Metra Electronics 95-8224 User's Manual
Contents
1. Gray 12V Batt Memory Yellow Right Front Gray Black Ground Black Left Front White Power Antenna Blue Left Front White Black Amp Turn On Blue White Right Rear Violet Amp Ground Black White Right Rear Violet Black Illumination Orange Left Rear Green A Orange White Left Rear Green Black NOTE When a Black wire is not present ground radio to vehicle chassis All colors may not be present on all leads due to manufacturer s specifications 4 5 5 RSS NOTES 95 5224 INSTRUCTIONS ee A 1 800 221 0932 La www metraonline com REV 04 27 10 COPYRIGHT 2004 2010 METRA ELECTRONICS CORPORATION INST95 82242. INSTALLATION INSTRUCTIONS FOR PART 95 8224 APPLICATIONS Toyota Matrix 2009 10 Pontiac Vibe 2009 10 Excluding Factory Navigation Models 95 8Pp4 KIT FEATURES e Double DIN Radio Provision e Stacked ISO Mount Units Provision KIT COMPONENTS e A Double Din Trim Plate B Double DIN Brackets Harness amp Antenna Connections sold separately e 70 1761 Toyota Harness 87 up TOOLS REQUIRED Small Flat Blade Screwdriver Panel Removal Tool e Socket Set A 1 800 221 0932 2 www metraonline com COPYRIGHT 2010 METRA ELECTRONICS CORPORATION Vs su TABLE OF CONTENTS Dash Disassembly Toyota Matrix Pontiac Vibe 2009 10 7 Kit Preparation ica AAA 2 Kit Assembly Double DIN Radio Provision 3 Stacked ISO Mount Units Provision 3 Final Assembly cocer rd 4 Note Refer also to the instructions included with the aftermarket radio Le A 95 8224 DASH DISASSEMBLY Toyota Matrix Pontiac Vibe 2009 10 1 Disconnect the negative battery ter minal to prevent an accidental short circuit 2 Unclip and remove the radio trim panel including the a c vent Figure A 3 Remove 4 10 MM bolts securing the radio Unplug and remove the radio Figure B Continue to kit preparation LEE 25 5224 KIT PREPARATION DOUBLE DIN RADIO PROVISION STACKED ISO MOUNT UNITS Note Refer also to th
3. e instructions included with the aftermarket radio A 1 Snap the Double DIN Trim plate into the rear of the factory radio trim panel Figure A Continue to kit assembly LEZ 95 8224 KIT ASSEMBLY DOUBLE DIN RADIO PROVISION STACKED ISO MOUNT UNITS PROVISION Note Refer also to the instructions included with the aftermarket radio 1 Attach the Double DIN brackets to the Double DIN or the stacked ISO mount unit s using the screws supplied with the unit s Figure A Continue to final assembly LE A 25 9224 FINAL ASSEMBLY FINAL ASSEMBLY A Strip wire ends back 1 2 B Twist ends together C Solder D Tape 1 Locate the factory wiring harness in the dash Metra recommends using the proper mating adapter and making connections as shown Isolate and individ ually tape off the ends of any unused wires to prevent electrical short circuit 2 Re connect the negative battery terminal and test the unit for proper operation 3 Reassemble radio and dash assemblies in reverse order of disassembly FINAL WIRING CONNECTIONS Make wiring connections using the EIA color code chart shown below and the instructions included with the head unit Metra recommends making connections as shown below Strip Splice Solder Tape Isolate and individually tape off ends of any unused wires to prevent electrical short circuit METRA EIA WIRING CODE 12V Ignition Acc Red Right Front
Download Pdf Manuals
Related Search