Metra Electronics 95-7326 User's Manual
Contents
1. Figure A TIP The smoother the cut the better gt N the 95 7326 will look in the dash panel CUT OUT BAR 2 Snap the Double DIN brackets to the inside edge of the Double DIN trim j plate Figure B Slide the Double DIN radio into bracket trim plate assembly and secure the radio to the assembly using the screws supplied with the radio Figure C Continue to final assembly 3 Slide the stacked ISO units into 95 7326 KIT ASSEMBLY STACKED 150 MOUNT UNITS PROVISION Note Refer also to the instructions included with the aftermarket radio 1 Cut and remove the bar in the factory radio trim panel Figure A TIP The smoother the cut the better the 95 7326 will look in the dash panel 2 Snap the Double DIN brackets to the inside edge of the Double DIN trim plate Figure B iL I bracket trim plate assembly and secure the units to the assembly using the screws supplied with the units Figure C Continue to final assembly 93 7326 FINAL ASSEMBLY FINAL ASSEMBLY A Strip wire ends back 1 2 B Twist ends together C Solder D Tape 1 Locate the factory wiring harness in the dash Metra recommends using the proper mating adapter and making connections as shown Isolate and individ ually tape off the ends of any unused wires to prevent electrical short circuit 2 Re connect the negative battery terminal and test the unit2. INSTALLATION INSTRUCTIONS FOR PART 95 7326 APPLICATIONS Hyundai Elantra 2007 2010 US Model Only Non Radio Delete Non Touring Model 95 7326 KIT FEATURES Double DIN Radio Provision Stacked 150 Mount Units Provision KIT COMPONENTS A Double DIN Trim Plate B Double DIN Brackets TOOLS REQUIRED Small Flat Blade Screwdriver Panel Removal Tool Phillips Screwdriver SN N 1 800 221 0932 www metraonline com COPYRIGHT 2010 METRA ELECTRONICS CORPORATION 22222 95 7326 TABLE OF CONTENTS Dash Disassembly Hyundai Elantra 2007 2010 1 Kit Assembly Double DIN Radio Provision 2 Stacked ISO Mount Units Provision 3 ii FE Od IET TT TI FFF rarr FFAN 4 Note Refer also to the instructions included with the aftermarket radio SS e 95 7326 DASH DISASSEMBLY HYUNDAI ELANTRA 2007 2010 1 Disconnect the negative battery ter minal to prevent an accidental short circuit 2 Unclip and remove the panel sur rounding the radio including the a c vents and hazard button Figure A 3 Remove 4 Phillips screws to remove radio Figure B Continue to kit assembly 95 7326 KIT ASSEMBLY DOUBLE DIN RADIO PROVISION Note Refer also to the instructions included with the aftermarket radio 1 Cut and remove the bar in the factory radio trim panel
3. for proper operation 3 Reassemble radio and dash assemblies in reverse order of disassembly FINAL WIRING CONNECTIONS Make wiring connections using the EIA color code chart shown below and the instructions included with the head unit Metra recommends making connections as shown below Strip Splice Solder Tape Isolate and individually tape off ends of any unused wires to prevent electrical short circuit EIA WIRING CODE 12V Ignition Red 12V Yellow DO Black Power Antenna Blue Turn On Blue White Amp Ground Black White Illumination Orange i LL Orange White Right Front Gray Right Front Gray Black Left Front White Left Front White Black Right Rear Violet Right Rear Violet Black Left Rear Green Left Rear Green Black NOTE When a Black wire is not present ground radio to vehicle chassis All colors may not be present on all leads due to manufacturer s specifications 4 TF 95 7326 m Lil VS NOTES 95 7326 INSTRUCTIONS 1 800 221 0932 www metraonline com REV 4 27 10 COPYRIGHT 2010 METRA ELECTRONICS CORPORATION INST95 7326
Download Pdf Manuals
Related Search