Panamax MAX 5300-PM User's Manual
Contents
1. Dimensions Weight 17 x 12 75 x 3 5 30 Ibs 2315 X 10S x10 33 5 Lbs 0 50616 00816 7 Same as 33 5 Lbs 5 00 50616 00816 2 4 1 H with feet Unit Carton PAIMARAAN 1690 Corporate Circle Petaluma CA 94954 800 472 5555 or 707 283 5900 Fax 707 283 5901 www panamax com 2007 Panamax Inc Panamax MAX and the Panamax logo are registered US trademarks of Panamax L590 REV A 07 072. LOOKING FOR CRYSTAL CLEAR PICTURE AND SOUND Clean Power Level 4 Improves picture and sound quality by eliminating noise across the entire AC bandwidth 40 more efficient at eliminating noise than Clean Power Level 3 MAX 5300 PM AVM Automatic Voltage Monitoring Protects equipment against prolonged over un der voltages by disconnecting the power and reconnecting it when safe power returns EN Improves Picture and Sound Quality Level 4 Power Cleaning and Filtration eliminates High Current Outlets common symptoms of contaminated power including 2 outlets for equipment with high power loss of detail pops hisses hums and visual artifacts demands Amps S ubwoofers and allows your A V equipment to perform up to its full Capability USB Charger Convenience charger for mp3 players cell PA Monitors Incoming Line Voltage and Provides a phones and other small electronics Visual Indication of Power Level Panamax s patent pending AVM circuitry continuously monitors the incoming power as displayed on the digital voltmeter In case of an undervoltage or an overvoltage a flashing red lightning bolt will be displayed in the voltmeter and power to the connected equipment is automatically turned off if either of these conditions is detected When voltage returns to a safe level power to the equipment is automatically reconnected s Gaming LAN Port Easy access to LAN port on front panel Perfect for on
3. line gaming 5 Isolated Outlet Banks Isolating outlet banks from one another prevents noise contamination between components 12 Volt Trigger IEJ Reduces Cross Contamination Between Components Allows source equipment to activate or The M5300 P M is designed to provide noise isolation deactivate the outlets on the M5300 PM between 5 isolated outlet banks including 1 bank with 2 high current outlets so that any noise created by an A V component cannot contaminate the power going to equip ment plugged into another outlet bank Power Sequencing Guards against blown fuses and potentially damaging speaker thump by automatically powering outlets on and off in sequence 11 Outlets 5 Always On 4 Switched 2 Switched High Current www panamax com FAINAMAX MAX 5300 PM BACK PANEL FEATURES 1 15A Main Circuit 2 Outlet Bank 5 3 Outlet Banks 3 and 4 4 Outlet Banks 1 and 2 5 Universal TV Coaxial Breaker Two switched high current outlets controlled by Each bank features two switched outlets with linear Each bank features two always on outlets with Jacks Automatically opens the front panel Power Button or the DC Trigger in filtration technology LIFT controlled by the front linear filtration technology LIFT Power will 3 pairs of bidirectional when the current load put Bank 5 has a 5 second turn on delay and turns panel Power Button or the DC Trigger input Banks only be turned off under a fault condition See protectio
4. n circuits optimized for is greater than 15 off immediately upon shutdown The High Current 3 amp 4 will turn on immediately and turn off after a Specifications for over voltage and under voltage Satellite cable and antenna Amps Push to reset outlets provide power from a low impedance noise 10 second delay LiFT EMI RFI noise filtration is thresholds LIFT EMI RFI noise filtration is TV signal lines filtration circuit that does not limit the current to provided by a two stage balanced Pi filter which provided by a two stage balanced Pi filter which your equipment Its output is noise isolated from all also provides noise isolation from all other outlet also provides noise isolation from all other other outlet banks banks outlet banks ow TED 6 Main Power Cord 10ft 7 Ground Lug 8 Bank 1 amp 2 Indicator 9 Voltage Sense Trigger 10 Voltage Sense Trigger 11 LAN J acks 12 Phone J acks Must be plugged into a Provides a common Light Output Input Protection circuits for 10 100 baseT Ethernet Protection circuits for standard properly wired amp grounded grounding point for Normally ON is lit when 3 5mm 1 8 Mini P lug jack 3 5mm 1 8 mono mini plug lines For the LAN 2 protected jacks the incom telephone or pay per view lines 3 wire outlet equipment with separate there is power present Connecting a trigger wire to Connect to a remote trigger ing LAN line MUST be plugged into the LINE Phone circuit is autoresetting ground leads
5. on the Bank 1 and 2 the Voltage Sense Outputjack device that uses a DC output jack and the patch cord to the equipment MUST Incoming phone cord MUST be receptacles will allow the input signal to to trigger a startup shutdown be plugged into the EQUIP jack For the LAN 1 plugged into the LINE jack Patch pass through the M5300 PM to sequence protected jacks the incoming LAN line must be cords to the equipment satellite control the startup shutdown of plugged into the LINE jack and the equipment receiver digital video recorder an additional device must be plugged into the gaming jack on the telephone etc MUST be plugged MAX 5300 PM SPEC FICATIONS front panel 8 wire protection 52V clamping into the EQUIP jacks General LAN Circuits Initial Clamping Level Energy Dissipation Peak Impulse Current Catastrophic Surge Circuit Thermal Fusing Capacitance 30pf approx Suppression Modes Metallic amp Longitudinal Over voltage shutoff 142 VAC 8 VAC Wires Protected 2 Wire Pins 4 amp 5 Under voltage shutoff 90 VAC 2 VAC Connectors EMI RFI Noise Filtration Cable and Satellite Circuits Banks 1 2 3 4 HD 1080 i p Ready Bank 5 High Current Outlets Shielded Clamping Level Frequency Range Insertion Loss Connections Bidirectional Positive Tip Negative Ring Design and specifications subject to change without notice due to product improvement UPC S QUANTITIES WEIGHTS amp MEASUREMENTS FOR ORDERING amp SHIPPING
Download Pdf Manuals
Related Search