Miele Washer/Dryer 1119 User's Manual
Contents
1. 1g else is a compromise Technical Information Date June 7 2004 To Technical Service Subject Washer Dryer Stand W1113 1119 1203 1213 1215 T1302 1303 1322C 1323C 1329C 1403 1405 anything else is a compromise mo 1 t A e eo B CTE mexa 7 8 Note The washer dryer stand is designed for use with washers and dryers only Use for any other purpose may result in damage to the machine or personal injury DO NOT USE OR PLACE A STACKED WASHER AND DRYER ON THIS STAND Carry out the following steps prior to installing the stands Drawer Removal Pull the drawer out all the way Lift upward to release and remove see Fig 2 Rear Panel Removal Remove the rear panel screws Torx T20 and remove the rear panel see Fig 3 Leveling The stands must be leveled prior to installing the washer and dryer Place the stands into their locations see Fig4 Adjust the feet until the stands are level Tighten the counter nuts Note The studs for the washer are larger 17mm than the studs for the dryer 13mm anything else is a compromise Washer Stand Installation Drain the unit before laying it on its side Remove the shipping struts Lay the washer on its right side Be sure to lay the unit on a flat soft underlay i e carpet Remove the washers feet Using the threaded studs and nuts provided M10 screw 2 nuts midway onto each th2. n the nut see Fig 6 Install the caps into the open holes on the sides of the washer and dryer stand see Fig 8 Leveling Once the washer and dryer with stands are in their locations Adjust the feet until the stands are level Tighten the counter nuts Installing the Drawers Pull out the stand drawer rails as far as possible Place the drawer on the rails and close the drawer see Fig 2 e The drawer locks into position automatically when it is closed Open the drawer as far as possible then close it to check that it functions correctly
3. readed stud Screw the threaded studs M 10 into the washer and tighten them see Fig 5 Install a washer 10 2 x 32 x 2 on each threaded stud Fit the stand onto the studs Install a washer 10 5 on each threaded stud Screw a nut M 10 on each threaded stud and tighten Stand the washer upright Install the washer stand rear panel using the 4 Torx screws provided see Fig 3 Place the washer into its final position Insert the 2 rubber bushings into the side holes of the washer stand Install a washer and nut on each and tighten the nut see Fig 6 Dryer Stand Installation Drain the unit before laying it on its side Lay the dryer on its right side Be sure to lay the unit on a flat soft underlay i e carpet Remove the dryers feet Using the threaded studs and nuts provided MB screw 2 nuts midway onto each threaded stud Screw the threaded studs M 8 into the dryer and tighten them see Fig 7 Install a washer 8 5 x 30 x 2 on each threaded stud Fit the stand onto the studs Install a washer 8 4 on each threaded stud Screw a nut M 8 on each threaded stud and tighten Stand the dryer upright Install the dryer stand rear panel using the 4 Torx screws provided see Fig 3 Place the dryer into its final position being sure to line up the studs of the rubber bushings with the holes on the dryer stand Once the stands are together and in their final positions install a washer and nut onto each stud and tighte
Download Pdf Manuals
Related Search