Lightolier IS:3651 User's Manual
Contents
1. INSTRUCTION SHEET NO INSTRUCTIONS FOR ASSEMBLING AND INSTALLING FIXTURE IS z 3 6 5 1 RO786 READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE This fixture is intended for installation in accordance with the National Electrical Code and local or federal code specifications To prevent electrical shock turn off electricity at fuse box before proceeding Retain these instructions for reference CAUTION For wet locations in accordance with Underwriters Laboratories requirements a line of caulking compound such as acrylic latex or butyl must be placed around the back of the fixture to seal water away from the outlet box and back openings 1 Disassemble fixture by removing two SCREWS and proceed as follows 2 Thread NIPPLE into CROSSBAR 3 Secure CROSSBAR to OUTLET BOX with BOX SCREWS provided in OUTLET BOX 4 Make connections Black fixture lead or fixture lead without tracer mark to black supply lead white fixture lead or fixture lead with tracer mark to white supply lead Attach bare GROUND WIRE to outlet box grounding screw or otherwise attach to system ground Use WIRE NUTS local hardware item Place connections in OUTLET BOX 5 Position fixture over NIPPLE against wall Secure with KNOB fixture must be mounted so SOCKET is at bottom of fixture If auxiliary mounting holes in back are required they must be provided on site to match fastener used Fit recommended BULB into SOCKET2. Position GUARD and DIFFUSER with GASKET over CHASSIS as shown Secure with two SCREWS CAUTION MAXIMUM WATTAGE MARKED ON FIXTURE MUST NOT BE EXCEEDED MOUNTS HORIZONTALLY OR VERTICALLY ON WALL ONLY BULE KNOB GASKET N A CROSSBAR OUTLET BOX p GUARD CONFIGURATION VARIES WITH MODEL NUMBER BOX SCREW NIPPLE GROUND WIRE WIRE NUT OES eo cea CHASSIS SOCKET BULB TYPE VARIES WITH MODEL NUMBER DIFFUSER SEE BACK PAGE FOR ALTERNATE COMPACT FLUORESCENT LAMP INSTALLATION E Ics i 1 Ol i ee NEW JERSEY 07096 0508 B f m S MONTREAL QUEBEC CANADA 1 3651 R0786 LAMPING FIG A REMOVE GUARD AND DIFFUSER BY UNSCREWING TWO SCREWS Line up pins on lamp with socket and push in To relamp simply pull straight out No polarity of pins required NOTE Lamp requirement instructions for fluorescent fixtures using 7W or SW PL or TT NOTE 7W rated at 0 F QW rated at 25 F PL by North American Philips TT Twin Tube by Sylvania Dulux by Osram
Download Pdf Manuals
Related Search