Lanier RS232 User's Manual
Contents
1. LANiER A RICOH COMPANY MATERIAL SAFETY DATA SHEET 2300 Pariake Dive NE Atlanta GA USA 30345 2979 Emergency Telephone 800 526 4371 Section 1 Chemical Product and Company Information Identity Color Developer Cyan MSDS No CP 736 Product ID 480 0077 Issued 06 04 2003 Supersedes None Synonyms Developer for Lanier LPO36c Date 06 04 2003 amp Common Development Unit Type 5000 Color Prepared by EH amp S Department 770 496 9500 Names Cyan Approved by Larry Choskey Manager CEH amp S European Walter Fricke Manager Safety amp Uses Lanier LPO36c Contact Environment Lanier Worldwide Inc Chemical Im Taubental D 41468 Neuss Formula Mixture Germany 49 2131 387 177 Section 2 Composition Information on Ingredients PERCENT CAS No EXPOSURE LIMITS SOURCE Polyester resin gt 80 Confidential Not listed N a Acrylic resin lt 10 Confidential Not listed N a Silicon compound lt 3 7631 86 9 Not listed N a Organic pigment lt 10 147 14 8 Not listed N a Section 3 Hazards Identification HMIS Rating FLAMMABILITY 1 HEALTH 1 REACTIVITY 0 SPECIAL none Health Hazards Immediate and Potential Primary Entry Routes Inhalation Yes Skin No Ingestion No Medical conditions aggravated by exposure N A Chronic Effects No data is available on this product Carcinogenicity This product does not contain the carcinogenic substances which are listed in NTP IARC and are regulated by OSHA Section 4 First Aid2. Measures Gargle with water Remove to fresh air if effects In case of contact immediately flush Inhalation occur Get medical attention if needed Eye Contact eyes with water for 15 minutes Get medical attention if needed Skin Contact Wash with soap and water Ingestion Dilute stomach contents with several glasses of water Get medical attention Section 5 Fire Fighting Measures Suitable extinguishing media COs dry chemical foam or water Extinguishing media which may not be used for safety reasons none Special protective equipment for fire fighters none UEL n a LEL n a your document management partner MATERIAL SAFETY DATA SHEET Page2 of 3 CP 736 Section 6 Accidental Release Measures Spill leak Procedures If spilled sweep up using an approved toner vacuum with a 0 5 micron filter or smaller such as the Atrix AAA Toner Vacuum or 3M Toner Vacuum Use of a vacuum cleaner not rated for toner particles could result in a fire or personal injury Remove residue with soap and cold water Miscellaneous Keep product out of sewers and watercourses Personal protection Avoid inhalation of dust Section 7 Handling and Storage Special Handling Cleanse skin after contact before breaks or meals and end of workday Do not handle in areas where the wind blows Minimize the breathing of dust Special Storage Avoid direct sunlight Keep out of reach of children Store in a cool dry place Below 35C 95F Section 8 Expo
3. ermine the proper method for disposal Do not incinerate loose or spilled developer Section 14 Transportation Information International regulations RID ADR Not applicable ICAO TI ATA DGR Not applicable DOT 49 CFR Not applicable UN Classification Number Not applicable ADNR Not applicable IMDG Code Not applicable Specific precautionary transport measures Avoid direct sunlight Do not keep over 35 C 95 F Specific material to avoid None in normal use MATERIAL SAFETY DATA SHEET Page2 of 3 CP 736 Section 15 Regulatory Information Regulation Not known Section 16 Miscellaneous Information Judgment as to the suitability of information contained herein for user s purposes is the responsibility of the purchaser Therefore although reasonable care has been taken in the preparation of this information Lanier Worldwide Inc extends no warranties makes no representations and assumes no responsibility as to the accuracy or suitability of such information for application to user s intended purposes or for consequences of its use All materials may present unknown hazards and should be used with caution Although certain hazards are described herein we do not guarantee that these are the only hazards that exist
4. sure Control and Personal Protection Information Respiratory Protection none required under normal use Hand Protection none required under normal use Eye Protection none required under normal use Skin Protection none required under normal use Section 9 Physical and Chemical Properties CHARACTERISTICS Appearance Cyan Melting point N a Form Powder Vapor pressure N a Odor Slight plastic odor Vapor density N a Solubility in Water Insoluble Evaporation rate N a Specific gravity N a Boiling point N a Density 1 2 g cm Section 10 Stability and Reactivity Conditions to avoid none Materials to avoid none Stability Stable Hazardous decomposition products will not occur Section 11 Toxicological Information Ames test negative Acute skin irritation Non irritant Acute oral toxicity 5000mg kg rat Acute allergenic effects non skin sensitive Special effects Carcinogenicity No data is available on this product Section 12 Environmental Ecological Information Acute toxicity to fish not available Bioaccumulation Not known in bioaccumulation Persistence Degradability Not known Acute toxicity to daphnia Not available Algae inhibition test Not available Section 13 Disposal Consideration Used developer should be disposed of under conditions that meet all federal state and local environmental regulations Disposal regulations vary from locality to locality therefore consult your local Lanier office or the EPA to det
Download Pdf Manuals
Related Search