SkyLink SW-433 User's Manual
Contents
1. Introduction Programming the transmitter and the Silent Alarm Warranty FCC The Silent Alarm SW 433 is designed to work with all Skylink sensors that in corporate the rolling code technology This alarm can work with as many as 15 different sensors For instance it can work with the Security System Control Panel Temperature Sen sor Smoke Alarm Sensor Vibration Sensor Flood Sensor Door Window Sen sor are activated They will NOTE If you would like to order Skylink s product or have difficulty getting them to work please 1 2 3 visit our website FAQ section at www skylinkhome com or email us at support skylinkhome com or call our toll free at 1 800 304 1187 from Monday to Friday 9 am to 5 pm EST fax 1 800 286 1320 has been plugged into the silent alarm will be turned on 3 and off for approximately 15 seconds If a lamp is plugged into the Silent Alarm the light will flash so that it can notify 4 With the Silent Alarm plugged in press and hold the SET button on the unit its red LED light will flash Simultaneously activate the sensor that you want to program to the silent alarm until the red LED light on the silent alarm stops flashing indicating it has learned the code 5 Test the sensor by activating it while the Silent Alarm and the appliance are plugged in The appliance will turn on and off for approximately 15 seconds If the appliance that you plugged in does not turn on and of2. f repeat the above procedures the hearing impaired or you may plug in a radio to warn the visually impaired Skylink will not be held liable or responsible for any misuse or application of this product other than for its intended use CUSTOMER SERVICE 17 Sheard Avenue Brampton Ontario Canada L6Y 1J3 Email support skylinkhome com http Avww skylinkhome com P N 101A091 001 US Patent 6243000B1 2005 SKYLINK GROUP are registered trademarks of their respective corporations transmit a signal to the Silent 1 In order for the Silent Alarm to recognize different transmitters they must first be learned to the Silent Alarm Alarm and the appliance that 2 Plug in the Silent Alarm to an electrical outlet its red LED light will go on Plug in an appliance i e light radio maximum 1200 watts to the outlet of the Silent Alarm Turn on the appliance that is plugged into the Silent Alarm Turn on the Silent Alarm by pressing the ON OFF button The appliance should be on after the ON OFF button is pressed If you press the ON OFF button again the appliance will be turned off KY dy LINK SILENT ALARM USER S INSTRUCTIONS Model SW 433 If within one year from date The Remote Control is of purchase this product should become defective due to faulty workmanship or materials it will be re paired or replaced without charge Proof of purchase approved by the FCC and it complie
3. s with Part 15 of the FCC Rules Its operation is subject to the following two conditions This device may not cause harmful inter ference This device must accept any interference that may cause undesired operation WARNING Changes or modifications to this unit not expressly approved by the party res ponsible of compliance could void the user s authority to operate the equipment
Download Pdf Manuals
Related Search