Micro Technic INFORMER-MATE 81781 User's Manual
Contents
1. on control unit the seat portion of the chair Figure 6 An additional cushion may be used on top of the pad for patient or resident comfort If you use an additional cushion test the system by pressing firmly on the top of both cushions Sensor pad Mount the control unit on the chair in a convenient location with the mounting clip or mounting strap provided Figure 6 Insert the sensor pad cable into the sensor pad receptacle on the control unit If you are using the Informer Mate Deluxe system set the desired alarm tone by sliding the volume switch to position 1 2 3 or 4 If connecting a nurse call cable to the deluxe unit the alarm when sounding will automatically be sent to the nurse call unit and the local alarm will be disabled Test the Informer Mate monitoring system before each use and inspect the pads and monitor regularly to make sure they are not damaged Test the system by pressing firmly on the pad for 3 seconds When you remove pressure the alarm should sound Reset the alarm using the 2 button reset Maintenance To keep your Informer Mate control unit in good condition Do not immerse the control unit in liquid of any type The control unit will not operate properly if exposed to excessive liquids If the control unit is immersed in liquid discard it immediately Gently clean the Informer Mate control unit with non caustic cleaning agents Test your I2. 1781 81791 High Local alarm only Local alarm only Low Local alarm only Local alarm only Nurse Call Local alarm only Alert at nurse station If the Informer Mate Model 81781 is set to Nurse call the monitor defaults to Low setting Tf the Informer Mate Deluxe Model 81791 monitor is set to Nurse Call and the nurse station is not connected the monitor defaults to local alarm Battery Installation Slide open the battery cover on the back of the monitor The cover will remain attached to the monitor Insert a new 9V alkaline battery making sure to observe proper battery polarity positive to positive negative to negative Installing the Informer Mate System on a Bed AWARNING Keep the sensor pad flat at all times Folding the pad may damage it Do not use the pad if it has been folded Check for proper operation of the Informer Mate system with each mattress type used Above the mattress set up 1 Place the bed sensor pad across the width of the bed and under any sheets overlays or incontinence pads Figure 4 Placement should be under the patient or resident s buttocks area 2 2 99 overlay nformer Mate control unit Sensor Sensor wire Figure 4 2 Using the band and clip package provided with the sensor pad fasten the sensor pad to the mattress Figure 5 Make sure the sensor pad is fastened securely and lies fla
3. AYS TO 1 YEAR AS SPECIFIED TO BUYER Micro Tech is not responsible for warranty service should the Micro Tech label or logo or the serial number be removed or should the Micro Tech product fail to be properly maintained or fail to function properly as a result of misuse abuse neglect improper shipping or installation incorrect wiring not our own damage caused by disasters such as fire flood and lightning damage caused by faulty or leaking batteries not supplied by Micro Tech service other than by Micro Tech or units in use in violation of instructions furnished by Micro Tech Postage insurance or shipping costs incurred in presenting your Micro Tech product for warranty service are your responsibility THE FOREGOING WARRANTIES ARE EXCLUSIVE AND BUYER HEREBY WAIVES RELEASE AND RENOUNCES ALL OTHER WARRANTIES OBLIGATION AND LIABILITIES OF MICRO TECH AND ALL OTHER RIGHTS CLAIMS AND REMEDIES OF BUYER AGAINST MICRO TECH EXPRESS OR IMPLIED ARISING BY LAW OR OTHERWISE WITH RESPECT TO ANY NONCONFORMANCE OR DEFECT IN ITEMS OR SERVICES PURCHASED HEREUNDER INCLUDING BUT NOT LIMITED TO A ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE B ANY IMPLIED WARRANTY ARISING FROM COURSE OF PERFORMANCE COURSE OF DEALING OR USAGE OF TRADE C ANY OBLIGATION LIABILITY RIGHT CLAIM OR REMEDY IN TORT WHETHER OR NOT ARISING FROM THE NEGLIGENCE OF MICRO TECH WHETHER ACTIVE PASSIVE OR IMPUTED AND D ANY OBLIGATI
4. MICRO TECH ENTERPRISES Informer Mate Model 81781 Informer Mate Deluxe Model 81791 User Manual 800 206 1045 0163 198 G FCC ID HCQ 3B6UMXF Canada 2309 101 597 This device complies with Part 15 of the FCC rules Operation is subject to the following two conditions 1 this device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause undesired operation Changes or modifications not expressly approved by the party responsible for FCC compliance could void the user s authority to operate the equipment For Canadian customers This digital apparatus does not exceed the class A limit for radio noise emissions from digital apparatus as set out in the interference causing equipment standard entitled Digital Apparatus ICES 003 of Industry Canada All content herein is the property of The Stanley Works its Affiliates or their content suppliers and is protected by United States and international copyright laws The compilation of all content is likewise the exclusive property of The Stanley Works or the Affiliate identified in any copyright notice and is protected by United States and international copyright laws The trademarks service marks and logos the Trademarks used and displayed in this publication are registered and unregistered Trademarks of The Stanley Works its Affiliates and others Nothing herein should be construed as g
