NewAir AH-320E User's Manual
Contents
1. ee E The adapter should not be used if a three slot eS grounded receptacle is available GROUNDING GROUNDING MEANS i DO NOT DEFEAT THE SAFETY PURPOSE OF THE GROUNDED PLUG PRODUCT INFORMATION Reflective heating technology replicates the sun s healthy rays directly warming the object or person in front of the heater As the temperature of the heated surface rises the warming effect is felt throughout the air and surrounding areas Reflective heaters are great for open or large rooms and actually save you energy by warming objects and not the entire room Reflective heating is both safe and healthy it produces no odors chemicals or fumes and doesn t stir up dust As a safety feature the heater s exterior housing does not get as warm during use to reduce the risk of burns from anyone or anything touching the heater Remarkably efficient our heater uses less power to create the same amount of heat as traditional heaters Equipped with safety tip over switch and overheat auto off the NewAir reflective heater is safe and reliable SPECIFICATIONS Voltage Rating 120 V 60Hz Power Consumption 800W on High 400W on Low Unit Size 14 5 in W x 13 5 in D x 34 in B Unit Weight 6 5 lbs PRODUCT DIAGRAM Back Guard Front Grille Reflective Tube Sliding Column Reflection Hood Adjustable Height Button Control Panel Rask Diagram may diffe2. operation press the TIMER button repeatedly Add up the lit indicator lights for the total number of hours The heater will automatically shut off after the set time has elapsed Note 0 5H 30 minutes 1H 1 hour 2H 2 hours 4H 4 hours Swing Press the OSCIL button and the heater head will oscillate 90 from right to left The indicator light will turn on Press the OSCIL button again to stop oscillation The indicator light will turn off Remote Control Operation The remote control can be used to perform all the operations that can be performed from the control panel i ae bes K 0N 0 i CONTROL PANEL REMOTE CONTROL Height Adjustment Press in the height adjustment button and simultaneously pull the sliding column up to the desired height Release the height adjustment button to set To 4 reduce the height press in the height adjustment button and simultaneously push the sliding column down Release the button to set Heater Head Adjustment Grasp the reflection hood and gently tilt forward or backwards The unit will click into the different positions Notice When adjusting the heater head the heater must be turned off to ensure safety NOTE A tip over safety protection switch is installed at the bottom of the heater When the heater is not placed horizontally laid down or lifted up it stops operating to ensure safety After placing
3. the heater upright it will resume operation NOTE For safety if the heater s internal temperature rises above a certain point the heater is designed to automatically shut off To restart the heater in this situation 1 Push the power button to ON OFF 2 Unplug the power cord from the outlet and allow the heater to cool for at least 10 minutes 3 Plug the power cord back into the outlet Use the control panel to select the desired settings WARNING It is normal for the power cord to feel warm to the touch however a loose fit between the outlet and the plug may cause overheating of the plug If this occurs try inserting the plug into a different outlet Contact a qualified electrician to inspect the original outlet for damage MAINTENANCE 1 Unplug the unit and let it cool completely 2 To keep the heater clean the outer shell may be cleaned with a soft damp cloth You may use a mild detergent if necessary After cleaning dry the unit with a soft cloth CAUTION DO NOT let liquid enter the heater 3 DO NOT use alcohol gasoline abrasive powders furniture polish or rough brushes to clean the heater This may cause damage or deterioration to the surface of the heater 4 DO NOT immerse the heater in water Wait until the unit is completely dry before use STORAGE Store the heater in a cool dry location when not in use To prevent dust and dirt build up use the original packaging to repack the unit TROUBLESHOOTIN
4. 250W To avoid fire or shock hazard plug the unit directly into a 120 V AC electrical outlet To disconnect heater turn controls to OFF then remove plug from outlet Pull firmly on the plug DO NOT unplug by pulling on the cord Always unplug the unit before moving or cleaning or whenever the heater is not in use Use only for intended household use as described in this manual Any other use not recommended by the manufacturer may cause fire electric shock or injury to persons The use of attachments not recommended or sold by unauthorized dealers may cause hazards Always use on a dry level surface DO NOT use outdoors WARNING To reduce the risk of fire or electric shock DO NOT use this unit with any solid state speed control device 1 21 DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit Doing so will void your warranty The inside of the unit contains no user serviceable parts Qualified personnel should perform all servicing only 22 Connect to properly grounded outlets only 23 SAVE THESE INSTRUCTIONS WARNING This heater is for use on 120 volts The cord has a plug as shown in A An adapter as 0 T shown in C is available for connecting three ER el blade grounding type plugs to two slot G9 caver oF ceoungen ti receptacles The grounding lug extending from men the adapter must be connected to a permanent ground such as a properly grounded outlet box
