Life Fitness TR9100 User's Manual
Contents
1. Life Fitness Model TR9700 TR9500 TR9100 Treadmills How To Replace or Install Rear Roller Guards Tools Required Philips Screwdriver NOTE The following steps are applicable to units with Configuration No 1 Rear Roller Guards 1 Remove the Screws securing the Rear Roller Guard Assembly to the Frame Cover Guard Screw Roller Guard RT Roller Guard LT Grommet Configuration No 1 2 Remove the old Grommets from the Rear Roller Welded Guard Tab and Base Frame model specific 3 Install the new Grommets included in kit in the Rear Roller Guard Weldment and Base Frame locations 4 Place new Roller Guard in position as shown with the top surface under walking belt Align mounting holes Roller Guard to be located between belt and deck Align mounting holes with grommet holes Life Fitness Model TR9700 TR9500 TR9100 Treadmills How To Replace or Install Rear Roller Guards 5 Install Screws and fasten securely Approx 22 37 in Ibs Secure Mounting Screws 6 Repeat steps for opposite side After completion run treadmill and check for interference or binding If needed loosen Mounting Screws re align Guard and refasten securely Life Fitness Model 97Ti 95Ti 93T Treadmills How To Replace or Install Rear Roller Guards Tools Required Philips Screwdriver Flat Blade Screwdriver NOTE The following steps are applicable to units with Configuration No 2 Rear Roller Guards 1 Remove exi2. sting Roller Guard by unscrewing mounting screws on top and base of frame Mounting Screws 2 With flat blade screwdriver remove Grommet and Washer discard old washer and re install the grommet Use caution to prevent injury or damage to paint NOTE Do not replace washer Having a washer and the grommet will raise the guard too high and cause rubbing against the belt resulting in premature wear and reducing belt life 3 Remove the Base s Lower Head Grommet for the base bottom hole and move to the upper hole in the Base Frame Life Fitness Model 97Ti 95Ti 93T Treadmills How To Replace or Install Rear Roller Guards Continued 4 Place new Roller Guard in position shown with top surface under walking belt Align mounting holes Roller Guard to be located between belt and deck Align mounting holes with grommet holes 5 Install Screws and fasten securely Approx 22 37 in Ibs 6 Repeat steps for opposite side After completion run treadmill and check for interference or binding If needed loosen Mounting Screws re align Guard and refasten securely Secure Mounting Screws M051 00K58 A128
Download Pdf Manuals
Related Search