5. ON LIABILITY RIGHT CLAIM OR REMEDY FOR LOSS OF OR DAMAGE TO ANY EQUIPMENT MICRO TECH SHALL HAVE NO OBLIGATION OR LIABILITY WHETHER ARISING IN CONTRACT TORT OR OTHERWISE FOR LOSS OF USE REVENUE OR PROFIT COST OF CAPITAL COST OF SUBSTITUTE EQUIPMENT ADDITIONAL COSTS INCURRED BY BUYER BUYER S CUSTOMERS OR OTHER THIRD PARTIES FOR DAMAGES RESULTING FROM PERSONAL INJURY OR PROPERTY DAMAGE OR ANY OTHER INCIDENTAL OR CONSEQUENTIAL DAMAGES WITH RESPECT TO ANY NONCONFORMANCE OR DEFECT IN ANY ITEMS PROVIDED HEREUNDER Micro Tech Accessory amp Replacement Items MONITORS 81781 Informer Mate Monitor 81791 Informer Mate Deluxe Monitor Includes multi tone alarm and is nurse call system compatible SENSOR PAD BED 82700 30 day warranty 82708 90 day warranty 82710 1 year warranty 82715 Dark blue durable nylon cover with 1 year warranty SENSOR PAD CHAIR or WHEELCHAIR 83700 1 year warranty 83705 Dark blue durable nylon cover with 1 year warranty MISCELLANEOUS 0707 396 Nurse Call Cord for use with Deluxe model only 0034 051 Interlock Peel amp Stick Fastener 4 pc package 0141 514 Battery Cover 0707 773 Chair Mounting Strap 0120 142 Mounting Bracket included 0120 143 Wide Mounting Bracket 0707 774 Monitor Mounting strap top of unit Contact your Micro Tech distributor to order any of these products Senior Technologies a division of Stanley Security Solutions Inc Lincoln NE 68503 USA
6. The control unit will not function properly with a low battery Do not immerse the sensor pads in liquids The pad will not operate properly if the sensor pad is exposed to excessive liquids If the pad is immersed in liquid discard it immediately Description of the Micro Tech Informer Mate Series Monitoring Systems AWARNING Before installing this system please read and follow these instructions carefully Failure to do so could result in injury or death to a person in your care No device is a substitute for proper nursing care The Micro Tech Informer Mate system is designed to help reduce the risk of falls by alerting caregivers when a resident is leaving a bed chair or wheelchair Mount the monitor on the bed chair or wheelchair using one of the Micro Tech mounting brackets according to the included instructions Place a Micro Tech pressure pad on the bed chair or wheelchair according to the instructions included with the pad and attach the cord to the monitor When a resident moves from the pad an alarm sounds alerting you of a potential fall risk Monitor Design The Micro Tech Informer Mate series incorporates several important features allowing you to focus on resident care and safety while maintaining protocols The monitors feature a dual button reset feature which helps discourage resident tampering Multiple alarm notification options are available allowing you to customize alert notific
7. aregiver that a patient or resident may need assistance The Informer Mate system be defeated by a cognitively aware person a person with only a few moments of lucidity or an uncooperative person Properly assess each individual before Informer Mate system is used Resident weight may affect proper operation Models 82700 82708 82710 82715 83700 and 83705 pressure pads are not recommended for persons weighing less than 60 Ibs Keep the sensor pad flat at all times Folding the pad will damage it Do not use the pad if it has been folded Sensor pads were designed to withstand normal wear and tear but are more likely to fail and fail without warning due to prolonged use and other factors e g bending exposure to moisture punctures repeated cord pulls connector damage etc Test each pad before each use and remove it from service at any sign of damage or at the end of the stated life of the pad as labeled on it whichever comes first ACAUTION Use care when installing the Informer Mate system Gently remove or connect cords Pulling on cords may damage them and or result in system failure When putting your sensor pads into position keep the pad face up Failure to do so will result in reduced sensitivity and improper operation of your Informer Mate system Replace the battery immediately if the red low battery light on the control unit is on
