Kambrook CERAMIC KCE640 User's Manual
Contents
1. Building 2 Port Air Industrial Estate 1A Hale Street Botany NSW 2019 Australia Customer Service Line 1300 139 798 Customer Service Fax 1800 621 337 Kambrook New Zealand Private Bag 9441 1 Botany Manukau Auckland 2141 New Zealand Customer Service Line Spare Parts 0800 273 845 or 09 271 3980 Customer Service Fax 0800 288 513 KCE640_IB_FA indd 1 Due to continual improvement in design or otherwise the product you purchase may differ slightly from the illustration in this book Issue 1 10 KAMBROO THE SMARTER CHOICE 16 10 09 10 49 AM2. KAMBROOK THE SMARTER CHOICE KCE640 m KCE640 IB FA indd 1 Important Please retain your instruction book for future use In the event that you need some assistance with your Kambrook appliance please contact our Customer Service Department on 1300 139 798 Australia or 09 271 3980 New Zealand Alternatively visit us on our website at www kambrook com au KCE640_IB_FA indd 2 16 10 09 10 49 AM Contents Kambrook Recommends safety First Your Ceramic Tower Heater Quick Start Guide Using Your Ceramic Tower Heater Care and Cleaning Warranty Details KCE640_IB_FA indd 3 p4 p p 08 plO p12 16 10 09 10 49 AM Kambrook Recommends Safety First IMPORTANT Please retain your instruction book for future use At Kambrook we believe that safe performance is the first priority in any consumer product so that you our valued customer can confidently use and trust our products We ask that any electrical appliance that you use be operated in a sensible fashion with due care and attention placed on the following important operating instructions Important Safeguards For Your Kambrook Ceramic Tower Heater A Avoid touching heater body while it is on some parts of the heater are hot When moving the unit switch off and hold the heater by the handles where provided Keep combustible materials such as drapes and other furnishings at least 1 7 metres from the front sides and rear of the heater D
3. or 3 months commercial use The Kambrook Replacement Warranty does not apply to any defect deterioration loss injury or damage occasioned by or as a result of misuse or abuse negligent hanaling or if the product has been used other than in accordance with the instructions The Kambrook Replacement Warranty excludes breakables such as glass and ceramic items consumable items and normal wear and tear This Kambrook Replacement Warranty is void if there is evidence of the product being tampered with by unauthorised persons If the product includes one or a number of accessories only the defective accessory or product will be replaced Subject to your statutory rights in the event of Kambrook choosing to replace the appliance the Kambrook Replacement Warranty will expire at the original date i e 12 months from the original date of purchase In the event that you need some assistance with your Kambrook appliance please contact our Customer Service Department on 1300 139 98 Australia or 09 271 3980 New Zealand Alternatively visit us on the website at www kambrook com au Your Purchase Record Please Complete Date Of Purchase Model Number Serial Number Kambrook 12 Month Replacement Warranty Attach a copy of the purchase receipt here Please don t return purchase record until you are making a claim Register your warranty at www kambrook com au service asp Kambrook Australia
4. the heater is covered or positioned incorrectly This heater is not intended for use in wet or moist locations Do not use this heater in the immediate surroundings of a bath a shower or a swimming pool Do not immerse or allow liquids to be spilt on heater This heater has hot and arcing or sparking parts inside Do not use in areas where petrol paints aerosols or other inflammable substances are used or stored Do not operate the heater with the power cord damaged frayed or split wound around any part of the heater or in contact with heated surfaces of the heater 16 10 09 10 49 AM Do not allow materials that have been in contact with oil petroleum based products or drying fluids to come in contact with the heater Do not run fhe cord under carpeting or cover the cord with rugs runners or the like Arrange cord away from traffic areas and where it will not be tripped over To disconnect heater turn the power to OFE then turn the control switch to off Turn off at the power outlet then remove the plug from its outlet Do not insert or allow foreign objects to pass through the inlet or outlet openings This may cause an electric shock fire or damage the heater To prevent a possible fire or heat damage allow ample space around the heater 1 7m at front and 0 5m at the rear top and sides and do not totally or partially block the air inlet or outlets in any manner Check the openings from time to time f
