Karcher HD 650 *GB User's Manual
Contents
1. See illustrations J to BJ at the end of the instructions e Mount handle screws and nuts supplied Engage the holder for handgun at the side of the handle e Mount nozzle on the spray lance see markings on the top of the setting ring e Mount spray lance on the handgun 3 Using the cleaner for the first time Electrical connection Caution The voltage specified on the model rating plate must correspond to the voltage supplied Caution Use an extension cable whose cable cross section is adequate 10 m 2 5 mm 30 m 4 mm and unreel it completely from the cable drum For connected loads see model rating plate Technical Specifications Water connection suction feed operation Connection to water main Caution Pay attention to the regulations of the water supply company according to DIN 1988 the cleaner may not be connected direct to the public drinking water supply A short term connection via a non return valve Order no 6 412 578 is allowed For connected loads see Technical Specifications e Connect a supply hose not supplied to the water outlet 15 on the cleaner and to the water inlet e g water tap e Open water inlet Suctioning water from an open container e Screw suction hose with filter Order no 4 440 238 to the water outlet 15 Venting the unit To vent the unit unscrew the nozzle and leave the unit running until the water exits with no air bub2. an electric shock have a damaged connecting cable replaced without delay by authorised Customer Service personnel or an electrician e Check high pressure hose for damage danger of explosion replace a damaged high pressure hose without delay e Check cleaner pump for any leaks Three drops per minute are allowable and can appear on the underside of the cleaner Seek the help of Customer Service if leaks are more serious Every week e Check oil level in oil reservoir 16 if the oil is milky water in oil seek the help of Customer Service immediately e Clean the strainer at the water outlet e Clean the filter at the suction hose for detergent Annually or after 500 operating hours e Change the oil For oil quantity and type see Technical Specifications Undo fastening screws 12 remove unit cover remove cover of oil reservoir Lay cleaner on its side and drain oil into a suitable container Fill slowly with fresh oil air bubbles have to escape English 6 Troubleshooting Danger Before any repair work is undertaken switch the cleaner off and pull out the power plug Have electrical components checked and repaired only be authorised Customer Service personnel For faults which are not identified in this chapter or when in doubt or when expressly instructed to do so consult authorised Customer Service personnel Cleaner does not work e Check mains voltage e Check connecting cable
3. side of the pump If the lever 2 is released the pressure switch switches the pump off If the lever is retracted the pressure switch switches the pump on again Warranty The warranty terms issued by our authorised marketing company are valid in every country We remedy any fault in the cleaner free of charge within the warranty period providing the cause of the fault proves to be a material or manufacturing error The warranty only becomes operative when your dealer has completed the reply card accompanying the sale of the unit has stamped and signed it and you have then sent the reply card to the marketing company in your country Should you wish to call upon the guarantee please apply to your dealer or nearest authorised Customer Service centre taking along also the accessories and bill of sale English 2 Preparing the cleaner for use Unpackthe cleaner e When unpacking the cleaner check the contents of the packaging If there has been any damage in transit inform the dealer e Do not dispose of the packaging with the household rubbish hand it in at the appropriate collection point for recycling Check the oil level See illustrations J to El at the end of the instructions e Screw out the fastening screws on the left and right of the unit cover remove unit cover e Cut off the tip on the cover to the oil reservoir e Check the oil level in the oil reservoir e Fasten the unit cover Mount the accessories
