248  as Model and    Wet Dry canister vacuum 1 gallon capacity    as Product Type  All Vector Manufacturing  Ltd   products must be registered within 10 days of purchase to activate this warranty  Mail the completed registration card   along with a copy of the original sales receipt to     ATTN   CUSTOMER SERVICE   VECTOR MANUFACTURING  Ltd   4140 SW 28th Way  Ft  Lauderdale  FL 33312  PH  954 584 4446   TOLL FREE  866 584 5504   Fax  954 584 5556   You may also contact us at our web site www vectormfg com     WARRANTY IS NON TRANSFERABLE AND NON REFUNDABLE             2004 VECTOR MANUFACTURING  LTD   FT  LAUDERDALE  FL 33312   MADE IN CHINA  REV 051503    
8. re the area you choose to mount the Battery Pack Charging unit is free  from hidden electrical wires  water pipes and or gas lines            D    Select a place close to an indoor 120V   60Hz wall outlet   3  Do not locate in direct sunlight or close to any heat source      gt     Select a drill for the material and size of mounting screws   Be careful that no wires  water or gas pipes are behind the wall where the Battery  Charging unit is to be installed     on    Mark the wall where you want to mount the Battery Pack Charging unit     Os      After carefully drilling starter holes  install the screws so that the Battery Pack Charger  unit can hook onto the screw heads     NOTE  This Battery Pack Charging unit is designed for INDOOR MOUNTING ONLY     POWERING THE BATTERY PACK RECHARGE UNIT    Connect the AC DC Adapter into a working 120 VAC outlet     Plug the barrel connector into the receptacle on the Battery Pack Recharge unit  The unit may  be either continuously powered or disconnected after use     If desired  the tools may be placed in the tool wells for storage              BATTERY PACK RECHARGE    The battery pack should be charged for 24 hours before first use  Recharge the Battery Pack  after each use  Recharge every 30 days if not in use        The Battery Pack must be removed from the Canister Vac for recharging  The Battery Pack is  then snapped onto the powered Battery Pack Charging Unit     1  Make sure the AC DC Adapter is connected to a 120 VAC outlet   2
9. recharge after every use   e Fully recharge your Canister Vac at least once a month for optimum battery life     e For locations that have 12 volts DC available  remove the battery and use the DC  adapter to power the Canister Vac     FIGURES 1 AND 2   Front and Rear views of the Canister Vac    BATTERY  BATTERY PACK        12 VOLT 3 AH   RELEASE TAB    CAPACITY N                       BATTERY  STATUS LEDSN    I    ON OFF  ROCKER    SWITCH    HOSE      CONNECTION o     LIFT LATCH TO DETACH  ONE GALLON DIRT CONTAINER  CANISTER DIRT FOR CLEANING  CONTAINER    WARNING   TO AVOID ELECTRICAL SHOCK  DO NOT EXPOSE TO RAIN  STORE INDOORS  READ THE USER MANUAL AND SAFETY INSTRUCTIONS  BEFORE OPERATING THIS UNIT  TO AVOID INJURY OR PROPERTY DAMAGE  DO NOT PICK UP FLAMMABLE   COMBUSTIBLE  OR HOT MATERIALS  DO NOT USE AROUND EXPLOSIVE LIQUIDS OR VAPORS  AS  ELECTRICAL DEVICES PRODUCE ARCS OR SPARKS WHICH CAN CAUSE A FIRE OR EXPLOSION  DO NOT    USE AT FILLING STATIONS OR ANYWHERE GASOLINE IS STORED OR DISPENSED  TO AVOID HEALTH  HAZARDS FROM VAPORS OR DUST  DO NOT VACUUM TOXIC  CARCINOGENIC  OR OTHER HAZARDOUS  MATERIALS SUCH AS ASBESTOS  LEAD  PESTICIDES OR HEALTH ENDANGERING MATERIAL           FIGURE 3   Accessories            CREVICE TOOL    BATTERY PACK  BATTERY PACK  RECHARGE AND    TOOL STORAGE UNIT 5        3 FT LONG    VACUUM HOSE       BARREL    CONNECTOR       AC DC ADAPTER    Optional wall mounting instructions for battery pack charging unit  FOR INDOOR USE ONLY     le make su
10. sers or users  Vector Manufacturing  Ltd  will not be responsible for any amount of damage in excess of  the retail purchase price of the product under any circumstances  Incidental and consequential damages are specifically  excluded from coverage under this warranty     This product is not intended for commercial use  This warranty does not apply to accessories or damage to units from  misuse or incorrect installation  Misuse includes wiring or connecting to improper polarity power sources     RETURN REPAIR POLICY  Defective products  other than accessories  may be returned postage prepaid to Vector  Manufacturing  Any defective product  other than accessories  that is returned to Vector Manufacturing within  30 days of the date of purchase will be replaced free of charge  If such a product is returned more than 30 days but less  than one year from the purchase date  Vector Manufacturing will repair the unit or  at its option  replace it free of charge     If the unit is repaired  new or reconditioned replacement parts may be used  at Vector Manufacturing   s option   A unit may be replaced with a new or reconditioned unit of the same or comparable design  The repaired or replaced  unit will then be warranted under the terms of the remainder of the warranty period  The customer is responsible for the  shipping charges on all returned items after 30 days  During the warranty period  Vector Manufacturing  Ltd  will be  responsible for the return shipping charges     LIMITATIO
    
Download Pdf Manuals
 
 
    
Related Search
    
Related Contents
Télécharger la fiche produit au format PDF  Station solaire GTS 5 50  (D) Bedienungsanleitung  Intégrer une Grande Ecole d`Ingénieurs après une Prépa  User manual - CONRAD Produktinfo.  Catalogo Pronto Soccorso PVS  d-COLOR - Olivetti    Manual de instrucciones  Service Manual    Copyright © All rights reserved. 
   Failed to retrieve file