Triarch 75171 User's Manual
Contents
1. Center tube Bulbs not included Candle tubes Screws Wiring 1 Conpect the fixture ground wire to the outlet box ground wire using wirenut Connect outlet box ground wire to mounting plate with GREEN hex head ground screw to tapped hole in mounting strap marked GND as shown 2 Connect the half ofthe fixture wire that is white marked or has a ribbed surface to the outlet box supply wire WHITE Knurled Nut lees a Connect tne other hal ofthe fixture wire that is black unmarked or has a smooth surface to the outlet box Beck plate Y supply wire BLACK or RED Use wirenuts provided g Finial Main frame 3 Spread the electrical splices so that the black wires are on one side of the outlet box and the white wires are on the other side Outlet Box Dimples Ground Wwe NAS o Back plate re Coal Screw Back plate Z Top cap Tee _Joemner tube Fate fa tenter tube AETR Grounding Down Crouna wwe Q tats Poot incited not included deere ewes negornabed Candle tubes at Socket a cee Glass shade Q lane ate White Supply We Main frame Tek Damaniedor Smoon Main frase Etre wwe Knurled Nut Be Finiat finial d see Black or Red Supply Wire COPYRIGHT 20052. Assembly amp Installation Instructions CAUTION 1 TURN OFF THE ELECTRICTY AT THE FUSE BOK OR CIRCUIT BREAKER BEFORE INSTALLATION 2 RISK OF FIRE DO NOT LAMP FIXTURE GREATER THAN THE MAXINUN WATTAGE SHOWN ON THE WATTAGE LABELS ON THE FIXTURE 3 IF YOU ARE UNFAMILIER WITH ELECTRIC WIRING CONSULT A QUALITIED ELECTRICIAN TO INSTALL THIS FIXTURE FOR YOU FOR WALL BRACKET 1 Disconnect power at main electrical panel before instal lation 2 Thread the mounting screws into the opposite side of the Universal strip from the GREEN gound screw 3 Cuide fixture wires through hole in center of Universal strip 4 Attach Universal strip to outlet box using box screws provided with outlet box i Following wiring instruction careful ly listed below Mount fixture by aligning mounting holes in backplate with sounting screws and threading ball nuts onto mounting screws Tighten to firmly hold Back plate in place against wal mounting screws may require adjustment Open main frame bottom cap and glass shade or just thread out the threaded out see attached respective drawing install candle tubes onto sockets and install light bulbs not included See relamping label at candle tube for type and maximum allowed wattage then slip glass shade bottom cap and main frame up through bottom threaded pipe and secure all together by fastening with finial or just firaly secure glass shade with threaded Ara Top font Top cap
Download Pdf Manuals
Related Search