4. EC amended by 93 68 EEC EU Directive on Electromagnetic Compatibility 89 336 EEC amended by 91 263 EEC 92 31 EEC 93 68 EEC Harmonised standards applied DIN EN 60 335 1 DIN EN 61 000 3 3 1995 DIN EN 60 335 2 79 DIN EN 55 014 2 1997 DIN EN 61 000 3 2 1995 DIN EN 55 014 1 1993 National standards applied Appropriate internal measures have been taken to ensure that series production units conform at all times to the requirements of current EU Directives and relevant standards The signatories are empowered to represent and act on behalf of the company management Alfred Karcher Kommanditgesellschaft Sitz Winnenden Alfred a amp Co 5 Registergericht Waiblingen HRA 169 Cleaning Sy Y 2 Pers nlich haftende Gesellschafterin Alfred archer St 28 40 R EI o Karcher Reinigungstechnik GmbH P O B L Or Moisi LA 8 Sitz Winnenden 2404 Registergericht Waiblingen HRB D 71543 Winnenden haw x JA Gesch ftsf hrer Tel 49719514 S wo Dr Bernhard Graf Hartmut Jenner Herbert Konhausner Fax 4971 95 140212 RB Georg Metz Thomas Sch binger Dr B Graf S Reiser T Sch binger HER 1 150 112 GB 5 044 082 0 lt e ih 6 388 216 0 l 4 580 337 0 UN 5 731 040 0 6 304 099 0 6 389 870 0 6 435 197 0 6 389 853 0 2 880 296 0 4 775 296 0 S 4 763 212 0 02 99
5. at the end of these operating instructions 8 Technical Specifications English HD 650 1 150 112 Mains connection Voltage 90 110 V Type of current 1 50 Hz Connected load 2 6 kW Supply fuse delayed action 30 A Water connection Supply temperature max 60 C Supply volume min 700 l h Supply hose length 75 m Supply hose minimum diameter Y inches Suction height from an open container 20 C 0 5 m Supply pressure max 10 bar Performance data Operating pressure 20 100 bar Flow rate 150 550 l h Detergent intake 0 40 l h Recoil force of the handgun 26 N Sound level DIN 45 635 78 dB A Dimensions Length 400 mm Width 340 mm Height 900 mm Weight without accessories 26 5 kg Reservoir capacity detergent 7 Oil quantity pump 0 4 Oil type pump motor oil 15W40 EU Declaration of Conformity We hereby declare that the equipment described below conforms to the relevant fundamental safety and health requirements of the appropriate EU Directives both in its basic design and construction as well as in the version marketed by us This declaration will cease to be valid if any modifications are made to the machine without our express approval Product High pressure cleaner Model 1 150 xxx 1 151 xxx 1 214 xxx Relevant EU Directives EU Machinery Directive 98 37 EEC EU Low Voltage Equipment Directive 73 23 E
6. bles e Switch off the unit and screw the nozzle back on English 4 Operating the cleaner Danger Observe the relative safety regulations when using the cleaner at filling stations or other high risk areas Caution Only clean engines in places which have appropriate oil separators protection of the environment Caution Only wash animals with the low pressure fan jet see Selecting the type of spray Operating with high pressure The cleaner is equipped with a pressure switch The motor only starts up when the lever 2 is retracted e Press safety switch 3 and retract lever 2 e Set unit switch 17 to I e Adjust operating pressure and flow rate by rotating the pressure flow control 13 infinitely variable Read off operating pressure on pressure gauge Selecting the type of spray The handgun must be closed e Rotate the housing of the nozzle 22 until the desired symbol corresponds with the marking High pressure pencil jet for particularly stubborn accumulation of grime Low pressure fan jet for operating with detergent or cleaning with negligible pressure High pressure fan jet for dirt accumulation over a large surface Operating with detergent Caution Unsuitable detergents can harm the cleaner and the object which is to be cleaned Use only detergents which are released by Karcher Proportions of detergent to be used and accompanying instructions shou
7. ck it up by the handle Empty the detergent reservoir 10 before transporting it horizontally Storing the cleaner e Place the handgun 1 in the support 6 e Reel in the high pressure hose 5 and hang it over the hose rest 18 e Coil the connecting cable round the cable hose rest 20 English 4 Operating the cleaner Protection from sub zero temperatures Caution Water which has frozen in the cleaner can destroy parts of it At best store the cleaner in a heated room during the winter or empty it or rinse it thoroughly with antifreeze Empty the cleaner Unscrew supply hose and high pressure hose from the cleaner Leave the cleaner running until the pump and lines have emptied max 1 minute Putting in antifreeze For longer intervals between operations pumping antifreeze through the cleaner is to be recommended By this means also you obtain a sure protection against corrosion 5 Care and maintenance Danger Before undertaking any care or maintenance work on the cleaner pull out the power plug Caution When changing the oil dispose of any waste oil only at authorised collection points Safety inspection maintenance contract You can arrange with your dealer to have a regular safety inspection carried out or to have a maintenance contract Please seek advice on this Each time before operating the cleaner e Check connecting cable for damage risk of getting
