Smeg CV35XS5 Instructions for Use
Contents
1. cabinet Be careful not to heat the strip so much that it melts Setting up It is important that the appliance be Do not tilt the upright more than 7 degrees absolutely level To level the appliance to avoid damaging the floor remove the kick plate below the door and screw the adjustable feet up or down figs 8 and 9 If necessary it is possible to adjust the rear feet before the upright is installed Use a spirit level to check that the appliance is absolutely level If the appliance is to be placed on a soft surface e g floorboards or a carpet it is best to recheck whether the appliance is still level after a period of time as the underlying surface may give under the weight of the appliance lt 7 fig 11 Electrical connection The appliance is intended for connection to alternating current The required volt age V and frequency Hz are stated on the nameplate inside the appliance Power must be connected via an independent wall socket outlet Technical data This appliance complies with CE marking regulations directives and standards Low Voltage Directive 73 23 EEC EMC Directive 89 336 EEC Council Directive 92 75 EEC on the en ergy labelling of household appliances as subsequently amended by 94 2 EC and 2003 66 EC Directive 96 57 EC on energy efficiency requirements and subsequent amendments Operation and function Thermometer Control lam2. ensure that the appli ance has not been damaged during trans port Transport damage should be reported to the local distributor before the appliance is put to use Remove the packaging Clean the inside of the cabinet using warm water with a mild detergent Rinse with clean water and dry thoroughly see cleaning instructions Use a soft cloth If during transport the appliance has been laid down or if it has been stored in cold surroundings colder than 5 C it must be allowed to stabilise in an upright position for at least an hour before being switched on Contents Get to know your freezer 3 Installation and start up 4 Reversing the door s c eeee 7 Electrical connection 8 Operation and function 9 A 10 Detrosting oia 11 Cleaning and maintenance 12 Fault TIMING ico ii 13 Spare parts and ServiCe 14 Disposal namsa 15 Get to know your freezer Control panel Lighting Freezing tray Freezer shelf Nameplate Sealing strip Freezer drawers Door handle Defrost water drain Kick plate Adjustable feet fig 1 Installation and start up Placement For safety and operational reasons the appliance must not be installed outdoors The appliance should be placed on a level surface in a dry well ventilated room max 75 relative air humidity Never place the appliance close to sources of heat such as cookers or radiato
3. ctronic equipment Disposal must be carried out in accordance with local environmental regulations for waste disposal For more detailed information about treatment recovery and recycling of this product please contact your local city office your household waste disposal service or the shop where you purchased the product 15
4. e322 SME UK Instructions for use DE Bedienungsanleitung FR Mode d emploi NL Gebruiksaanwijzing ES Instrucciones para el uso Thank you for purchasing your new freezer from Smeg Please note that these instruc tions apply to all freezers in the SW range Illustrations and fittings may therefore not necessarily correspond exactly to your model Warning As the refrigerant used in this appliance is a flammable gas Isobutane R600a special care must be taken to prevent damage to the refrigerant circuit and piping during transport and installation If damage does occur avoid sparks or naked flame in the vicinity of the appliance ensure that the room is well ventilated disconnect the power supply and contact your supplier The unit must only be serviced by quali fied technicians from an approved service centre Old appliances Old refrigerators and freezers are often fitted with complicated latches that can only be opened from the outside If you have one of these old units stored away somewhere or if you scrap one remember to destroy the latch first in order to prevent children from being exposed to great dan ger by getting locked inside the unit Before use Before operating your new appliance please read the following instructions care fully as they contain important information on safety installation operation and main tenance Keep the instructions for future reference On receipt check to
5. freezing and storing frozen items of food With the exception of no frost models the freezer is equipped with a practical tray for freezing loose berries ice cubes etc Freezing To keep food at its best items must be frozen to 18 C as quickly as possible When the Super Freeze button is pressed the compressor runs continuously thus reducing the temperature as far as possible If items weighing 3 kg or more are to be frozen the Super Freeze button should be activated about 24 hours in advance There is no need to use Super Freeze when pre frozen items are placed in the freezer or when small single items are involved The control lamp lights yellow as long as the Super Freeze function is active Remember to switch the Super Freeze function off again approx 24 hours after placing items in the freezer Otherwise the appliance will use more electricity than necessary Only freeze fresh high quality products Meat poultry fish vegetables fruit dairy products and ready made meals are suitable for freezing Items with a high water content e g lettuce radishes grapes apples pears and cucumbers are not suitable for freezing Pack items to be frozen in airtight containers freezer bags or similar Freeze items in suitable portions Do not freeze vegetables in portions larger than 2 5 kg Do not freeze meat in portions larger than 2 5 kg Keep packages dry to prevent them 10 from freezing together To ensure
