The Swan Corporation BS-1515 User's Manual
Contents
1. a gray label indicating the most desired placement Position a chisel on the desired dot and strike with a hammer to break out the hole Clean out fixture hole with a knife If hole is not used peel off the label Attach faucet drain and accessories according to man ufacturer s instructions APPLY CAULK 6 Apply a bead of caulk not included to the underside of the sink flange and position sink into counter top opening 7 Attach four 4 sink clips to underside of sink Sink clips provided will accommodate a counter top up to 1 1 2 thick Tighten screws in front then rear first Work from side to side Do not overtighten Clean up excess caulk 8 Connect all faucet supply lines disposal if available and drain trap fittings per manufacturer instructions CHECK FOR LEAKS e Supply user tubes to faucet e Supply riser tubes to shut off valves or lower connections e Fill sink with water and check for leaks around drain e Release water from sink and check for possible leaks e Tighten as needed CLEANING Clean your Swanstone sink as you would any other fine bath fixture using normal house hold detergents and cleansers Just wiping the wall surfaces quickly removes watermarks and residues Occasional scrubbing with household abrasive cleansers ensures that the original maintained luster is REPAIRING SOLID COLORS Use 400 grit sandpaper to remove scratches and gouges in the surf2. TOOLS REQUIRED e Ruler e Drill e Caulk e Saber Saw if counter top cutout is required SWANSTONE Your Strongest Choice TRACE COMPLETELY AROUND EDGE OF SINK 1 If it is necessary to cut out the counter top invert sink and position onto the counter top Locate sink front to rear and so that the bowl will not interfere with the cabinets below Trace a pencil line around the outside edge of the sink and remove the sink from the counter top DRAW A 1 1 2 RADIUS AT EACH CORNER 2 Measure in 5 16 from the initial sink outline and draw a second line inside the first Draw a 1 1 2 radius at each corner This second interior line will be your cutout line Check Cutout Line Measurements Model Width Depth BS 1515 14 3 8 14 3 8 BS 2515 24 3 8 14 3 8 Measure the cutout or the pre cut opening to be sure it conforms to the sizes listed BAR SINKS DRILL STARTER HOLE INSIDE OF jf JEE 3 Drill starter hole inside of cutout line CUT INSIDE OF LINE 4 Using a saber saw cut inside of cutout line Trial fit sink to check proper fit OWNER S MANUAL MODEL NOS BS 1515 BS 2515 Installation Care and Cleaning CAUTION Read ALL instructions carefully BEFORE starting your installation Save this manual for future reference WARRANTY SWANSTONE Your Strongest Choice BAR SINKS 5 Fixture hole locations are identified with
3. ace A scotchbright pad can be used to blend in the area AGGREGATE amp GALAXY COLORS Use 400 grit sandpaper to remove scratches and gouges in the surface To blend in the area use a fine grade white automotive polishing com pound or paste wax SWAN wal The Swan Corporation One City Centre St Louis MO 63101 314 231 8148 Patent Pending Form 256 11 91 10M
Download Pdf Manuals
Related Search