8. ation for each resident each wing or any other configuration you desire Lights have been added to help you identify the monitor when in alarm condition in a crowded or dark room To help protect the monitor an integrated cushion protector and pad strain relief system have been added to protect the monitor and pad from accidental damage due to dropping or wheelchair entanglement Alert Notifications The Micro Tech Informer Mate series can be set up in multiple alarm configurations to allow you to customize the monitor to your specific resident and staff needs The monitors feature Hi Low volume control 0 or 2 second alarm delay to help prevent false alarms from resident movement and lights to alert staff to an alarm condition Additionally the Informer Mate Deluxe monitor offers multiple alarm notification tones and a nurse call jack for nurse station notification Multiple Pad Options to Fit your Specific Needs Micro Tech offers multiple pad options to allow you to customize each system to your specific patient needs Pads are available for beds chairs and wheelchairs in a variety of sizes and time length options DC Adapter 81791 only Nurse call receptacle Relief a 81791 only Figure 1 Figure 2 Battery r E Hi Lo NC Switch Alarm tone SS F selector gt aI lt ae 81791 only BH delay switch Figure 3 Alarm Mode Switch Settings Volume Setting 8
9. nformer Mate control unit and sensor pad before each use and inspect the cords controls and sensor pads for signs of damage Replace any components with signs of wear or damage immediately Never use equipment that has been damaged Call your distributor or Micro Tech at 800 206 1045 to order replacement parts To keep your sensor pads in good condition Do not immerse the pressure pad in liquid of any type The pressure pads will not operate properly if exposed to excessive liquids If the pad is immersed in liquid discard it immediately Clean soiled areas of sensor pad with a clean cloth and water or a vinyl tolerant solution Keep the pressure pad flat at all times Folding the pad will damage it Do not use the pad if it has been folded Call your distributor or Micro Tech at 800 206 1045 to order replacement parts Warranty and Disclaimer WARRANTY AND DISCLAIMER Micro Tech products are warranted to be free of manufacturing defects for a period of one year from the date of purchase If any defects covered by this Warranty appear within the above stated one year period Micro Tech will at its option repair or replace the defective component on an exchange basis with new or rebuilt parts at its expense without charge for parts or labor upon delivery of such product to Micro Tech at Buyer s expense EXCEPTION MICRO TECH PADS AND ACCESSORIES ARE WARRANTED TO BE FREE OF MANUFACTURING DEFECTS FOR PERIODS RANGING FROM 30 D
10. ranting by implication estoppel or otherwise any license or right to use any Trademark displayed herein without the prior consent of the Trademark owner Micro Tech and the Micro Tech design are some of the registered and unregistered trademarks owned by The Stanley Works and or its Affiliates Stanley Trademarks Stanley Trademarks may not be used in connection with any product or service that is not manufactured by or under license from The Stanley Works or its appropriate Affiliate Micro Tech is a trademark of Stanley Logistics Inc 2007 The Stanley Works Printed in China AWARNING Read these installation instructions thoroughly before using the Informer Mate system Failure to do so may result in injury or death to a person in your care Test the Informer Mate control unit and sensor pad before each use and inspect the cords and sensor pads for signs of damage Replace any components with signs of wear or damage immediately The Informer Mate system is only one part of your facility s fall management program The Informer Mate system is not a substitute for proper nursing care or routine visual monitoring by caregivers The effectiveness of the Informer Mate system relies entirely on an immediate response by the caregiver to the Informer Mate system alarm The Informer Mate system will not stop a person from leaving a bed or chair It is intended only to alert a c
11. t against the mattress Sensor ___ Rubber band Side mattress 8 Clip Bead of wiih mattress Figure 5 Route the sensor pad cable from the sensor pad to the control unit The cable will need to run from the top of the mattress to the underside of the bed and up the headboard footboard or rail of the bed Figure 4 Make sure the cable lies freely and does not interfere with handrails or moving parts of the bed Mount the control unit on the bed headboard footboard or rail in a convenient location using the mounting strap or mounting bracket Optional wide mounting brackets are available for extra wide headboards and footboards Insert the sensor pad cable into the sensor pad receptacle on the control unit If you are using the Informer Mate Deluxe system set the desired alarm tone by sliding the volume switch to position 1 2 3 or 4 If connecting a nurse call cable to the deluxe unit the alarm will when sounding automatically be sent to the nurse call unit and the local alarm will be disabled Test the Informer Mate monitoring system before each use and inspect the pads and monitor regularly to make sure they are not damaged Test the system by pressing firmly on the pad for 3 seconds When you remove pressure the alarm should sound Reset the alarm using the 2 button reset Installing the Informer Mate System On a Chair Chair setup Informer Mate 1 Place the chair sensor pad
Download Pdf Manuals
Related Search