5. G If the heater will not operate please check the following before seeking repair of service 5 Check 1f the power cord is plugged into an electrical outlet if not plug in Check if electricity to the main fuse 1s working 3 Check if the heater is set to ON by confirming the light on the control panel is lit If not press the POWER button to turn on the unit 4 Check if the heater is on a level surface If the tip over safety switch is not pushed in the heater will not run WARRANTY THIS WARRANTY DOES NOT COVER 1 Damage accidental or otherwise to the unit while in the possession of a consumer not caused by a defect in material or workmanship 2 Damage caused by consumer misuse tampering or failure to follow the care and special handling provisions in the instructions 3 Damage to the finish of the case or other appearance parts caused by wear 4 Damage caused by repairs or alterations of the unit by anyone other than those authorized by Soleus International Inc 5 Freight and Insurance cost for the warranty service
6. Oscillating Reflective Carbon Heater with Remote Control amp lonizer OWNER S MANUAL Model AH 320E PLEASE SAVE THESE INSTRUCTIONS WARNING READ THIS OWNER S MANUAL CAREFULLY BEFORE USE IMPORTANT INSTRUCTIONS When using this electric unit basic safety precautions should always be followed to reduce the risk of fire electric shock and injury to persons including the following 10 11 12 13 14 15 16 17 18 19 20 Read ALL instructions before using this unit CAUTION Risk of Electric Shock DO NOT open or try to repair the heater yourself This heater is hot when in use To avoid burns DO NOT let bare skin touch hot surfaces If provided use handles when moving this heater Keep combustible materials such as furniture pillows bedding paper clothes and curtains at least 3 ft from the front of the heater and keep them away from the sides and rear DO NOT place towels or other objects on the heater Extreme caution is necessary when any heater is used by or near children or the disabled or when the heater is l
7. eft operating and unattended DO NOT operate any heater with a damaged cord or after the heater malfunctions has been dropped or damaged in any manner Return heater to authorized service facility for examination electrical or mechanical adjustment or repair This heater is not intended for use in bathrooms laundry areas and similar indoor locations NEVER locate heater where it may fall into a bathtub or other water container To protect against electrical hazards DO NOT immerse in water or other liquids DO NOT touch the control panel or plug with a wet hand DO NOT run cord under carpeting DO NOT cover cord with throw rugs runners or similar coverings Arrange cord away from traffic area and where it will not be tripped over DO NOT insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire or damage the heater To prevent a possible fire DO NOT block air intakes or exhaust in any manner DO NOT use on soft surfaces like a bed where openings may become blocked A heater has hot and arcing or sparking parts inside DO NOT use in areas where gasoline paint explosive and or flammable liquids are used or stored Keep unit away from heated surfaces and open flames Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire However if you have to use an extension cord the cord shall be No 16 AWG minimum size and rated not less than 1
8. r slightly from actual product ASSEMBLY 1 Remove the heater body and base from the box Remove the packaging materials and keep for future storage 2 Slide the neck of the heater head into the column connected by the cord so that the holes in the neck align with the holes in the column 3 Insert and tighten the screws with a Philips screwdriver 4 Attach the base to the heater body by screwing on the fastening screw OPERATING INSTRUCTIONS Control Panel Operation 1 5 Place the heater on a firm level surface and plug into a grounded 120V 60Hz power outlet Press the ON OFF button to turn on the heater POWER indicator light and HIGH indicator light are working LOW heating up to 400W HIGH heating up to 800W Timer The heater is equipped with a 0 5 to 4 hour timer To select the desired length of
Download Pdf Manuals
Related Search