Tekkeon myPower MP3300 User's Manual
Contents
1. 3 Connect the adapter plug to the power output cord but not the device according to the device polarity e If the device polarity is center positive match the positive symbol on the selected adapter plug to N Connecting the Plug for a the positive symbol on the power output cord Center Positive Device and connect 2 e If the device polarity is center negative match gt the positive symbol on the selected adapter p Connecting the Plug for a Center Negative Device plug to negative symbol on the output cable and connect If the polarity is not shown you can assume that it is center positive as with most devices in North America If you change the adapter plug while the power adapter cord is connected to myPower ALL the voltage setting will reset to 3V the default voltage setting Connect the Power Output Cord 1 Plug the large end of the power output cord into the DC OUT jack on the end of myPower ALL The 3V voltage indicator will turn on to indicate that the voltage is set to the lowest setting If you have previously selected a voltage the voltage selection will be returned to the lowest setting 3V Adjust the Voltage Level 1 Locate the voltage specification for your portable device This can be found on the device power adapter label or device specification label which typically is found on the bottom of the unit If available use the voltage specification shown o2. finished unplug the power output cord from myPower ALL and your device NOTE If your portable device displays a low voltage low capacity or double beep warning while myPower ALL is connected adjust the voltage setting to one level higher TIP For most portable devices myPower ALL can be used to power the device even when the device battery is not installed USER GUIDE 1 View myPower ALL Battery Capacity The capacity in myPower ALL will decrease as the battery powers and or charges your devices The remaining voltage is shown on the voltage indicator which is accessed as described below As the voltage decreases the lights will turn off in sequence from right to left When the myPower ALL battery capacity is low only the red EMPTY light will be on You should recharge myPower ALL at this time When myPower ALL is completely out of battery all lights will be off At this point you must charge myPower ALL 1 With the voltage lock in the locked position LOCK and the adapter plug power output cord or the power adapter connected press and hold the voltage selector When you release the voltage selector the battery capacity indicators will turn off and one indicator will turn on to indicate the voltage selection Recording Device Information CAPACITY INDICATOR 1 5 Recharge before using Red Indicator 1st Green Indicator 5 15 2nd Green Indicator 15 25 3rd Green Indicator 25 40 4th Gr
3. the maximum provided by myPower ALL the device will shut down when turned on and cannot be powered and or charged by myPower ALL If the device requires a charging voltage greater than 14V verify that the total output power provided by the device power adapter is not more than 64W To do this multiply the voltage by the amps shown on the power adapter Watt Voltage x Amps If the output power is greater than 64W myPower ALL MP3300 will not power or charge the device myPower ALL the portable device and that the adapter plug fits snugly into the power jack on your portable device If not try another adapter Center Positive Connection the adapter plug In most cases the polarity is center positive In this case you must match the positive symbol on the selected adapter plug to the positive symbol on the power output cord as shown on the top right and connect If the polarity is center negative disconnect the adapter plug from the output cord and reconnect the plug in the opposite direction as shown on the bottom right i Check that the output voltage for your portable device matches or is just below the output voltage set on myPower ALL Ifthe output voltage is not correct unlock the voltage lock if in the locked position and change the voltage as required my Power 10 all 7 Verify that a battery is installed in the portable device as some devices will not function without a bat
4. Tekkeon a Universal Rechargeable Battery di User Guide my Power USER GUIDE Contents OVERVIEW 2 Getting started er erraten 2 Unpacking myPower ALL usa 2 Getting to Know myPower ALL 3 Charging MyPower All aus 3 Using myPower ALL anne lan 4 Select Connect the Adapter Plug anneer enene eneen 4 Connect the Power Output Cord eneen enen ennen 5 Adjust the Voltage Level nanne ennn sernesenneseeneseene seen 5 Connect the Portable Device 7 View myPower ALL Battery Capacity 8 Recording Device Information nnen enen ennen eenen eenen 8 Obtaining Adapters censor sereen eden arena 9 TOUDIESNOOU NG raven nrden treten 10 Limited Warranty nnee en ae 11 Customer Support uvas 12 Overview You can use myPower ALL the universal rechargeable battery to power just about any portable device Simply connect myPower ALL to your portable DVD player notebook computer digital camera digital camcorder portable CD player PDA mobile phone or other portable device to extend the battery life As an added bonus myPower ALL will charge the internal battery on some devices while powering the device myPower ALL goes where you go Slip the handy leather case onto your belt or just toss myPower ALL into your briefcase or backpack it s tha
