Miele CVA 4070 EN-CA User's Manual
Contents
1. set Installation Instructions CVA 4070 en CA Installation repair and maintenance work should be performed by a Miele authorized service technician in accordance with national and local safety regulations and the provided installation instructions Electrical connection Ensure that power is not supplied to the machine while installation or maintenance work is performed All electrical work should be performed by a qualified electrician in strict accordance with national and local safety regulations Installation repairs and other work by unqualified persons could be dangerous The manufacturer cannot be held responsible for unauthorized work Verify that the voltage load and circuit rating information found on the data plate match the household electrical supply before installing the coffee system If there is any question concerning the electrical connection of this appliance to your power supply please consult a licensed electrician or contact Miele s Technical Service Department See back page for contact information WARNING THIS APPLIANCE MUST BE GROUNDED Important The coffee system comes equipped with a 6 ft 1 8 m power cord with a NEMA 5 15P molded plug for connection to a 120 V 15 A 60 Hz power supply 57 Installation Installation options The coffee system is designed to be built into cabinetry Fo x NO On i Te 0 _ Y o 3 N q A combination with oth2. e into the electrical outlet m Push the appliance into the niche m Open the door and partially tighten the screws m Carefully turn the lower screws to center the machine m To secure the appliance in the cabinet tighten the upper screws by hand Do not use an electric screwdriver 59 Installation Adjusting the door hinges The door hinges can be adjusted if the door cannot be opened easily m To adjust the door sideways turn screw m To adjust the door to the front or back turn screw 60 When contacting the Technical Service please quote the model and serial number of your appliance Miele Inc Miele Limited National Headquarters Headquarters and Showroom 9 Independence Way 161 Four Valley Drive Princeton NJ 08540 Vaughan ON L4K 4V8 Phone 800 843 7231 Phone 800 643 5381 609 419 9898 905 660 9936 Fax 609 419 4298 Fax 905 532 2290 www miele com www miele ca info miele ca general enquiries Technical Service amp Support professional miele ca commercial Nationwide enquiries Phone 800 999 1360 MieleCare National Service ras Bas pee nee Phone 800 565 6435 905 532 2272 Fax 905 532 2292 service miele ca technical enquiries Alteration rights reserved 0607 M Nr 06 911 520 02 en USA CDN CVA 4070 For the most updated manual see the Mlele Website
3. er Miele built in appliances is possible If the machine is installed in combination with other appliances it should be installed with a protective base between the appliance and the unit exception installation with a built in plate warmer A special display cabinet is also available from your dealer or Miele as an installation option Miele appliances can be installed flush or proud Discuss your installation requirements with your architect designer and installer 58 Installation Installation Make sure power is not supplied to the appliance while installation or maintenance work is performed Disconnect the power supply to the work area by unplugging the unit tripping the circuit breaker or removing the fuse The coffee system must be installed into cabinetry before being used m Unscrew the height adjustable feet on the underside of the machine about 1 16 2 mm m Push the appliance all the way back into the cabinet and center it If necessary level the unit with the four height adjustable feet The feet can be turned out up to 3 8 10 mm m f your cabinet has 3 4 19 mm side walls drill four holes for the mounting m Center the unit and turn the screws a little bit in and then out again m Take the unit out of the niche and drill four holes at the screw markings 1 16 2 mm diameter 3 16 4 5 mm m Connect the appliance to a cold water supply m Plug the applianc
Download Pdf Manuals
Related Search