Panasonic Arbitrator 360 User Guide
Contents
1. WIRELESS TRANSCEIVER SYSTEM TDSS 900 PNA User Guide 900MHz Series Version 1 5 3 Read this user s guide carefully for safe operation and proper use of the product Features and specifications are subject to change without notification RECOMMENDATIONS BOX CONTENTS Prior to use charge TX at least 3 hours Disconnect the battery or switch the power OFF when TX Set is not in use for long periods 1 Transmitter TX Charge TX Set when not in use for short periods Receiver RX Plug In Microphone MONO TROUBLESHOOTING Mounting Bracket for Receiver with screw Probl heck Points i roblems Chec Rechargeable Li lon Battery Check the battery status No reception Check the connection and cables Leather Pouch Check the communication range External antenna Change the location of RX Set Poor reception Check the communication range Desktop charger for transmitter Static noise Check to see if unit is placed near TV speakers or other electronic devices AC Power supply for desktop charger Check the battery status Charger Stand for Desktop Charger Unit does not Check the power switch on the bottom of respond the unit Straight Type internal antenna Check the connection and cables RF Main Cable In car MIC Instruction Manual TIP2 Preserving the Batteries In order to maintain the optimum capacity of the rechargeable battery pack the u2. nit has to be fully discharged by using approximately every 6 months Then recharge the battery to full capacity again DESCRIPTION Main Cable To Receiver Power Red Power GND Black Audio Out RCA connector Trigger REC Yellow GND Black Important These three ground wires have to be all connected together Power ground wire from TDSS 900 PNA Trigger ground wire from TDSS 900 PNA and Ground wire of the Recorder GPIO Connection with the system Power DC12V Red Power GND Black Power Cables to engine battery Audio Out RCA Connector Connects to AUDIO IN 1 port in the back of recorder Trigger REC Yellow Connect to GPIO1 brown cable GND Black Connect to GPIO black cable DESCRIPION Receiver lt Rear gt lt Bottom gt e nonren 6 wan cae comectn a a 2 Talk On LED 3 Charging Status When TX triggers the recording of the Red LED In charging system green LED lights on Green LED Fully Charged OPERATION OPERATION Install the bracket by using the screws Slide RX Set onto the Bracket Connect the main cable to RX Set Connect the antenna Internal Antenna or External Antenna to the RX Set Indication of LED Button Place external antenna on the windshield at the point Horizontal or Vertical as following picture Talk REC Low Out of Battery range N Push Push 5 gt OFF lt pON Mode Mode Mute Red LED l
3. re installation check power supply and voltage to avoid hazards Number of Channel Do not apply force or shock to the unit Do not disassemble the unit Channel Space Placement of items on the duty belt can restrict ready access to important equipment The location of the wireless transmitter or any Speech Coder other device provided with this system that is carried on the officer s person should be chosen with care and consideration Type of Modulation After a location is selected the officer should test access to and practice drawing primary items such as service firearms and Processing Gain Power DC 12V for RX 20Channels 1 2MHz 32Kbps ADPCM with parity DBPSK SS MODULATION DEMODULATION 11dB secondary defense devices such as Aerosol Subject Restraint Batons Electronic Disruption Devices etc Proper operation of Data Rate S0Rops TIME Division Duplex handheld radios and other signaling devices should also be tested as should access to handcuffs and other restraining devices PAANS APES calmer Receiver Sensitivit 102dBm 82dBm strangulation i e loop around the neck or any other body part Battery Talking Time 12Hours Charging Time 3Hours Battery Capacity Lithium ion 3 7V DC 2000mA TX power levels 100mW 10mW 1mW Temperature Range 20 C 60 C Dimensions WxDxH TX 54mm x 30 5mm x 83 6mm RX 104mm x388mm x 81 5mm
4. t External Antenna Installation gt ioan Blue On Blue Vibration notes 1 3 Blink Red On Red Blink aa Red Blue gt Blink Put the battery pack into TX Set Mute Talk No Blue Off Blue Red Off Red Off Red Off Indication Off Note Switch the power ON o PEP 1 LED ON this mode as initial when Power on OCAR One poten Or Tx Cnt 2 After synchronized the mode goes back to the last 3 When TX is Off and inserted to RX there will be no synchronized Prior to use charge the unit by placing TX set in the RX set at least for 3 hours Place TX on RX to sync the code DESCRIPTION Transmitter DESCRIPTION HOME CHARGER Battery LED Power Adapter Connector Battery LED In Charging Red LED Fully Charged Green LED 4V 4 2V Note Place TX on the charger at least 4 5sec for the initializing Installation for Charger stand lt Bottom gt 1 Beeptore 6 TX Power On Off TIP1_How to detach TX from RX and Home Charger Ee aes sola Aouad To prevent units from being broken by the improper use Microphone Jack 8 MuteButton detach TX unit from RX unit as the drawing described on the right picture FCC Label 9 Talk Button Serial Number Label Mode Selection Button CAUTION SPECIFICATION Use only provided antenna with RX Set Do not immerse in water or keep in humid areas Do not place near TV speakers or other electronic devices Frequency MHz 902 927MHz Band Width Befo
Download Pdf Manuals
Related Search