5. een Indicator 40 55 5th Green Indicator 55 70 6th Green Indicator 70 85 7th Green Indicator The Device At A Glance Card included with myPower ALL enables you to record the information you need to use myPower ALL with each of your portable devices Simply record the device name required voltage and reference letter for the compatible adapter Store the card in the pocket provided inside the leather case 85 100 my ower Obtaining Adapters Eight adapter plugs that fit most DC adapter jacks on a variety of portable devices are included with myPower ALL If none of these plugs fits snugly into your portable device power jack please go to our web site at www tekkeon com mpadapters to determine which adapter plug you need for your device You can obtain most adapters through the web site or by contacting Tekkeon by phone at 888 787 5888 or 1 714 832 1266 If available through Tekkeon the adapter will be sent to you for a nominal fee USER GUIDE 9 Troubleshooting If myPower ALL does not power the portable device or charge the device battery take these steps 1 View the remaining battery capacity If it is below 25 recharge Check that the output cord is connected to both myPower ALL and Verify that the polarity of the portable device s power jack matches Verify that the current consumption of the portable device is not more than 4Amp Ifthe device consumes more than
6. l the battery capacity indicates FULL 5 When the battery capacity indicates FULL unplug the power adapter NOTE myPower ALL will automatically shut down the power input when fully charged so you can charge it overnight USER GUIDE 3 Using myPower ALL myPower ALL can be used to power and or charge your portable device With devices that require higher voltage levels like notebook computers and portable DVD players we recommend that you use myPower ALL only to power the device You will find that powering without charging your higher voltage device will maximize the battery life of myPower ALL thus letting you use your portable device even longer To use myPower ALL to power and or charge your device take these steps which are described in detail in the following sections e Select an adapter plug and connect the plug to the output cord Connect the power output cord to myPower ALL e Adjust the voltage level to match that of your device and lock the voltage setting Connect the adapter plug output cord to your device Select Connect the Adapter Plug 1 Select the adapter plug that fits securely into the power jack on your portable device 2 Locate the polarity symbol on your device in the area around the power connector jack o DEI Center Positive Center Negative The polarity of your device determines how you will connect the power output cord to the adapter plug to connect to your device my Power 4 all
7. n the power adapter Sample Power Adapter Label USER GUIDE 9 2 With the voltage lock in the unlocked position switched right to VOLTAGE set the voltage output to the voltage selection that is equal to or one increment higher than the voltage identified for your device To do this press the voltage selector until the voltage indicator turns on under the appropriate voltage selection 3 4 5 5 oe nn 6 7 5 9 12 14V For example if your device requires 6V set the Br voltage to 6 If your device requires 7 2V set the voltage to 7 5 It is important to set the voltage selector NO MORE than one step higher than the voltage requirement for the portable device as an incorrect setting may prevent myPower ALL from working with your device or may harm your device in the rare instance that the device accepts the higher voltage However for all devices adjusting the voltage ONLY one step higher than required will not harm the device 3 Slide the voltage lock to the locked position switched left to LOCK This will prevent you from accidentally selecting a different voltage while your device is connected 4 To change the voltage slide the voltage lock to the unlocked position VOLTAGE and select a new voltage Be sure to relock the voltage TIP You can optimize the use of myPower ALL with your notebook computer or portable DVD player by setting the voltage on myPower ALL to less than the required voltage This prevents myP