6. iance The nameplate contains various technical information including type and serial numbers Important Please note that changes to the construction of the appliance or changes to the component equipment of the appliance will invalidate Smegs warranty and product liability and the appliance cannot be used lawfully The approval stated on Smegs rating plate will also be invalidated XXXXXXXX Model XXXX Serial nr XXXXXXXXX Basic Type No XXXX C fig 13 Note Always use approved service centres when your appliance is to be repaired or replaced 14 Disposal Environmental regulations on disposal must also be observed When disposing of the appliance you should contact your local authority technical department who will inform you of how collection and recycling of such units take place in your area This appliance is marked according to the European directive 2002 96 EC on Waste Electrical and Electronic Equipment WEEE By ensuring this product is disposed of correctly you will help prevent potential negative consequences for the environment and human health which could otherwise be caused by inappropriate waste handling of this product The symbol mmm on the product or on the documents accompanying the product indicates that this appliance may not be treated as household waste Instead it shall be handed over to the applicable collection point for the recycling of electrical and ele
7. of more than 12 W must not be used Save energy Cool hot food and beverages before placing them in the appliance Thaw frozen items in a refrigerator Keep the door s closed as much as possible Ensure that the door s is are not prevented from closing tightly 12 Fault finding E Fault Possible cause Remedy The control lamp is not lit Power failure the fuse is blown the appliance is not plugged in correctly Check that power is connected Reset the fuse Vibration or bothersome noise The appliance is not level The appliance is resting against other kitchen elements Level the appliance using a spirit level Move the appliance away from the kitchen elements or appli ances it is in contact with Compressor runs continuously Temperature setting too low High room temperature Raise the temperature setting Ensure adequate ventilation Temperature in freezer too high Temperature setting too high The quantity of fresh items placed in the freezer at a time is greater than the capacity of the appliance Lower the temperature setting Wait a few hours and then re check the temperature 13 e Spare parts and service Spare parts When ordering spare parts please state the type serial and production numbers of your appliance see fig 1 on page 3 and fig 13 This information is given on the nameplate on the rear of the appl
8. p 7 q IS S Super freeze O Alarm off super freeze off A Acoustic alarm Always maintain correct storage temperature The thermostat button can be set from 1 min to 7 max A temperature of 18 C is recommended for items stored in a freezer Maintaining a temperature lower than this consumes additional energy The temperature in the freezer is displayed on the thermometer The control lamp lights green when the power supply is connected correctly The control lamp lights yellow when Super Freeze is activated The indicator lamp lights red and the acoustic alarm sounds if the temperature in the freezer is too high To switch off the acoustic alarm set the freeze button to O see fig 10 The indicator lamp continues to light red as long as the temperature in the freezer remains too high When starting the freezer for the first time switch off the acoustic alarm by setting the freeze button to O Once the recommended temperature 18 C has been achieved in the freezer set the freeze button to the a This will allow the acoustic alarm to sound if the temperature in the freezer becomes too high Lighting It is quite normal that the indicator lamp lights red when the freezer is started for the first time It will also occasionally light red when large quantities of fresh material are put in the freezer simultaneously Use Freezer The appliance is a four star freezer approved for
9. rapid freezing make sure as far as possible that items placed in the freezer are not touching Ensure that there is as little air in the packages as possible to prevent the surfaces of the items from drying out Always remember to write the date content and quantity on the packages before placing them in the appliance It is a good idea to group items within the freezer Keep vegetables in one drawer meat in another and so on Thawing Frozen vegetables and fruit require no thawing before use and can be immersed in boiling water direct from the freezer To thaw meat it is advisable to take it out of the freezer the day before it is to be used and place it in a refrigerator to defrost This ensures the best hygiene and maintains meat quality as much as possible Refreezing If purchased items of frozen food thaw before reaching home they must not be refrozen but should be consumed within 24 hours or cooked immediately and then frozen Frozen items that have been placed in a refrigerator for thawing may be refrozen without risk if they have only just thawed Note Glass bottles or cans containing carbonated fizzy drinks must never be placed in the freezer as they may explode Defrosting Defrosting the freezer The items stored and the humidity of the air gradually cause frost and ice to form in the freezer A thin layer of frost or ice does not affect freezer performance but the thicker the layer the higher
