Nortel Networks 210667-A User's Manual
Contents
1. Note This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to Part 15 of the FCC rules These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment This equipment generates uses and can radiate radio frequency energy If it is not installed and used in accordance with the instruction manual it may cause harmful interference to radio communications Operation of this equipment in a residential area is likely to cause harmful interference in which case users will be required to take whatever measures may be necessary to correct the interference at their own expense EN 55 022 Statement This is to certify that the Nortel Networks e mobility 802 11b Wireless LAN DSSS Access Point is shielded against the generation of radio interference in accordance with the application of Council Directive 89 336 EEC Article 4a Conformity is declared by the application of EN 55 022 Class A CISPR 22 Warning This is a Class A product In a domestic environment this product may cause radio interference in which case the user may be required to take appropriate measures Achtung Dieses ist ein Ger t der Funkst rgrenzwertklasse A In Wohnbereichen k nnen bei Betrieb dieses Ger tes Rundfunkst rungen auftreten in welchen Fallen der Benutzer fiir entsprechende Gegenma nahmen verantwortlich ist Attention Ceci2. 00 320 Japan RCR STD 33 Radio Data Ran 11 Mbps range 5 5 Mbps range 2 Mbps range 1 Mbps range Radio Output Power 100 mW Open environment approximately 400 feet 121 92 meters Typical office or retail environment approximately 150 feet 45 72 meters Dependent upon antenna selection building construction and environmental characteristics Open environment approximately 700 feet 213 36 meters Typical office or retail environment approximately 250 feet 76 20 meters Dependent upon antenna selection building construction and environmental characteristics Open environment approximately 800 feet 243 84 meters Typical office or retail environment approximately 300 feet 91 44 meters Dependent upon antenna selection building construction and environmental characteristics Open environment approximately 1200 feet 365 76 meters Typical office or retail environment approximately 450 feet 137 16 meters Dependent upon antenna selection building construction and environmental characteristics
3. Part No 210667 A December 2000 4401 Great America Parkway Santa Clara CA 95054 Installing the e mobility 802 11b Wireless LAN DSSS Access Point NORTEL NETWORKS 210667 A Copyright 2000 Nortel Networks All rights reserved Printed in the USA December 2000 The information in this document is subject to change without notice The statements configurations technical data and recommendations in this document are believed to be accurate and reliable but are presented without express or implied warranty Users must take full responsibility for their applications of any products specified in this document The information in this document is proprietary to Nortel Networks NA Inc Trademarks NORTEL NETWORKS and e mobility are trademarks of Nortel Networks All other trademarks and registered trademarks are the property of their respective owners Statement of Conditions In the interest of improving internal design operational function and or reliability Nortel Networks NA Inc reserves the right to make changes to the products described in this document without notice Nortel Networks NA Inc does not assume any liability that may occur due to the use or application of the product s or circuit layout s described herein Declaration of Conformity We Symbol Technologies Inc of One Symbol Plaza Holtsville NY 11742 1300 USA declare under our sole responsibility that the product Spectrum24HR LA 4121 11 Mbps Typ
4. ance diversity antennas e Mountable F plane antenna If installing two antennas enable the Antenna Diversity option in the User Interface Refer to Access Point Installation in the Reference for the e mobility 802 11b Wireless LAN DSSS Access Point part number 210669 x Antenna Extension Cables Nortel Networks offers extension cables for access point antennas Some range loss occurs when increasing the distance between the antenna and the access point Length Loss Range Loss 6ft 2 0 dB 5 12 ft 4 0 dB 10 To order extension cables contact a Nortel Networks representative Connecting the Power Adapter The power adapter connects to the rear of the access point and to a power outlet To connect the power adapter 1 Verify that the power adapter matches the country of use requirements 2 Plug power adapter cable into the socket on the back of the access point 3 Plug the adapter into an outlet When the Power indicator on the front of the access point stops flashing and lights solid green and the Wireless LAN Activity indicator begins flickering the access point is functional and ready to associate with MUs Note The e mobility access point may also be powered by using the Remote Power Interface RPI in conjunction with the AC Power Adapter The RPI enables the access point to be installed in locations without direct access to AC power Refer to 210672A Installing the e mobility 802 11b Wireless LAN DSSS Re
