Kinyo GZ-501 User's Manual
Contents
1. Use the button to operate power on off 18 5 1 CH INPUT LED INDICATOR The LED indicates the system is in 5 1 channel input mode 2 or3 INPUT LED INDICATOR The LED indicates the system is in 2 channelinput mode SURROUND LED INDICATOR This LED will ight up when in surround input mode This function does not operate upon 6CH input INPUT Aelect Use the button to operate 1 3 INPUT MASTER VOL Press this key to increase master volume level MASTER VOL Press this key to decrease master volume level STANDBY LED INDICATOR This LED indicates the system is in standby mode When making functional adjustments the LED will flash This LED will light up when the volume is adjusted to either maximum or minimum indicating the volume level cannot be further increased or decreased MUTE LED INDICATOR This LED will flash when in mute mode Stereo Headphone Jack SPEAKERS CONTROL REMOTE CONTROL FUNCTIONS POWER Press this key to operate standby on off RESET In the 6CH mode press this key and the volume in each audio channel will return to its default value In the 2CH mode press this key and it will erase the SURROUND effect and retum to its default value MUTE Press this key to turn mute on and off SURROUND Before operating this function make sure the system is in the 2CH mode Otherwise it will not function when the key is pressed INPUT SEL Use the key to operate 1 3 INPUT MAIN To increase decrea2. BY MUTE Controls 2 5 Watts RMS 3 Full Range Speaker 120Hz 20KHz Frequency Response Impedance 40 Dimensions W200 X H120 X D105 5mm 7 78X 4 X 4 vie inch Subwoofer AV Input Input 1 G9 to 6 RCA RCA to RCA stereo to stereo Input 2 Analog stereo RCA X 2 RCA to RCA stereo to stereo Input 3 Analog stereo RCA X 2 RCA to RCA stereo to stereo Output RCA FL FR RR Channels amp stereo CEN Channel 12 5 Watts RMS 4 Woofer Speaker 50 2 2 2 L F E Impedance 400 Power switch Dimensions W260 X H150 X D240mm 101 4 X 57 8 X 9 1 2 inch A PER REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER OR BACK NO USER SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL WARNING REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE CAUTION PILOT LAMP SOLDERED IN PLACE TO REDUCE THE RISK OF ELECTRIC SHOCK REFER TO QUALIFIED SERVICE PERSONNEL Attention presence of dangerous voltage located within enclosure Attention consult instruction manual for important operating and maintenance servicing instructions Do not install this equipment in a confined space such as book case or similar unit The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids such as vases shall be placed on the apparatus The secondary switch d
3. KINYO GAME ZONE 5 1 User s Guide 7 501 Please read and understand all safety instructions before use 5 1 Home Theater Speakers LOCATION OF CONTROLS Input2 PSone RF PS2 SPEAKER Xbox GameCube VCR CONNECTING SUBWOOFER TO SATELLITE SPEAKERS 1 RCA jacks of the right rear surround speaker to the right rear surround channel RCA socket of subwoofer 2 RCA jacks of the right front speaker to the right front channel RCA socket of the subwoofer 3 Connect RCA jacks of the left rear surround speaker to the left rear surround channel RCA socket of the subwoofer 4 Connect RCA jacks of the front speaker to the left front channel RCA socket of the subwoofer 5 Connect mini jacks of the center speaker to the center channel mini socket of the subwoofer B CONNECTING AUDIO SIGNAL TO CONTROL UNIT 1 Use the G9 cable for audio signal input Connect one end of the G9 cable to the audio source and the other end to the control unit 2 Use the RCA cable to input analog stereo audio signals D CONNECTING POWER TO THE SYSTEM Connect the subwoofer s AC plug to the electrical wall outlet directly ACCEPTABLE RANGE OF REMOTE CONTROLLER Depending on the environment satelite speakers centerleftright rear left and rear right can be placed on the wall CONTROL UNIT FUNCTIONS FRONT PANEL POWER
4. oes not disconnect the apparatus mains
5. se master volume level LF To increase decrease left front volume level LR increase decrease left rear volume level RF To increase decrease right front volume level RR To increase decrease right rear volume level SW increase decrease subwoofer volume level To increase decrease center volume level increase decrease overall volume level CONTROL UNIT CONNECTIONS BACK PANEL WOOFER BACK PANEL e 1 POWER 2 AC IN 3 5 CHANNEL OUTPUT 4 3 GROUPS INPUT TROUBLESHOOTING AND SUPPORT Problem Case Remedy No Sound Speakers not properly Check cables for short connected open connections incorrect input mode Select proper audio source Digital or Analog Amplifier is offimalfunction Check your amplifier Weak sound Volume control down Tum volume control up Speak cable shorted or have Check cables broken strands Buzzing sound Speaker cable wire short Check cable wiring No balance control Check balance control setting Adjust balance control Excessive Speaker out of circuit Check speaker Highs or lows SPECIFICATIONS Remote Controller DR 66 Satellite Surround Speakers 2 5 Watts RMS each 3 Full Range Speaker 120H2 20KHz Frequency Response Impedance 40 Dimensions W96 X H120 X D98 5mm 3 34 X 4 X 3 inch Center Speaker LED Display Remote Control Receiver Volume Volume ST
Download Pdf Manuals
Related Search