10. returned to the freezer activate the Super Freeze button Remember to switch Super Freeze off again 8 Return items to the freezer approx 5 minutes after having switched it on Cleaning and maintenance Cleaning Disconnect the power supply at the mains socket before cleaning the inside of the cabinet The cabinet is best cleaned using warm water max 65 C with a little mild detergent Never use cleaning agents that scour Use a soft cloth Rinse with clean water and dry thoroughly It is important to prevent water from entering the control panel The sealing strip around the door must be cleaned regularly to prevent discolouration and prolong service life Use clean water After cleaning the sealing strip check that it continues to provide a tight seal Dust collecting on the compressor and in the compressor compartment is best removed using a vacuum cleaner It is possible to clean beneath the appliance by removing the kick plate Stainless steel or aluminium doors are best cleaned using a care spray and soft cloth Various suitable products are available from most household appliance distributors If the appliance is not to be used for any length of time switch it off empty it clean the cabinet and fittings and leave the door s slightly open to allow air circulation and prevent smells Replacing the light bulb fig 12 Unscrew the bulb without removing the shade Bulbs with an output
11. rs and avoid placing it in direct sunlight Room temperature The climate class is stated on the nameplate see fig 1 on page 3 and fig 13 on page 14 This specifies the optimum room temperature 600 600 fig 2 Climate class Optimum room tem perature SN 10 C to 32 C N 16 C to 32 C ST 18 C to 38 C T 18 C to 43 C Installation The surface on which the appliance is to be placed must be level Do not use a frame or similar The appliance can be installed as a free standing unit against a wall built into a kitchen element or lined up with other ap pliances figs 2 3 After installation the plug should be accessible fig 3 The appliance viewed from above If the appliance is placed beside a wall there must be sufficient room for its door to be opened wide enough to allow the drawers to be pulled out fig 4 Distance pieces The distance pieces on the rear of the appliance ensure sufficient air circulation Fit the two distance pieces supplied with the appliance as shown in fig 5 NY Tir ral aN a N fig 5 Ventilation It is important that the appliance be well ventilated and that air can circulate unhindered above below and around it The figures below illustrate how the necessary air circulation can be ens
12. the energy consumption Loose frost can be removed using a plastic or wooden scraper Never use a knife or other sharp implement that might damage the inside of the freezer When the layer of frost and ice exceeds 4 5 mm the freezer should be completely defrosted Proceed as follows 1 Press the Super Freeze button 4 5 hours before defrosting This lowers the temperature of the items stored to approx 25 C thus prolonging the length of time they remain frozen after having been removed from the freezer see step 4 below 2 Switch the freezer off by turning the thermostat button to 0 min 3 Pull out the drain spout at the bottom of the cabinet and place a bowl under it to collect defrost water fig 11 If the spout is frozen in place lay a cloth which has been soaked in hot water over it for a few minutes 4 Remove the items of food Place them in a refrigerator or wrap them in newspaper to keep them as cold as possible 5 Place a bowl of hot but not boiling water in the freezer 6 To prevent the floor from becoming wet 11 E during defrosting check progress from time to time and lay towels around the bowl on the floor to protect against ice and splashes When all the frost and ice have melted clean the inside of the cabinet with a mild detergent solution Dry the freezer with a soft cloth 7 Restart the freezer by turning the thermostat button to the required setting If many items are to be
13. ured figs 6 7 100 a ah Se ee 1 1650 1950 1560 1860 fig 6 fig 7 Reversing the door s The door s can be changed from right hinged to left hinged and vice versa as follows 1 Lay the appliance on its back with the 2 Remove the upper hinge 5 Remove the kick plate by pulling it door uppermost 3 Move the plastic plugs to where the outwards and upwards upper hinge was fitted 4 Lift off the door and lay it aside 6 Loosen lock nut with the fork wrench 7 Remove the lower hinge Rotate the 9 Remove the door closer and refit it on enclosed and move the pin hinge through 180 and refit it on the the opposite side opposite side of the appliance 8 Refit the kick plate 10 Remember to pull the pin in the door 11 Refit the door 13 Remove the door handle and refit it on closer towards the side before fitting 12 Fit the upper hinge the opposite side Refit the caps the door 14 The appliance must be allowed to stabilise in an upright position for at least 1 hour before being switched on 15 After reversing the door s it is important to check that the sealing strip provides a tight seal all the way round If it does not carefully heat the strip all the way round using a hair dryer Then ease the strip outwards slightly so that it forms a tight seal against the
Download Pdf Manuals
Related Search