5. er cut out switch e Power switch THERMO Wy GUARD Pee TED KCE640_IB_FA indd 6 16 10 09 10 50 AM Quick Start Guide Turning the heater on Plug the cord into a 230V or 240V power point and switch on Setting the oscillation ON OFF Lo Press the SWING Press the ON OFF button again to place the heater in standby mode and the heater will turn off button To activate Press again to stop the oscillation Press the Power switch to ON position to switch on Turning the heater off ON OFF Setting the heating mode Lo y Press the ON OFF button to activate The heater will start operating at the LOW heat setting Press the Power switch to OFF position to switch off Hints Tips to Retain Heat in i Your Home Don t overheat your home The temperature of a heated room in winter should be 18 21 C e Your heater will work more efficiently if you stick to Kambrook s recommended o clearance spaces Choose the right size heater for the room o type you want to heat KCE640_IB_FA indd 7 Press the MODE button To select the HIGH heat setting and retain a comfortable temperature for your room Zone off unoccupied rooms by closing doors and only heat the main living areas Fit window coverings like curtains to halve winter heat loss Put draft stoppers such as a rolled up towel at the bottom of outside doorways
6. ith the press of each button Setting the Heating Mode To activate the heater press the ON OFF button The heater will start operating on the LOW heat setting 1200 watts and the LOW LED will illuminate The ON OFF LED will also illuminate MODE SWING ON OFF TIMER EJE Use the MODE button to select the desired heat setting Ihe MODE button allows you to select from two heat settings HIGH High heat setting 2000 watts LOW Low heat setting 1200 watts Turn the heater off by switching the Power ON OFF fg switch located at the back panel of the heater to the OFF position NOTE This heater features a tip over switch If the heater tips over it will automatically switch off Once placed back into the upright position the heater will be in standby mode and the settings will need to be selected again 16 10 09 10 50 AM Setting the Oscillation The oscillation function works at both operating temperatures Press the SWING button once to activate The heater will begin to oscillate from side to side Press the SWING button again to stop the heater from oscillating Setting the Auto Off Timer The timer function works at both operating temperatures and switches the unit off after a preset number of hours Press the TIMER button to activate the timer settings The 30 minute LED will illuminate 30M IH 2H 4H through the 30 minute and one hour increments up to 7 5 hours The hea
7. me to completely dry before replacing the filter and the filter casing panel 10 KCE640 IB FA indd 10 16 10 09 10 50 AM Notes 11 KCE640_IB_FA indd 11 16 10 09 10 50 AM Kambrook 12 Month Replacement Warranty In Australia this Kambrook Replacement Warranty does not affect the mandatory statutory rights implied under the Trade Practices Act 1974 and other similar State and Territory legislation relating to the appliance It applies in addition to the conditions and warranties implied by that legislation In New Zealand this Kambrook Replacement Warranty does not affect your mandatory statutory rights implied under the Consumer Guarantees Act 1993 in relation to the appliance It applies in addition to the conditions and guarantees implied by that legislation This Kambrook Replacement Warranty is valid only in the country of purchase but other statutory warranties may still apply This Warranty card and the purchase receipt for this product are to be retained as proof of purchase and must be presented if making a claim under the Kambrook Replacement Warranty Please note that under any applicable statutory warranty you are not required to produce these documents but may be required to provide a proof of purchase Kambrook warrants the purchaser against defects in workmanship and material for a period of 12 months domestic use from the date of purchase
8. o not use heater to dry your laundry WARNING In order to avoid overheating do not cover the heater Extreme caution and supervision is necessary when this heater is used by or near children invalids or animals This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not play with the appliance Important this heater is intended for floor use only Do nof mount on ceiling or walls Do not leave heater unattended Always switch off the heater at the controls and KCE640 IB FA indd 4 at the power outlet then unplug heater from the power outlet when not in use Do not operate heater whilst asleep Do not operate any heater with a damaged cord or plug or if heater has been dropped or damaged in any manner Return heater to your nearest service centre for examination electrical or mechanical adjustment or repair Do not use Outdoors This heater is not intended for commercial use such as construction sites Do not locate the heater immediately below a socket outlet when in use Do not use this heater with a programmer timer or any other device that switches the heater on automatically Since a fire risk may exist if
