Lightolier IS:23S39T6 User's Manual
Contents
1. A reflector and glass lens must always be used Do not operate with accessory holder in open position Lamps are sold separately INSTRUCTIONS FOR ATTACHING LUMINAIRE TO TRACK 1 Turn off power to TRACK and put SWITCH in off position 2 Insert luminaire intoTRACK as shown in FIG 1 The STEM must be on the same side as the BEAD 3 Rotate BALLAST HOUSING clockwise 90 pull BALLAST HOUSING away from TRACK enough for LEVER to clear TRACK 4 Turn LEVER to position shown in FIG 2 to mechanically secure BALLAST HOUSING 5 Do not turn the SWITCH to on position unless LAMP and accessory holder are properly installed See instructions on page 2 6 TO REMOVE Turn LEVER lightly pull down BALLAST HOUSING and rotate counterclockwise FOR OFF SWITCH TRACK LEVER GR a ay BEAD BRASS UJ CONTACT BALLAST E S FIG 1 HOUSING STEM FIG 4 INSTRUCTIONS FOR CONVERTING LUMINAIRE TO OPERATE ON 2 CIRCUIT ADVENT TRACK FIG 3 ADVENT TO POWER ON UPPER CIRCUIT TRACK 1 Raise BRASS CONTACT to high position by pulling CONTACT as high UPPER NEUTRAL as stop permits See FIG 4 CIRCUIT CIRCUIT 2 Follow instructions above for installing into track LOWER TO POWER ON LOWER CIRCUIT CIRCUIT 1 Ensure CONTACTS are at the same level Push down BRASS contact if needed FIG 3 2 Follow instructions above for installing into track 631 Airport Road Fall River MA 02720 508 679 8131 Fax 52. SCREWS 3 Turn power on to track cuircuit 4 Place SWITCH to ON position HEXCELL LOUVER RETAINING FIG 6 RING ACCESSORY ACCESSORY HOLDER HOLDER REFLECTOR RETAINING T6 G12 BASE TA o N ROTATION HEX KEY SET SCREW FIG 8 631 Airport Road Fall River MA 02720 508 679 8131 Fax 508 674 4710 We reserve the right to change details of design materials and finish www lightolier com 2008 Philips Group A0508 Lightolier is a Philips group brand PH ILI PS
3. 08 674 4710 We reserve the right to change details of design materials and finish www lightolier com 2008 Philips Group A0508 Lightolier is a Philips group brand PHILI PS ICSI TCL HER Instruction Sheet Number IS 23S39T6 Page 2 of 2 INSTRUCTIONS FOR LAMPING 1 Turn off power to TRACK and put SWITCH in off position Ci 2 Open ACCESSORY HOLDER by turning KNOB FIG 5 KNOB 3 Place REFLECTOR in LUMINAIRE and secure by snapping RETAINING RING in GROOVE 4 Install proper lamp type and wattage as specified on luminaire lamp label INSTRUCTIONS FOR INSTALLING OPTIONAL ACCESSORIES FIG 7 1 Remove ACCESSORY RETAINING RING 2 Place accessories into ACCESSORY HOLDER FIG 5 3 Secure accessories with ACCESSORY RETAINING RING Note Luminaire accepts 3 accessories max Two glass lenses and snoot ACCESSORY or One Louver one glass lens and snoot If Louver is used position HOLDER louver furthest from lamp DO NOT OPERATE WITHOUT GLASS LENS ACCESSORY OR ACCESSORY HOLDER IN OPEN POSITION ne INSTRUCTIONS FOR OPERATING LUMINAIRE as 1 Close ACCESSORY HOLDER on Luminaire and tighten KNOB FIG 5 2 Adjust VERTICAL and HORIZONTAL aim FIG 8 GLASS Note vertical and horizontal rotation have mechanical stops LENS and locking feature Do not force past stop If aim is locked loosen SET SCREWS Note Horizontal and Vertical aiming can be locked To lock tighten SET SCREWS with hex key by others To unlock loosen SET
4. LIGHTOIL HER Instruction Sheet Number IS 23S39T6 Page 1 of 2 Read and understand these instructions before installing luminaire fixture This luminaire is intended for installation in accordance with the National Electrical Code and local regulations To assure full compliance with local codes and regulations check with your local electrical inspector before installation To prevent electrical shock turn off electricity at fuse box before proceeding Allow fixture to cool before handling Retain these instructions for maintenance reference INSTRUCTIONS FOR INSTALLING AND OPERATING 23S39T6 23S70T6 ALCYON HID LUMINAIRES FOR USE WITH LIGHTOLIER LYTESPAN TRACK SYSTEMS ONLY Compatible with ceiling wall and suspended mounted track Compatible with multipoint 23839T6 compatible with monopoint 6172 23S70T6 compatible with monopoint 6173 Sold separately Compatible with reflectors MHT6RS MHT6RNF MHT6RF Sold separately Compatible with AF4 AL4HC and 23SNT6 accessories Sold separately Not compatible with 6170 and 6190 monopoints extension wands clamp on monopoint weighted base sloped ceiling adapter Atom pro spec track CAUTION HOT SURFACE Keep away from curtains and any other combustible materials CAUTION DO NOT OPERATE ON A DIMMING CIRCUIT CAUTION Turn power off and allow fixture to cool before handling CAUTION Use only lamp types and wattages specified on the luminaires lamp label CAUTION
Download Pdf Manuals
Related Search