Linear RE-BWC1 User's Manual
Contents
1. are valid only until Warranty Expiration Date as labeled on the product This Linear LLC Warranty is in lieu of all other warranties express or implied All products returned for warranty service require a Return Product Authorization Number RPA Contact Linear Technical Services at 1 800 421 1587 for an RPA and other important details Copyright 2007 Linear Corporation 227793 A2. RE BWC1 Black amp White CCTV Camera Installation Instructions Linear 760 438 7000 USA amp Canada 800 421 1587 amp 800 392 0123 Toll Free FAX 800 468 1340 www linearcorp com 2 MOUNT THE CAMERA SECURE THE CAMERA ASSEMBLY WITH TWO SCREWS IMPORTANT TO PREVENT INTERNAL INFRARED LIGHT FROM ENTERING THE CAMERA BE SURE THE FOAM GASKET AROUND THE CAMERA S LENS PRESSES FIRMLY AGAINST THE RE 1 S FACEPLATE 5 CONNECT CAMERA CABLE PLUG THE CAMERA CABLE INTO THE CAMERA S JACK AND THE RE 1 S CAMERA JACK CAMERA CABLE FROM CAMERA S JACK PRODUCT DESCRIPTION Linear s Model RE BWC1 P N ACP00886A CCTV camera can be installed inside the RE 1 Entry System The camera provides a video signal for viewing the area in front of the entry system The camera is continuously powered by the RE 1 The camera s infrared light emitters illuminate the area directly on front of the entry system for nighttime or low light operation The camera focus has been factory adjusted to a range of three to four feet The RE 1 CAMERA jack is used to connect the camera to the main circuit board with the single ended modular cable supplied with the camera This cable routes power to and video from the camera The RE 1 VIDEO jack is for connection to a video cable with a Type BNC connector Up to 300 feet of 75 ohm RG 59 video cable can be used Longer cable runs may require the use of a video amplifier NOTE If ca
3. mera is being installed on an existing installation power must be off prior to removing circuit board 3 CONNECT LIGHTING POWER INSERT WIRING HARNESS PLUG INTO THE 2 PIN LIGHTING CONNECTOR 6 CONNECT VIDEO CABLE CONNECT THE VIDEO CABLE FOR THE MONITOR TO THE RE 1 S VIDEO OUTPUT CONNECTOR a N 1 REMOVE CIRCUIT BOARD DISCONNECT THESE TWO CONNECTORS REMOVE CIRCUIT REMOVE THESE 4 SCREWS 4 REPLACE CIRCUIT BOARD RECONNECT THESE TWO CONNECTORS REPLACE CIRCUIT BOARD SECURE WITH 4 SCREWS LINEAR LIMITED WARRANTY This Linear product is warranted against defects in material and workmanship for twenty four 24 months The Warranty Expiration Date is labeled on the product This warranty extends only to wholesale customers who buy direct from Linear or through Linear s normal distribution channels Linear does not warrant this product to consumers Consumers should inquire from their selling dealer as to the nature of the dealer s warranty if any There are no obligations or liabilities on the part of Linear LLC for consequential damages arising out of or in connection with use or performance of this product or other indirect damages with respect to loss of property revenue or profit or cost of removal installation or reinstallation All implied warranties including implied warranties for merchantability and implied warranties for fitness
Download Pdf Manuals
Related Search