8. ower ALL from charging the device thus extending the amount of time you can use myPower ALL to power your notebook or portable DVD player Most notebook computers require a charging voltage of 11 1 volts or 14 8 volts Even though myPower ALL MP3300 provides only up to 14V it may be used to power these notebooks To determine if MP3300 can power your notebook verify that the total output power provided by the device power adapter is not more than 64W To do this multiply the voltage by the amps shown on the power adapter Watt Voltage x Amps If the output power is greater than 64W myPower ALL will not power or charge my Power 6 all the device If it is less than 64W set the voltage on MP3300 to 12V and test to see if it will power your notebook at this setting If not increase the voltage to 14V and retest Most portable DVD players require 9 or 12 volts Set the voltage to 7 5V and test to see if myPower ALL will power your device at this setting If not increase the voltage by one level and retest Connect the Portable Device 1 Connect the adapter plug into the power jack on the portable device 2 Turn on the portable device and use it as you would normally While connected myPower ALL will power and charge your device As mentioned earlier myPower ALL will not charge a device if the voltage setting is lower than that required or Leave the portable device turned off and myPower ALL will charge the device battery 3 When
9. t lightweight Getting Started Unpacking myPowerALL Your myPower ALL package includes the following 1 myPower ALL lithium polymer rechargeable battery Leather travel case with belt loop Power adapter Power output cord 2 Adapter plug kit with drawstring bag 8 adapter tips Device At A Glance Card 7 User guide not shown 3 Gi 4 2 3 4 5 my ower Getting to Know myPower ALL Voltage Indicators Capacity Indicators Voltage Selector Voltage Lock Charging Indicator DC OUT For connection to device DC IN For connection to power adapter Charging myPower ALL myPower ALL will charge in four hours when completely empty The green CHARGE indicator will turn on after the battery is 80 charged Therefore you should view the actual battery capacity before disconnecting the power adapter to stop charging Before using myPower ALL for the first time you must charge the device for four hours 1 Plug the power adapter into the DG IN jack on the end of myPower ALL 2 Remove the output cord from the DG OUT jack if connected 3 Plug the power adapter into a wall outlet The red CHARGE indicator will turn on to indicate the battery is charging and is less than 80 charged 4 When the green CHARGE indicator turns on set the voltage lock to LOCK and press the voltage selector to view the battery capacity If the capacity does not indicate FULL continue to charge the battery unti
10. tery installed 8 Verify if your device is designed with charging circuitry that limits the input voltage If so myPower ALL may not be able to power or charge the device Limited Warranty The product enclosed herein is warranted to be free of operational defects for a period of one year from the date of purchase In the event of a defect in operation during the warranty period Tekkeon Inc will replace the defective product when the owner returns all product contents The limited warranty will be considered void if the unit is tampered with subject to misuse negligence or accidental damage has been improperly serviced or if the security seal is removed This warranty is limited to replacement only and shall not cover any other damages Any product returned to Tekkeon Inc with no fault found will be returned to the owner at the owner s expense To obtain warranty coverage please complete and submit the enclosed registration card Disclaimer of Warranties Any user of this product does so at the users own risk To the maximum extent permitted by applicable law Tekkeon Inc and its suppliers provide the hardware and any support services related thereto as is and with all faults and hereby disclaim all warranties and conditions whether express implied or statutory including but not limited to implied warranties of merchantability fitness for a particular purpose non infringement lack of negligence or correspondence to description e
11. xcept for those warranties specifically and expressly provided in the Limited Warranty With respect to the use of this product in no event shall the company be liable for any loss of profit or any other commercial damage including but not limited to special incidental consequential and other damages USER GUIDE 11 Customer Support Customer support for myPower ALL is available at Tekkeon Inc c o myPower 3002 Dow Avenue 134 Tustin CA 92780 888 787 5888 714 832 1266 www tekkeon com Tekkeon Inc must issue a Return Merchandise Authorization RMA number for all exchanges or refunds www tekkeon com my Power 12 Tekkeon www tekkeon com 2005 Tekkeon Inc Revision A2 All Rights Reserved myPower is a trademark of Tekkeon Inc
Download Pdf Manuals
Related Search