Lightolier C4CEX User's Manual
Contents
1. LEAD Use wire nuts ee ee x NNER BANAST local hardware items Place wire nuts into outlet box Pa NS ASSEMBLY STEP 5 Install BALLAST SUPPORT onto MOUNTING PLATE _ REFLECTOR secure with threaded CAP NUTS DO NOT OVER TORQUE STEP 6 Install lamp Use only T4 5 metal halide lamp with G8 5 h tn base a LAMP BARRIER STEP 7 Install LAMP BARRIER into the INNER GLASS assembly E O __ INNER GLASS and secure with RETAINING SPRING STEP 8 Attach the INNER GLASS assembly to the REFLECTOR by lining up the pins on the REFLECTOR and the slots on the INNER GLASS assembly and turn clockwise until tight STEP 9 Install OUTER GLASS by positioning over the INNER B a BALLAST ASSEMBLY and secure with three set screws STEP 10 Position REFLECTOR HOUSING onto center stud secure it with LOCK UPPER HOUSING STEP 11 Slide the UPPER HOUSING over the OUTER GLASS and attach to the INNER BALLAST ASSEMBLY Secure by twisting the housing clockwise until tight CAUTION DO NOT ENERGIZE ma S THE LAMP UNTIL THE FIXTURE NFAY IS COMPLETELY ASSEMBLED Cae AND INSTALLED LIGHTOILHER 6 Airport Road Fan River MA 02720 READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE INSTRUCTION SHEET NO This fixture is intended for installation in accordance with the National Electrical Code and local regulation2. READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE INSTRUCTION SHEET NO This fixture is intended for installation in accordance with the National Electrical Code and local regulations To assure full compliance with local codes and regulations check with your local electrical inspector before IS CAC EX installation To prevent electric shock turn off electricity at fuse box before proceeding E Retain these instructions for maintenance reference A0604 Paqe 1 of 2 INSTALLATION PROCEDURE FOR C4CEX EXPO SERIES H I D SURFACE CYLINDER STEP 1 Screw OUTLET BOX SCREWS not provided to 4 octagon outlet box leaving about 4 space for engaging the MOUNTING PLATE STEP 2 Pass supply wires into large wire way hole of MOUNTING E OUTLET BOX PLATE N SCREWS STEP 3 Position key slots in MOUNTING PLATE onto the heads B Lag MOUNTING PLATE of OUTLET BOX SCREWS shift housing into place and secure by JY NI BALLAST tightening the screws firmly Ae a SUPPORT CAP NUTS STEP 4 Make Connections Bare Copper and or green insulation LI _ wire s must be connected to SUPPLY GROUND Connect WHITE AN BALLAST LEAD to NUETRAL WHITE SUPPLY LEAD Connect Ca a BLACK BALLAST LEAD to HOT SUPPLY
3. s To assure full compliance with local codes and regulations check with your local electrical inspector before IS g C4C EX installation To prevent electric shock turn off electricity at fuse box before proceeding m Retain these instructions for maintenance reference A0604 Page 2 of 2 INSTALLATION PROCEDURE FOR EXPO ROD TRIM KIT CAT NO CAEXPT H I D SURFACE CYLINDER NOTE EXPO Rod Trim Kit can be installed without detaching outer glass en STEP 1 Install ROD into threaded hole in EXPO DECORATIVE A EXPO CYLINDER repeat with the other two rods Make sure rods are all lt J i DECORATIVE CYLINDER the way In es Nf CAT NO C4CEX SERIES STEP 2 Align bottom end of RODS with holes in GLASS DISC position GLASS DISC onto the bottom lip of OUTER GLASS then secures with LOCK NUTS aa OUTER GLASS RODS GLASS DISC a LOCK NUTS COMPLETED LIGHTOIL HER eetaiportrcaa Fal River ma 02720
Download Pdf Manuals
Related Search