Pelco DAS5200 User's Manual
Contents
1. INSTALLATION J TEP NSM5200 PS Replacement Power Supply Endura NSM5200 DAS5200 Series by Schneider Electric C4611M 10 09 The NSM5200 and DAS5200 units incorporate two independent hot swappable power supplies Each power supply acts as a redundant alternate for the other This level of fault tolerance ensures that the NSM5200 and the DAS5200 are capable of sustaining uninterruptible operation in the event of failure If a power supply fails the hot swappable feature simplifies replacement without shutting down the unit or interrupting normal operation This document describes how to replace a failed power supply in an NSM5200 Series network storage manager NSM and a DAS5200 Series direct attached storage DAS NOTES e You can replace one failed power supply without shutting down the unit e No tools are required to replace this component e The NSM5200 rear panel is displayed in this document The power supplies are in the same locations in the DAS5200 To replace a power supply 1 Review all instructions in this document before proceeding 2 Identify the failed power supply The status indicator of a failed power supply is red 3 Disconnect the power cord from the failed power supply as follows WARNING For safety you must disconnect the power cord from the wall socket or other power source before disconnecting it from the failed power supply on the unit a Disconnect the power cord of the failed power supply from the power so2. comply with Directive 2002 96 EC of the European Union regarding the disposal of waste electrical and electronic equipment WEEE Contact your local dealer for procedures for recycling this equipment Pelco Inc Worldwide Headquarters 3500 Pelco Way Clovis California 93612 USA USA amp Canada Tel 800 289 9100 Fax 800 289 9150 International Tel 1 559 292 1981 Fax 1 559 348 1120 www pelco com Copyright 2009 Pelco Inc All rights reserved Pelco and the Pelco logo are registered trademarks of Pelco Inc
3. urce b Disconnect the power cord of the failed power supply at the rear panel of the unit 4 Turn the captive thumbscrew counterclockwise to loosen It Figure 1 Loosening the Captive Thumbscrew Power Supplies thumbscrew 2 Power Receptacles O Reserve Power Supply Pull Handles 5 Using the pull handle gently remove the failed power supply from the unit Figure 2 Removing the Power Supply 6 Position the replacement power supply so that the cord receptacle is on the left side of the unit Figure 3 Replacing the Power Supply 7 Gently push the replacement power supply into the unit until it locks into place 8 Turn the captive thumbscrew clockwise to tighten it 9 Connect the power cord for the replacement power supply as follows J WARNING For safety you must plug the power cord into the power supply before plugging it into the wall socket or other power source a Connect the power cord to the receptacle on the replacement power supply b Connect the power cord to the power source 10 Verify that the indicator on the newly installed power supply glows green The power supply alarm will stop REVISION HISTORY Manual Date Comments C4611M 10 09 Original version amp Green The materials used in the manufacture of this document and its components are compliant to the requirements of Directive 2002 95 EC This equipment contains electrical or electronic components that must be recycled properly to
Download Pdf Manuals
Related Search