MMATS Professional Audio D700.2 User's Manual
Contents
1. PANEL LAYOUT Speaker amp Remote Terminals Power Fault LEDs RCA Inputs Lowpass Filter Gain 4 AWG Power Terminals SPECIFICATIONS RMS Power at 13 8V 700W into 2 ohms with less than 1 THD N S N Ratio 92db A Wtd Frequency Response lt 10 to 225Hz Lowpass Filter Variable 24db 70 to 200Hz Idle Current 1A Dimensions LxWxH 10 x 9 25 x 2 25 D70O0 2 Owner s Guide MMATS Professional Audio 867 West 13 Court Riviera Beach Fl 33404 http www mmatsproaudio com FEATURES Ultra Efficient Class D Audio Output Stage Proven Contest Winning Power Dual Regulated Pulse Width Modulated Power Supply High Capacity Heat Sink Adjustable 24db Low Pass Filter 1 Surface Mount Components Computer Optimized Transformer Large Geometry Power MOSFETs Overload and Thermal Protection SUGGESTED HOOKUP This Amplifier is optimized to run into 2 ohm loads This can be configured many ways 3 six ohm woofers 233Wrms each 2 four ohm woofers 350Wrms each 1 two ohm woofer 700Wrms each CONTROLS AND CONNECTORS Positive Power Terminal This is the power feed from the positive terminal of the car s battery Use 4 gauge cable and good quality terminals when routing this connection Tighten the connections well to prevent power loss due bad contact Route the power cable away from the RCA and speaker cables Ground Terminal For optimum performance an 4 gauge cable and good quality connectors2. should attach the this terminal to the battery s negative terminal Remote Terminal The amplifier will turn on when 12 volts is applied to this terminal This 12 volt signal is usually taken from the Power Antenna or Remote wire coming from the source unit Speaker Terminals Two pairs of and terminals are provided for ease of connecting multiple woofers It does not matter which or you use as they are connected together internally Running too low of a speaker impedance will cause the amplifier to go into a fault condition Lowpass Filter Linkwitz Riley 24db slope This control sets the 6db down point of your amplifier Higher frequencies beyond this setting are not heard from your speakers Gain Allows input levels between 150mV and 2 5 volts for full output Inputs Two RCA jacks are provided Their signals are added together inside the amplifier and the bass information is extracted Since they are summed together it does not matter which one is Left or Right
Download Pdf Manuals
Related Search