Lenmar Enterprises BCV636 User's Manual
Contents
1. OmniSource SVC Model BCV636 Universal Charger Conditioner for 8mm amp VHS C Camcorders Including Sharp 3 6 Volt Viewcam Batteries PLEASE READ THE INFORMATION AND FOLLOW ALL INSTRUCTIONS THOROUGHLY BEFORE USING THIS PRODUCT Introduction The OmniSource SVC BCV636 is a fully automatic camcorder battery charger conditioner which is compatible with almost any 6 volt battery for 8mm and VHS C camcorders from Sharp Sony Canon JVC Panasonic RCA and other manufacturers By using the adapter plates included you can also charge the Sharp Viewcam 3 6 volt Ni Cd Ni MH or Li Ion batteries The BCV636 uses a microprocessor controlled charging circuit which provides a safe full charge every time Also Ni Cd batteries can be properly discharged and reconditioned with the push of a button Charging Full Charge and Conditioning status is shown with built in LED indicators Flexible power input allows you to use the BCV636 from home with its AC Power Supply or on the road using the DC Cigarette Lighter Adapter included Avoid prolonged use in an automobile when the engine is not running as it may drain the battery in the vehicle Operation 1 Plug in either the AC 110V or the DC Cigarette Lighter power adapter depending on where you are going to use your OmniSource SVC Connect the other end of the power adapter cable to the power input socket on the charger unit 2 6 volt batteries will slide directly onto the charger unit makin2. g sure the contacts on the battery are aligned with the appropriate contacts on the charger for your camcorder battery type For 3 6 volt Sharp camcorder batteries choose the adapter plate for the Li Ion Lithium Ion type batteries or the adapter plate for the Ni Cd Ni MH type batteries Attach the proper adapter plate to the charger unit then slide the battery to be charged onto the adapter plate 3 Once the battery has been properly connected to the charger unit the Red LED CHG indicator will light up to indicate that this unit has begun to charging your battery When the battery is fully charged the Red LED will turn off and the Green LED FULL indicator will turn on Remove the battery from the charger 4 If you wish to condition your battery to eliminate minor memory problems or refresh a stale battery and restore lost capacity push the button in the lower right hand corner of base unit The Red LED will go out and the Yellow LED DIS will begin to flash while the battery is discharged to the proper voltage As soon as the battery is properly discharged the circuit will automatically switch back to charging mode and begin to charge your battery Note Conditioning or fully discharging batteries is recommended ONLY for a partially charged discharged Ni Cd type batteries Ni MH batteries may also benefit from an occasional conditioning cycle DO NOT attempt to condition Li Ion type batteries Cautions e Do not leave the battery on con
3. ge should include evidence of date and place of purchase Enclose 10 00 for shipping and handling for addresses in the U S For outside the U S and Canada freight will vary depending upon ship to address Visit our web site at www Lenmar com 202 172
4. nected to the charger for prolonged periods several days Remove the battery after charge is complete Unplug the charger when not in use Do not use place or store the charger where it may come into contact with water or moisture Always replace frayed or damaged wire and broken plugs immediately Use this charger with the AC adapter included in the package only It is not necessary or recommended to discharge a Li Ion prior to charge Note Batteries will self discharge when not in use whether they are attached to a camcorder or not Batteries can be kept fresh if you do not let them sit idle for more than two months without recharging Trouble Shooting Tips If the Red LED CHG indicator does not light up when the charger is plugged with power and battery has been attached the battery contacts may not be touching contacts on base unit Unplug the unit and check connection of the battery to the charger If adapter plate is being used check its connection as well Use a clean dry cloth when necessary to keep the metal contacts of both charger and battery clean If a Ni Cd or Ni MH battery sits idle for a too long a period of time conditioning may be necessary Press the discharge button to discharge the battery prior to charging it and repeat for 2 3 cycles to refresh the battery If the battery is still not working properly the battery may need to be replaced The following statement is required in the state of California pu
5. rsuant to the settlement of an action brought by the Mateel Environmental Justice Foundation against multiple electronics and appliance manufacturers WARNING Handling the cord on this product will expose you to lead a chemical known to the state of California to cause birth defects or other reproductive harm Wash hands after handling Battery Charge Times Battery Capacity Approx Chg Time 1200 mAh 80 minutes 1800 mAh 125 minutes 2400 mAh 170 minutes 3600 mAh 255 minutes Specifications Power Input 12 18 VDC 800 1000 mA Avg Charge Current 890 mA Avg Discharge Current 350 mA Discharge Cutoff 1 0 volt per cell Charge Control AV Max V Max Time 360 min Limited 3 Year Warranty This limited warranty starts from the date of original purchase and expires 3 years thereafter If any part because of manufacturing defects or workmanship fails to function properly under normal use will be repaired at no charge for parts and labor or at our option the product will be replaced The following is excluded damages from delay or loss of use of equipment or damaged batteries malfunctions resulting from misuse tampering unauthorized repairs modifications or accident Package the unit and its accessories carefully using ample padding material to prevent damage in transit and ship it prepaid and insured to LENMAR ENTERPRISES INC USA 4035 Via Pescador Camarillo CA 93012 When sending in product for service your packa
Download Pdf Manuals
Related Search