Transition Networks E-100BTX-FRL-01(SC) User's Manual
Contents
1. indicates portis receiving link signal RJ 452. MEDIA CONVERTER TECHNICAL SPECIHCATIONS Standards IEEE 802 3 Case dimensions 3 9 x 3 0 x 1 0 99mm x 76mm x 25mm Environment Temperature 0 40 C 32 to 104 F Humidity 10 90 non condensing Altitude 0 10 000 feet Warranty Five years Power Supply Requirements Replace power supply with only the equivalent input rating see below and output rating regulated 9VDC at 0 5 A TN PN Requirement Location 3517 240 volts 50 hertz United Kingdom 3516 230 volts 50 hertz Europe 3518 120 volts 60 hertz USA Canada M exico 3514 100 volts 50 60 hertz Japan 3515 240 volts 50 hertz Australia CAUTION RJ connectors are NOT INTENDED FOR CONNECTION TO THE PUBLIC TELEPHONE NETWORK Failure to observe this caution could result in damage to the public telephone network Der Anschluss dieses Ger tes an ein Gffentlickes Telekommunikationsnetz in den EG Mitgliedstaaten verst sst gegen die jeweligen einzelstaatlichen Gesetze zur Anwendung der Richtlinie 91 263 EWG zur Angleichung der Rechtsvorschriften der Mitgliedstaaten Uber Telekommunikationsendeinrichtungen einschliesslich der gegenseitigen Anerkennung ihrer Konformit t Compliance Information UL Listed C UL Listed Canada CISPR EN55022 Class A FCC Regulations This equipment has been tested and found to comply with the limits for a class A digital device pursuant to part 15 of the FCC rules These limits are designed to provide reasonable protection against harmful interfer
3. ence when the equipment is operated in a commercial environment This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual may cause harmful interference to radio communications Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at the user s own expense Canadian Regulations This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on the radio interference regulations of the Canadian Department of Communications European Regulations Warming This is a Class A product In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures Copyright Restrictions 1996 1997 TRANSITION Networks All rights reserved No part of this work may be reproduced or used in any form or by any means graphic electronic or mechanical without written permission from TRANSITION Networks Trademark Notice All registered trademarks and trademarks are the property of their respective owners 33009 C TRA NSTTION networks Minneapolis MN 55344 USA LOOBASE T 1LOOBASE FX Media Converters E 100BTX FRL O1 E LOOBTX FRL O1 SC E 100BTX FRL O1 SM USER S GUIDE The TRANSITION Networks Ethemet 100BASE TX to 10OBASE FX media conve
4. rters connect LOOBASE TX unshielded twisted pair cable to LOOBASE FX multimode or singlemode fiber optic cable Media converter models are selected according to the fiber mode and fiber connector required at the site Multimode fiber optic cable can use either an ST connector E 100BTX FRL O1 or an SC connector E 100BTX FRL O1 SC Singlemode fiber E LOOBTX FRL O1 SM uses only an SC connector All media converters function in half duplex mode or when connected to devices capable of full duplex connectivity in full duplex mode E 100BTX FRL O1 Provides an RJ 45 unshielded twisted pair 1OOBASE TX connector and a set of RX receive and TX transmit ST 100BASE FX connectors to multimode fiber optic cable E 100BTX FRL 01 E 100BTX FRL 01 SC Provides an RJ 45 unshielded twisted pair 100BASE TX connector and an RX receive and TX transmit SC 100BASE FX connector to multimode fiber optic cable E 100BTX FRL 01 SM Provides an RJ 45 unshielded twisted pair 100BASE TX connector and an RX receive and TX transmit SC 100BASE FX connector to singlemode fiber optic cable Singlemode Fiber Status LEDs on the connector side of the media Link converters provide the following information T o Pwr Power Illuminated green LED Pa ad a indicates connection to extemal s e 10BASE T A0BASE FL 1 AC power RX Receive Flashing green LED indicates port is receiving data Link Steady green LED
Download Pdf Manuals
Related Search