8. for damage If the motor has overheated let the cleaner cool down Then switch it on again e Consult Customer Service if there is an electrical fault Cleaner does not come up to pressure e Set nozzle 22 to high pressure e Clean nozzle or replace with new one e Clean strainer at the water connection 15 e Evacuate air from the cleaner e Check water inlet volume see Technical Specifications e Check all supply lines to the pump for leaks or obstructions e Seek the help of Customer Service if necessary Pump is leaky e Three drops per minute are allowable and can appear on the underside of the cleaner Seek the help of Customer Service if leaks are more serious Pump makes a knocking noise e Check all supply lines as well as the detergent system for leaks e Evacuate air from the cleaner e Seek the help of Customer Service if necessary Detergent is not being drawn in e Set nozzle 22 to low pressure e Check detergent suction hose 11 with filter for leaks or obstructions and clean it if necessary e Clean renew non return valve in detergent suction hose 11 connection e Open detergent metering valve 8 or check it for leaks remove obstruction Also clean venting orifice in the cap Tip the cleaner backwards over the wheels Empty the detergent reservoir 10 and rinse it out e Seek the help of Customer Service if necessary 7 Spare parts You will find a list of spare parts
9. i E CH RAR HT B G 650 D H English 1 Important notice Unit parts Please fold out illustration page at the front Handgun with built in pressure gauge Lever Safety switch Spray lance High pressure hose Handgun support Nozzle rest Detergent metering valve Cap for detergent reservoir 10 Detergent reservoir 11 Detergent suction hose with filter 12 Fastening screws for unit cover 13 Pressure flow control 14 High pressure outlet 15 Water outlet with strainer 16 Checkpoint for oil level 17 Unit switch 18 Hose rest 19 Fastening screws for handle 20 Cable hose rest 21 Handle 22 Nozzle OONDOABRWND For your safety Before you use the cleaner for the first time read these operating instructions and take special note of the accompanying booklet Safety Instructions for High pressure Cleaners No 5 951 949 Use of the cleaner Use this cleaner exclusively for cleaning with high pressure jet and detergent e g cleaning of machines vehicles buildings tools cleaning with high pressure jet without detergent e g cleaning facades terraces gardening equipment For stubborn dirt we recommend the dirt blaster as an optional accessory Safety features Relief valve with pressure switch On reducing the flow rate with the pressure and flow control the relief valve opens and part of the water runs back to the suction
10. ld be noted carefully Use detergents sparingly out of consideration for the environment Karcher cleaning agents guarantee trouble free operation Please seek advice or ask for our catalogue of information sheets on cleaning agents Active cleaner RM 31 ASF Universal cleaner RM 55 ASF Active wash RM 81 ASF Fill detergent reservoir 10 Ed e Set nozzle 22 to d e Set detergent metering valve 8 to the centre position Adjust dosage with or as required Recommended cleaning methods 1 Spray detergent sparingly over the dry surface to be cleaned and let it take effect but not dry out 2 Spray off rinse off the loosened dirt using the high pressure spray e When you have finished the operation set detergent metering valve 8 to 0 and switch the cleaner on for about 1 minute and rinse it clear of detergent Interrupting the operation e Release lever 2 the cleaner switches off Retract lever again and the cleaner switches on again Switching the cleaner off e Set unit switch 17 to 0 and pull out power plug e Close water inlet e Retract lever 2 until the cleaner is without pressure e Press safety switch 3 to secure lever against being activated unintentionally Transporting the cleaner To transport the cleaner over relatively long stretches take hold of it by the handle 21 and pull it along behind you e To transport it up steps or over ledges pi
Download Pdf Manuals
Related Search