Makita ML900 User's Manual
Contents
1. Turn the ring counterclockwise and remove the ring reflector and bulb together Pull the bulb holder out of the reflector Pull the bulb out of the bulb holder after turning the bulb slightly clockwise To install a new bulb follow the re moval procedure in reverse There Bulb holder are three notches in the bulb holder Set the bulb in the center notch Set the bulb here CAUTION e Replacement light bulbs are readily available from your Makita dealers or Makita Authorized or Factory Service Centers Always specify bulb type 9 6 V 500 mA e Never attempt to short the bulb using tweezers metal tools etc Cleaning Use a cloth dampened in a mild detergent to clean off the flashlight from time to time Then wipe dry with a dry cloth Benzine thinner and other volatile agents will damage the plastic so never use them To maintain product SAFETY and RELIABILITY repairs maintenance and adjustment should be perfomed by Makita Authorized or Factory Service Centers always using Makita replacement parts OPTIONAL ACCESSORIES The accessories listed in this manual are available at an extra cost from your Makita Distributor or Makita Factory Service Center Service centers are listed on the warranty card packed with your tool e Signal cap e Lanyard set e Strap Recycling the battery The only way to dispose of a Makita battery is to recycle it OY The law prohibits any other method of disposal T2. Ve ads Rechargeable Flashlight MODEL ML900 INSTRUCTION MANUAL SPECIFICATIONS Makita battery cartridge 9000 9 6 V Rocker type 84 mm x 273 mm 260g rechargeable Ni cd 500 mA ON OFF i 3 1 4 x 10 3 4 0 6 Ibs Manufacturer reserves the right to change specifications without notice Note Specifications may differ from country to country Installing or removing battery cartridge NOTE Before operation charge the battery cartridge with Makita 9 6 V Fast charger To insert the battery cartridge pull out the set plate align the tongue i on the battery cartridge with the Battery cartridge groove in the flashlight handle and Rg slip it into place Snap the set plate back into place Be sure to close the set plate fully before using the flash light Set plate Switch action To turn the flashlight on press the ON side of the switch Press the OFF side to turn it off Switch E re Condensing or dispersing light To cast a wide beam turn the knob so that the pointer points to the C marking For a narrow spotlight beam turn the knob so that the pointer points to the marking Stand The stand allows the flashlight to be positioned at a convenient up ward angle MAINTENANCE CAUTION Always be sure that the flashlight is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance Replacing light bulb
3. o recycle the battery amp amp 1 Remove the battery from the tool 2 a Take the battery to your nearest Makita Factory Service Center Ni Cd or b Take the battery to your nearest Makita Authorized Service Center or Distributor that has been designated as a Makita battery recycling location Call your nearest Makita Service Center or Distributor to determine the location that provides Makita battery recycling See your local yellow pages under Tools Electric Makita Corporation of America Buford GA MCA 4 93 883565C067 PRINTED IN USA 1995 8 4D
Download Pdf Manuals
Related Search