9. or accumulated dust Ensure long shag carpet does not obstruct airflow under the unit Do not touch hot surfaces switch off at the control switch and power outlet then unplug and allow heater to cool down before cleaning or storing Always move the heater with the handle provided Use this heater only as described in this instruction manual Any other use not recommended by the manufacturer may cause fire electric shock or injury and voids all warranties Regularly inspect the supply cord plug control settings air inlets and outlets and main housing for any damage If found damaged in any way immediately cease use of the heater and return to Kambrook or an authorised service agent for inspection or repair NOTE This Kambrook Ceramic Tower Heater is electronically controlled and will not operate until the heater is plugged into a 230V or 240V power point and switched on Important Safeguards For All Electrical Appliances Fully unwind the power cord before use Do not let the power cord hang over the edge of a bench or table touch hot surfaces or become knotted The appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do no
10. t play with the appliance It is recommended to regularly inspect the appliance lo avoid a hazard do not use the appliance if power cord power plug or appliance becomes damaged in any way Return the entire appliance to the nearest authorised Kambrook service Centre for examination and or repair or contact Customer Service on 1300 139 798 KCE640 IB FA indd 5 e Any maintenance other than cleaning should be performed at an authorised Kambrook Service Centre e This appliance is for household use only Do not use this appliance for anything other than its intended use Do not use in moving vehicles or boats Do nof use outdoors Misuse may cause injury e The installation of a residual current device safety switch is recommended to provide additional safety protection when using electrical appliances It is advisable that a safety switch with a rated residual operating current not exceeding 30mA be installed in the electrical circuit supplying the appliance See your electrician for professional advice 16 10 09 10 49 AM Your Ceramic Tower Heater 1 2000 watt ceramic heating Control Panel element 6 2 LED screen Convenient 7 5 hr auto off timer pt 2 heat settings 3 E een for 8 75 degree oscillation for warmth pene Sr Haus throughout the room 4 Full featured remote control 9 Power on off 5 Ceramic heating elements for efficient heating Not Shown e Convenient carry handle e Safety tip ov
11. ter will then switch itself to standby mode after the selected number of hours has passed KCE640 IB FA indd 9 ThermoGuard Overheating Safety Device THERMO Wy GUARD PROTECTED Your heater is fitted with a safety device that switches off the heater in the event of overheating Should this heater stop working turn off the heater and inspect the air inlet and outlet for blockages Wait for at least five minutes for the protection system to reset before attempting to restart the heater If the heater fails to operate or the safety device switches off again return the heater to your nearest service centre for examination or repair 16 10 09 10 50 AM Care and Cleaning Ensure that the heater is switched off and disconnected from the power point before cleaning Use a clean dry cloth to clean the external surfaces of the heater If the heater has collected dust or dirt inside the unit or around the elements have the unit cleaned by a qualified service agent Do not operate the heater in this condition Do not attempt to open the case of the heater at any time as there are no customer serviceable parts inside When not in use store the heater preferably in its original box in a cool clean and dry location The air filter at the rear of the heater can be easily cleaned by removing the filter casing panel and removing the mesh filter A basic clean in warm water to remove any build up is adequate and allow ti
12. to keep out cold air Keep the heat in and the cold out by installing wall and ceiling insulation Avoid placing items too close to the heater both at the front and back for optimal air flow 16 10 09 10 50 AM Using Your Ceramic Tower Heater Before First Use Remove any promotional material or packaging from the heater Unwind the cord to its full length and place the heater on a firm level surface in a stable upright position Visually inspect the air inlet and outlets to ensure there are no blockages When unpacking the heater check to see you have received the remote control before discarding the packaging Turning Your Heater On Plug the cord into a 230V or 240V power point and switch on NOTE To avoid an electrical circuit overload it is recommended that no other appliances are plugged into the same circuit as your heater when it is in use Turn the heater on by switching the Power ON OFF fi switch located on the back panel of the heater to the ON position An audible beep will sound The heater is now in standby mode Using The Remote Control Your heater may be operated using either the control panel or the remote control The remote control uses 2 x AAA batteries Io access fhe battery compartment simply remove the cover at the rear of the remote control To operate ensure that you point KCE640 IB FA indd 8 The remote control at the heater An audible beep will sound w
Download Pdf Manuals
Related Search