Life Fitness Upright Exercise Bike User's Manual
Contents
1. EWS A Tighten the MOUNTING SCREWS securely NOTE BE CAREFUL NOT TO PINCH ANY WIRES WHEN INSTALLING THE DISPLAY CONSOLE B TO THE DISPLAY CONSOLE MOUNTING PLATE C M051 00K63 A029 N2. Life Fitness Upright Exercise Bikes How To INSTALL THE POLAR KIT Tools Required Phillips screwdriver T 45 Torx wrench T 20 Torx wrench 1 Remove the four MOUNTING SCREWS A securing the DISPLAY CONSOLE B to the DISPLAY CONSOLE MOUNTING BRACKET C Set the MOUNTING SCREWS aside 2 Carefully raise the DISPLAY CONSOLE B off of the DISPLAY CONSOLE MOUNTING BRACKET C Disconnect all CONNECTORS D from the back of the DISPLAY CONSOLE Set the DISPLAY CONSOLE aside 3 Remove the four MOUNTING SCREWS E securing the FRONT POLAR CAP F to the REAR POLAR CAP G Remove the FRONT POLAR CAP and set it and the four MOUNTING SCREWS aside Slide the REAR POLAR CAP down the MONOCOLUMN H until it rests on the CONSOLE EXTENSION TUBE J 4 Remove the four MOUNTING SCREWS K securing the HANDLEBARS L to the MONOCOLUMN H Set the MOUNTING SCREWS aside 5 Carefully remove the HANDLEBARS L from the MONOCOLUMN H Disconnect the HEART RATE CABLE CONNECTOR if equipped Set the HANDLEBARS aside NOTE BE CAREFUL NOT TO PULL ON THE HEART RATE CABLE Locate the L BRACKET CABLE ASSEMBLY M and the two WELLNUTS N Insert the two WELLNUTS into the two open holes on the L BRACKET as shown Feed the L BRACKET CABLE ASSEMBLY M 3 PIN CONNECTOR end first into the MONOCOLUMN H and up through the CONSOLE EXTENSION TUBE J access hole Align the L BRACKET M with the mounting holes located on th
3. e bottom side of the MONOCOLUMN near the top most end of the MONOCOLUMN H The POLAR RECEIVER JACK should face the inside of the MONOCOLUMN Secure the L BRACKET using the two supplied MOUNTING SCREWS 0 NOTE CAREFULLY GRIP THE WELLNUTS N INSIDE THE MONOCOLUMN H TO ENSURE THE WELLNUTS DO NOT SPIN UPON TIGHTENING THE MOUNTING SCREWS O 9 Carefully replace the HANDLEBARS L in reverse order of removal Re connect the HEART RATE CABLE if equipped Tighten the four SCREWS K to 28 32 ft lbs NOTE BE CAREFUL NOT TO PINCH ANY WIRES WHEN INSTALLING THE HANDLEBARS L 10 Slide the foam POLAR RECEIVER COVER P over the POLAR RECEIVER Q Note the red dot on the POLAR RECEIVER Insert the POLAR RECEIVER PLUG into the POLAR RECEIVER JACK of the L BRACKET CABLE ASSEMBLY M Position the POLAR RECEIVER with the red dot facing upward 11 Slide the REAR POLAR COVER G up to meet the HANDLEBARS L Position the FRONT POLAR CAP F over the REAR POLAR CAP and secure using the four previously removed SCREWS E NOTE THE LOGO ON THE FRONT POLAR COVER F MUST BE FACING UPWARD FOR CORRECT FRONT POLAR CAP ORIENTATION 12 Connect all CONNECTORS D leading from the CONSOLE EXTENSION TUBE J access hole to the back of the DISPLAY CONSOLE B Carefully place the DISPLAY CONSOLE onto the DISPLAY CONSOLE MOUNTING PLATE C Secure the DISPLAY CONSOLE to the DISPLAY CONSOLE MOUNTING PLATE using the four previously removed MOUNTING SCR
Download Pdf Manuals
Related Search