5. e II Radio Card To which this product relates is in conformity with the following standards and or other normative documents ETS 300 328 November 1996 Radio Wideband 2 4GHz Spread Spectrum ETS 300 826 November 1997 EMC 2 4GHz wideband transmission systems EN 60950 1992 Incl Amdt 1 4 11 Safety of Information Technology Equipment We hereby declare that all essential test suites have been carried out and that the above named product is in conformity to all essential requirements of Directive 1999 S EC The conformity assessment procedure referred to in Article 10 5 and detailed in Annex IV of Directive 1999 5 EC has been followed with the involvement of the following Notified Body ies BABT Claremont House 34 Molesey Road Walton on Thames KT12 4RQ Identification Mark 0168 The equipment also carries the Class 2 equipment identifier p The technical documentation relevant to the above equipment can be made available for inspection on application to Symbol Technologies EMEA Symbol Place Winnersh Triangle Berkshire RG 41 5TP UK Dornu Narnor Senior Director Regulatory Wonu 7 September 2000 name title signature of authorised person date Symbol Spectrum24 HR products have been rebranded to Nortel Networks e mobility 802 11b Wireless LAN DSSS products and the above Declaration of Conformity applies to both brands Federal Communications Commission FCC Compliance Notice Radio Frequency Notice
6. est un produit de Classe A Dans un environnement domestique ce produit risque de cr er des interf rences radio lectriques il appartiendra alors l utilisateur de prendre les mesures sp cifiques appropri es EC Declaration of Conformity This product conforms to the provisions of the R amp TTE Directive 1999 5 EC Bureau of Standards Metrology and Inspection BSMI Statement GELA Pe PANERA ESENE ERN mE STEH CTE HRT Erari Re eee Canadian Department of Communications Radio Interference Regulations This digital apparatus e mobility 802 1 1b Wireless LAN DSSS Access Point does not exceed the Class A limits for radio noise emissions from digital apparatus as set out in the Radio Interference Regulations of the Canadian Department of Communications Warning To comply with FCC and Industry Canada exposure requirements antennas that are mounted externally at remote locations or operating near users at standalone desktop or similar configurations must operate with a minimum separation of 20 cm from all persons R glement sur le brouillage radio lectrique du minist re des Communications Cet appareil num rique e mobility 802 11b Wireless LAN DSSS Access Point respecte les limites de bruits radio lectriques visant les appareils num riques de classe A prescrites dans le R glement sur le brouillage radio lectrique du minist re des Communications du Canada European Economic Area The European variant is intended for use
7. ific 800 2LANWAN or 800 252 6926 61 2 9927 8800 China 800 810 5000 An Express Routing Code ERC is available for many Nortel Networks products and services When you use an ERC your call is routed to a technical support person who specializes in supporting that product or service To locate an ERC for your product or service go to the www12 nortelnetworks com URL and click ERC at the bottom of the page Introduction The e mobility 802 11b Wireless LAN DSSS Access Point AP provides a bridge between Ethernet wired LANs and e mobility wireless networks It provides transparent access between Ethernet wired networks and radio equipped mobile units MUs MUs include all of Nortel Networks e mobility terminals scanners third party devices and other equipment The access point provides an 11 Mbps data transfer rate on the radio network For further information about access point configuration refer to Reference for the e mobility 802 11b Wireless LAN DSSS Access Point part number 210669 x Precautions Before installing the access point AP verify the following The location for the unit is dry and dust free Install in wet or dusty areas only with additional protection Contact a Nortel Networks representative for more information e The environment has a temperature range between 20 C and 55 C Requirements The minimum installation requirements for a single cell peer to peer net
