NEC Express5800/MC2200 Release Notes
Contents
1. System Release Server MC2200 System Release Notes These System Release Notes provide the latest available release information Copyright 1999 Packard Bell NEC Inc Trademarks Adaptec is a registered trademark of Adaptec Inc Mylex is a registered trademark of Mylex Corporation AcceleRAID 250 is a trademark of Mylex Corporation All other trademarks are the property of their respective owners Printed in the United States of America PN 904451 02 1 99 Notes Introduction These System Release Notes include general comments and advisories pertaining to your MC2200 Server General Comments The following general comment applies to this server m Versions of the Network Operating Systems tested and recommended Windows NT 4 0 Server with Service Pack 3 OS 2 WARP 4 0 m The current BIOS is Version 1 00 02 ESP16 Advisories This section contains advisories on the disk drive carrier RAID configuration drivers and on board Adaptec controllers Disk Drive Carrier When installing or removing a hard disk drive it is recommended that its carrier handle be leftin a straight outward position until either the carrier is fully seated in its connector or removed from the drive bay To move a hard disk drivein or out of a bay the outside edges of the carrier s front panel should be used System Release Notes RAID The following advisory applies to MC2200 systems that include the NEC SecuRAID 210 Mylex A2. cceleRAID 250 RAID Controller If your system includes the NEC SecuRAID 210 Mylex AcceleRAID 250 RAID controller the OS 2 RAID driver is located on the EXPRESSBUILDER CD ROM in DAC960 Software Kit V1 07 for OS 2 The GAM client and server version for OS 2 is V2 11 If your EXPRESSBUILDER is Version 2 4 you can get a later version of the OS 2 software from your vendor On Board Adaptec Controllers System Release Notes If you are running OS 2 and disable the onboard Adaptec 7880 controller the OS 2 Adaptec driver will display the following message when started Error Adapter not support by this version of the driver C0103083h This message can be ignored It is caused by the driver not being able to initialize the 7880 controller because it is disabled but not because the driver doesn t support it It doesn t effect the initialization of the onboard Adaptec 7860 controller
Download Pdf Manuals
Related Search