Home
Sony PCG-K13 Replacement Instructions
Contents
1. SONY PCG K Senes CD DVD Drive A Replacement Instruc tons IMPORTANT PLEASE READ BEFORE YOU START These easy instructions are intended to guide you through the replacement process v To avoid electnc shock please make sure product is tumed off and AC Adaptor is disconnected from the power source Remove jewelry before you begin work to avoid scratching the surface of your notebook computer v Place your notebook computer on a clean stable and covered surface to avoid damage to the Computer s case v Follow the ESD Electrostatic Discharge damage prevention instructions o Hold partsby the edges away from exposed circuitry when possible o Do not walk around excessively asthis promotes static build up v The appearance of the electronic components shown in the illustrations may be different from the components shipped This slight difference doesnot affect the accuracy of these instructions Sony Is not responsible for any loss of data associated with your computer or any damage caused by incorrect handling of the computer under these procedures The terms of your Sony Limited Warranty continue to apply Step 1 Power on the PC Step 2 Close the screen Place your Step 3 CAUTION A eject the CD DVD drive tray computer upside down on a protected surface Disconnect the power cord and b
2. ful not to La N me ails are phe drop screws into the inside of petal eturn the old the unit and be careful to use CD DVD drive to Sony the correct screws as shown ai following the included in the picture Do not over shipping instructions tighten the screws P N T99860099 Rev D 2 2
3. y pressing the button on the with the back edge facing toward you remove the battery Failure to drive door Next properly turn do so can result in damage to off the PC leaving the tray the PC ejected P N T99860099 Rev D 1 2 PC G K Senes CD DVD Drive Replacement Instruc tons Step 5 Using the enclosed magnetic screwdriver remove the three 3 screws as indicated in the picture CAUTION Be careful not to drop screws into the unit Step 4 Using the enclosed magnetic screwdriver remove the marked screw and door as shown and set them TEES YO A UUT iS E Faceplate should be flat with edge of PC Step 7 Gently insert the new CD DVD drive into the unit as shown in the picture Push both sides of the drive faceplate with have been removed Slide open the CD DVD drive by grasping equal force toward the PC When done properly the drive the tray at both sides as shown above and slowly pull the drive faceplate should be flat with the PC and the screw holes should be away from the PC NOTE Some force may be required to aligned with the screw openings initiate the removal of the CD DVD tray Step 6 Rotate the PC The CD DVD drive should be facing you IMPORTANT Ensure that all three 3 screws from step 5 Step 8 Using the enclosed Step 9 Using the magnetic screwdriver reinstall enclosed magnetic the sled 3 previously screwdriver reinstall removed screws E m boe CAUTION Be care
Download Pdf Manuals
Related Search
Related Contents
DELL XPS 1820 RMS com Termômetro IV Gebrauchsanweisung - DT 1Instalación de las estructuras KOMPAN 2 Herramientas Copyright © All rights reserved.
Failed to retrieve file