8. mote Power Inteface for details LED Indicators The LED indicators provide a status display indicating transmission and error conditions The indicators are Power Flashing indicates AP initialization Shows steady green during operation Link Flashing indicates data transfers on wired connection Activity Flickering indicates beacons and data transfers with MUs Specifications Physical Characteristics Dimensions Weight w power supply Operating Temperature Storage Temperature Humidity Shock ESD Drop 1 25 inches H x 5 5 inches L x 7 75 inches W 3 18 cm H x 14 97 cm L x 19 69 cm W 1 Ibs 0 454 kg 4 F to 131 F 20 C to 55 C 40 F to 149 F 40 C to 65 C 10 to 95 noncondensing 40 G 11 ms half sine meets CE Mark withstands up to a 30 in 76 cm drop to concrete with possible surface marring Radio Characteristics The frequency range used by the e mobility 802 11b WLAN DSSS components is within 2 4 GHz to 2 5 GHz unlicensed ISM band From one to eleven of the fourteen 22 GHz wide channels country dependent Frequency Allow hannel Ran Country 2 412 2 470 1 11 United States 2 430 2 447 5 8 Israel 2 457 2 463 10 11 Spain 2 458 2 472 10 13 France 2 400 2 485 1 14 Japan TX Max Radiated US FCC part 15 247 EIRP Europe ETS 300 320 Japan RCR STD 33 Modulation Binary GFSK TX Out of Band US FCC part 15 247 15 205 Emissions 15 209 Europe ETS 3
9. n any direction The AP attaches to a wall and can be oriented in any position as long as the antennas are oriented vertically e mobility 802 11b Wireless LAN DSSS Access Point Antennas Antenna coverage is analogous to lighting Users might find an area lit from far away to be not bright enough An area lit sharply might minimize coverage and create dark areas Uniform antenna placement in an area like an even placement of light bulbs provides even efficient coverage Place the antenna using the following guidelines e Install the antenna as high as practical e Orient the antenna vertically for best reception e Point the antenna downward if attaching the AP to the ceiling The AP requires one antenna and can use two Two antennas provide diversity that can improve signal reception Attach antennas to ANTENNA connectors on the back of the AP For a single antenna use the PRIMARY ANTENNA connector and set the Antenna Diversity setting to Primary Only This is the left antenna connector when viewed from the front of the unit It is identified by one vertical bar on the bottom of the unit The secondary antenna is marked with two vertical bars The standard antenna performs well in most office environments Obtain additional or higher performance antennas from Nortel Networks Contact a Nortel Networks representative to order the following models e Standard rubber antenna e Single high performance antenna e Twin high perform
10. throughout the European Economic Area however authorization for use is restricted as follows European standards dictate maximum radiated transmit power of 100mW EIRP and frequency range 2 400 2 4835 GHz In France the equipment is restricted to the 2 4465 2 4835 GHz frequency range In Belguim outside the equipment is restricted to the 2 460 2 4835 frequency range The operation of this equipment in Italy requires a user license Hard Copy Technical Manuals You can print selected technical manuals and release notes free directly from the Internet Go to the www25 nortelnetworks com library tpubs URL Find the product for which you need documentation Then locate the specific category and model or version for your hardware or software product Use Adobe Acrobat Reader to open the manuals and release notes search for the sections you need and print them on most standard printers Go to Adobe Systems at the www adobe com URL to download a free copy of the Adobe Acrobat Reader How To Get Help If you purchased a service contract for your Nortel Networks product from a distributor or authorized reseller contact the technical support staff for that distributor or reseller for assistance If you purchased a Nortel Networks service program contact one of the following Nortel Networks Technical Solutions Centers Technical Solutions Center Telephone EMEA 33 4 92 966 968 North America Asia Pac
11. work are a power outlet and an antenna Note Use and test the radio network with a properly equipped e mobility mobile unit Network Connection Locate connectors for Ethernet antennas and power on the back of the AP Ethernet configurations vary according to the environment Note The e mobility site survey utility can be used to determine the number of access points to install and their locations 10BASE T UTP Use a 1OBASE T connection for multiple access points or an access point attached to a wired UTP Ethernet hub or switch Normal 10BASE T limitations apply To establish a 10BASE T connection 1 Plug the data cable RJ 45 connector into the access point RJ 45 connector 2 Plug the other end of the data cable into the LAN access port possibly a hub or wall connection 3 Add additional access points as needed Note When connecting the e mobility access point to an Ethernet switch ensure the switch port parameters are set to 10 Mbps Half Duplex Severe performance degradation may result from mis matched speed or duplex modes Mounting the AP The AP rests on a flat surface or attaches to any hard flat stable surface Position the AP at any angle Use the standard mounting kit provided Choose an option based on environment e Resting flat The AP rests on the four rubber pads on its underside Place the AP on a surface clear of debris and away from traffic e Attaching on the wall i
Download Pdf Manuals
Related Search