Phase Technology CL-1.5 User's Manual
Contents
1. ILA F Custom Installation Series See arom Ores HHHH TECHNOLOGY Owners Manual Installation Instructions CI 1 5 Speaker seismic restraint hole SpeedWing mounting arms Installation aid paint mask Grille safety clip Grille Box contents 1 Speaker 1 Grille 1 Paint mask 1 Hole template 1 Euroblock connector MSE Audio Group 8650 College Boulevard Overland Park Kansas 66210 866 663 9770 www mseaudio com www phasetech com HHE sods SOUNE TUBE E N T E R T A I N INDUCTION DYNAMICS TECHNOLOGY DILA F Installation Instructions Installing the Speakers For Your Life TE CH NO LO GY Cl 1 5 in a Sheetrock Ceiling 1 Unpack speaker Leave 2 Use hole template to paint mask in place until mark cutout on sheetrock after speaker is installed or painting is complete 3 Use RotoZip or other tool 4 Connect Euroblock to to cut hole Hole diameter Speaker wires and connect 5 6 in 142 mm to speakers 5 If required attach seismic 6 Insert speaker into restraint system to hole in mounting hole with paint clamping arm then to mask in place Tighten both reinforced structure safety screws on the baffle face to cable not included actuate the mounting wings Firmly secure both screws DO NOT OVERTIGHTEN 9 Attach grille safety clip by 10 Align tabs on snap fit placing the large end of the grille with slots in baffle clip over snap fit post 1 gently press gr2. ille into place then sliding clip until small end snaps into place around post 2 7 Remove paint mask 8 Adjust tap switch to unless painting is required proper setting Switch is In that case follow steps preset to 8 ohm mode 8 11 when painting is complete 11 Done D ILA F Installation Instructions Installing the CI 1 5 speakers For Your Life Using Optional Pre Construction Bracket TE CH NO LO GY 1 Nail or screw bracket to 2 Finish installing ceiling 3 Use RotoZip or other tool 4 Unpack speaker Leave joists to cut hole paint mask in place until after speaker is installed or painting is complete 5 Connect euroblock to 6 If required attach 7 Insert speaker into 8 Remove paint mask speaker wires and connect seismic restraint system to mounting hole Tighten both unless painting is required to speakers the sheet metal tab on the screws on the baffle face to In that case follow steps rear panel of the speaker actuate the mounting wings 9 12 when painting is then to reinforced structure DO NOT OVERTIGHTEN complete safety cable not included 9 Adjust tap switch to 10 Attach grille safety clip 11 Align tabs on snap fit 12 Done proper setting Switch is by placing the large end of grille with slots in baffle preset to the 89hm mode the clip over snap fit post 1 gently press grille into place then sliding clip until small end snaps into place around post 2
Download Pdf Manuals
Related Search