Samsung SN-324 User's Manual
Contents
1. SN 324 EN 03 1 283 9 PM TOTAL OAS KID CD RW DVD ROM DRIVE SN 324 User s Guide FCC Compliance This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC rules These limits are designed to provide reasonable protection against harmful interference in a residential installation p This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be deter mined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Re orient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio TV technician for help http www samsungodd com www samsungelectronics com BG68 XXXXA Rev 00 SN 324 EN 03 1 283 9 PM ze i eal gt Safety Precautions Your CD RW DVD ROM Drive The following diagrams illustrate the precautions to be taken when using you2. Check that the power cable is correctly connected Power off and disconnect the PC Insert a pin or unfolded paper clip in the emergency hole and push firmly until the disc compartment opens Adjust the size of the replay screen After checking the display resolution adjust it if necessary The computer may not recognize the disc if you start playback too quickly after inserting the disc Open and close the disc compartment and try again Clean the disc and try again The interface mode of the sound card is AT BUS You must therefore connect the DVD ROM drive to the IDE port on the PC mother board rather than to the sound card or install an IDE compatible sound card Technical Specifications SAMSUNG continually strives to improve its products Both the design specifications and these user instructions are thus subject to change without notice Disc types supported CD DA CD ROM Mode 1 2 CD ROM XA Mode 2 Form 1 2 Photo CD single Multi session Video CD ready CD I FMV CD Plus CD EXtra CD RW CD R CD TEXT DVD ROM DVD Video Data transfer rate CD R 7200KB sec 24X 1200KB sec 8X 600KB sec 4X 300KB sec 2X CD RW 1200KB sec 8X 600KB sec 4X 300KB sec 2X 120ms 1 3 stroke DRIVE PERFORMANCE 120ms 1 3 stroke Data buffer capadl Laser ERRORRATE 10 MODE110 MODE2 10 FRONT PANEL Auto eject or Auto inject 128 W x 9 5 H x 129 D mm GENERAL
3. In case of the PC without UDMA it may have a different DVD data transmission rate 9
4. The SAMSUNG CD RW DVD ROM SN xxx device name is displayed Using the DMA mode may slightly decrease the efficiency of CD RW DVD ROM The SAMSUNG device driver enables discs in the CD RW DVD ROM drive to be read but not recorded in an MS DOS environment the driver is located in the D driver folder on the CD record utility disc Software Support Upgrading the Firmware Flash Memory Roxio 5 1 or higher The product firmware can be upgraded by downloading the updated file from the following Web site http www samsung ODD com www samsungelectronics com odd Regional Coding Region Protection Coding RPC of DVD Discs This feature is supported on DVD Players and used with DVD Video Discs ie movies Currently the motion picture industry has divided the world into different regional zones These regions or zones correlate to the regional markets into which the motion picture industry releases movies Simply put RPC Codes are placed on Movie Discs marketed throughout the world based on the region of the world they are being sold into These RPC codes help to control and prevent the pirating of new release movies into other motion picture market regions prior to their true release dates within those markets SN 324 CD RW DVD ROM drive supports RPC phase II The local code of RPC 2 mode can be changed by users It is possible for users to change the zone code up to five times on MPEG Application SN 324 EN 031 283 9P
5. CD RW DVD ROM drive is not detected by the computer After installing the CD RW DVD ROM drive the PC gets slower The CD RW DVD ROM drive is not recognized by MS DOS The CD RW DVD ROM drive is not detected by Windows No sound is heard from an audio CD A CD is not read or is read too slowly The disc compartment will not open When the MPEG software plays a Video CD the pictures are not regular and the running speed is too slow The Disc is not in message is displayed even though a disc has been inserted The DVD ROM drive is not detected after it is connected to a sound card Meaning Solution Check that the power audio and IDE cables are correctly connected to the computer Change the IDE cable and reconnect it to the computer Preferably connect a second IDE cable to the CD RW DVD ROM drive in master mode Check the position of the jumper in the master slave select terminal Reinstall the device driver or update it with the latest version by downloading it from the Samsung Web site www samsung ODD com www samsungelectronics com odd This case may occur when there is a Windows installation problem reinstall Windows Check whether the audio cable is correctly connected to the sound output terminal on the DVD ROM drive and the sound card CD IN terminal Check that the sound card is operational Adjust the volume control Install the latest version of the device driver
6. M 1 6 Using the CD RW DVD ROM Drive To play audio or video CDs in your CD RW DVD ROM drive proceed as follows 1 Press the Eject button and you will hear sound like tick Then you should pull the tray open completely 2 Place the disc on the center of the tray with the lt gt OA label side facing upwards 3 Push the tray until it is closed completely 4 Play the disc CD DVD Playing Audio CDs Run the CD player supplied with Windows or your sound card You can listen to the CD by connecting headphones to the appropriate connector If you have installed the appropriate player such as Microsoft Windows Media Player you can adjust the volume using the headphone volume control on the drive front panel Playing Video CD DVDs Set up and run the SOFT MPEG program A Usage Guidelines Do not press down on the disc tray when opening or closing it Do not place objects on the disc tray Never use a damsged broken or deformed disc Do not press the Eject button while the computer is accessing the disc Keep the disc tray closed when not using the CD RW DVD ROM drive Do not press the Eject button while the drive is playing a CD movie To stop a CD movie click Stop button in the CD player application program Note High speed drives spin the disc at a high rotational speed If a CD has printing on only half of the disc or if there is a slight imbalance in the CD the imbalance is gre
7. atly magnified by the high speed causing the drive to vibrate or product a fan like noise These effects are inherent in the high speed technology and do not indicate a problem with drive WARNING The Disc in this unit operate at a very high speed 6 Using the CD RW DVD ROM Drive The procedure described below can be used to remove a disc from the CD RW DVD ROM Drive if the Eject button is disabeled by software or a power failure occurs 1 Turn off the power to the computer installed the CD RW DVD ROM Drive 2 Insert a steel rod about 1 3mm in diameter into the emergency eject hole and push hard 3 The disc tray is ejected by about 10mm Pull it all the way open by hand A stiff paper clip may be used as a steel rod Storing and Cleaning Your Discs To ensure a long service life for your discs and drive follow the precautions below when storing and cleaning your discs 1 Do not place a disc in direct sunlight 2 Store a disc vertically in a well ventilated and stable location 3 Do not write or attach a label on a disc 4 Do not drop a disc or place heavy objects on it 5 Do not touch the surface of a disc hold it by the edges 6 To clean a disc polish lightly from the inside of the disc to the outside with a soft cotton cloth T Do not leave the disc compartment open when you are not using it SN 324 EN 031 283 9PM 1 A g an Solving Technical Problems Problem The
8. ound the border of the center hole we recommend that you make a copy of the disc immediately and then stop using it If you continue using the disc it will probably 49 1 develop more cracks and eventually cause irreparable damage 3 Do not use poor quality discs e From unknown sources z e Without any copyright e Scratched or damaged in any way 2 3 SN 324 EN 03 1 283 9 PM TY 4 gt System Requirements Installing the Device Driver Before you install the CD RW DVD ROM drive we strongly recommend that you check that No additional device driver is needed for Windows 98 2000 ME XP NT as the your setup meets the system requirements listed below default Windows device driver is used You can check that the CD RW DVD ROM drive has been correctly detected by Windows To do so proceed as follows Item Description 1 l l Computer Intel Pentium III or higher 350MHz or higher Double click on the My Computer icon on your desktop 128MB of RAM or higher with an IDE interface 2 Double click on the Control Panel folder Disk space 100MB minimum Windows version Windows 95 OSR2 98 2000 ME XP 3 Double click on the System icon Windows NT 4 0 or higher 4 Click on the Device Manager tab This product has been set at the UDMA mode It may cause trouble due to the compatibility of a specific board or system 5 Expand the CD ROM branch In this case download the latest version of Firmware which supports the DMA Mode
9. r CD RW DVD ROM drive T 3 4 1 2 1 Disc Tray The Disc Tray will be open a little when you press the Eject Button Then you should pull the Tray open completely When you place a disc in the tray make sure that the label on the disc is facing upwards 2 LED Changes or modifications not expressly approved by the party responsible for compliance 3 o e IONS eee peng Tead could void the user s authority to operate the equipment 4 Emergency Eject Hole If the disc tray does not open when you press the Eject button insert You must not use the drive in any manner other than that specified in this guide a small metal rod an unwound paper clip for example into this hole eject the disc aes CAUTION Do not attempt to repair the CD RW DVD ROM drive yourself This function should only be performed when the computer is powered OFF Se Contact your dealer or local SAMSUNG representative for all repairs If you make any adjustments or perform any operations other than those specified in this guide you run the risk of exposure to hazardous radiation Avoid exposing your eyes or skin to direct or scattered radiation WARRANTY Please refer to the Samsung limited warranty statements Precautions 1 To reduce the risk of fire or electric shock do not expose this i Fee B appliance to rain or moisture T 2 Always check each disc for cracks before using it If there are cracks on the surfaces especially ar
Download Pdf Manuals
Related Search