JVC PK-CL200U User's Manual
Contents
1. JVC LAMP REPLACEMENT INSTRUCTIONS Replacement Lamp Kit K CL200 WARNING This Lamp Kit is for use only with JVC model AV 61S902 LCT0811 001A The following instructions will tell you how to safely replace the projection lamp Please read these instructions fully before attempting to replace the lamp If you feel unsure about replacing the lamp call a service technician WARNING It is very important you DO NOT TOUCH THE GLASS SURFACE OF THE NEW LAMP Touching the glass surface will deposit oils from your hand onto the lamp surface When the lamp heats up to operating temperature the oil will cause a difference in temperature on the lamp surface This will likely cause the lamp to break This lamp is only for use with the AV 61S902 It is designed to work specifically with the AV 61S902 Using this lamp with a different television or other product could cause a malfunction and or damage to the television or the lamp Under operating conditions THE LAMP WILL GET EXTREMELY HOT AND WILL CAUSE SEVERE BURNS IF TOUCHED Before attempting to replace the lamp make sure the television has run through its cooling cycle indicated by the front panel LED lights and that the television is unplugged If you feel any warmth coming from the lamp DO NOT TOUCH IT Wait until the lamp has fully cooled before attempting to replace it NEVER attempt to replace the lamp with the television plugged into a wall outlet Attempting to replac2. screws using Handle the hex wrench To ensure the new lamp assembly sits properly inside the television secure the right hex screw first then the left If the lamp assembly does not sit Light source lamp unit securely inside the television the television will not turn on Hex wrench WARNING Remember it is very important you DO NOT TOUCH THE GLASS SURFACE OF THE NEW LAMP Please re read the warnings on page 2 regarding the new lamp unit This lamp is only for use with the AV 61S902 It is designed to work specifically with the AV 61S902 Using this lamp with a different television or other product could cause a malfunction and or damage to the television or the lamp THE USED LAMP MUST BE RECYCLED IN THE US See the includ ed sheet and page 63 of the AV 61S902 s User s Guide for detailed recycling information for customers in the US F The lamp assembly in this product contains mercury Disposal of the lamp assembly may be regulated due to environmental considerations For information on replacement disposal or recycling procedures please contact JVC Customer Relations at 1 800 252 5722 8 Install the filter unit Position the filter assembly back into its place being careful not to touch the surface of the filter Position the three screws and tighten using an correct sized coin 9 Reinstall the filter cover Place the filter cover over the filter Insert the four screws and tighten them using t
3. e a lamp with the television plugged in could lead to a severe electrical shock This kit also includes instructions on recycling the used lamp Because the lamp contains a small amount of mercury it cannot be disposed of with normal trash in the U S Packaging with a pre paid shipping label for returning the lamp to a JVC authorized recycling center for recycling is included with the replacement lamp See the included sheet and page 63 in the AV 61S902 User s Guide for details on recycling information for customers in the United States Check the accessories Check that nothing is missing The kit will include e High Pressure Mercury Lamp e Hex Wrench e Replacement Instructions e Recycling Information Sheet e Pre paid shipping label Replacing the Lamp 1 Turn the television off Press the Power button on the remote control or television s front panel to turn the television off Wait until the picture has closed and the LED lights on the front panel have stopped blinking indicating the lamp cool down cycle is complete Warning The cool down cycle cools the lamp from its normal operat ing temperatures This does not mean the lamp will now be cool enough to handle safely Wait at least one hour before proceeding 2 Unplug the television Disconnect the television s power cord from the AC outlet Make sure the LED lights have stopped blinking before you unplug the televi sion Never attempt to replace the lamp with the t
4. e been Coin etc loosened slide the filter assembly out to remove it e Do not touch the surface of the filter or try to remove it from the filter assembly These actions could damage the filter If the filter is damaged call a service technician to replace the filter Filter unit Filter WARNING DO NOT attempt to remove the assembly until the lamp has fully cooled down If you feel any heat near the lamp assembly STOP the removal and wait until the lamp has FULLY COOLED NEVER attempt to remove the lamp assembly with the television plugged into a wall outlet DO NOT DROP the used lamp The inside of the lamp is under pres sure Dropping or other hard shock could cause the lamp to shatter ALWAYS recycle the used lamp Because the lamp contains a small amount of mercury it cannot be thrown out with regular trash Follow the recycling instructions included with the replacement lamp Continued on the next page 5 6 Removing the lamp assembly Using the hex wrench included with the replacement lamp loosen the two hex screws fastening the lamp assembly unit Remove the screws and set aside When the screws have been removed remove the lamp assembly by grabbing the handle and sliding the assembly towards you 7 Install the new lamp unit Slide the new lamp assembly into the television by holding the han dle attached to the unit When the new lamp assembly is securely installed inside the television replace the hex
5. elevision plugged in Continued on the next page 3 3 Remove the left soeaker panel The next step is to remove the left speaker panel locat ed at the bottom of the front 1 Puli of the television cabinet o Make sure the television is unplugged see steps 1 and 2 before removing the speaker panel lt To remove the panel Grab the panel from the side near the top Gently pull the top away from the television When the top part of the speaker panel is fully away from the television lift up The panel will come away from the bottom of the television Set the panel aside Speaker Panel 4 Remove the filter cover The lamp is located behind the air fil ter To access the lamp you will need to remove this filter assembly and the filter panel covering it To remove this panel you will need a Phillips head screwdriver First loosen the screws located at the four corners of the panel Once the screws have been Screws loosened slide the cover up until the large holes align with the screw Filter Cover heads Gently pull the panel away from the television and set aside Please see Appendix A for illustrations for removing the speaker and filter covers Q 5 Removing the filter assembly Next you will need to remove the filter Herod swich assembly To remove the assembly use a coin to loosen the three large slotted screws fastening the filter assembly When the screws hav
6. free 1 800 882 2345 or on the web at www JVC com For service in Canada To locate your local JVC service center or dealer in Canada please call In Eastern Canada In Western Canada En Frangais Montr al 1 416 293 1311 1 604 270 1311 1 514 871 1311 Or visit us on the web at www JVC ca 11 JVC JVC COMPANY OF AMERICA JVC CANADA INC Division of JVC Americas Corp 21 Finchdene Square 1700 Valley Road Scarborough Ontario Wayne New Jersey 07470 Canada M1X 1A7
7. he screwdriver 10 Reinstall the speaker cover Replace the bottom of the speaker cover first Insert the two pegs located at the bottom of the cover into the holes at the bottom lip of the television cabinet When the pegs are in place gently press the top part of the speaker cover against the television to reinstall Once the speaker cover is back in place you may plug the television back into the AC power supply and return to normal television viewing If you have read the installation instructions and do not feel comfort able changing the lamp yourself please call for a service technician Continued on the next page 7 Warning Messages If the lamp replacement was successful the television will operate normally If there was a problem with the installation one of several messages may display on the front panel LED lights Lamp installed on a slant or not fully inside the television If the lamp assembly has been installed into the unit slanted not flat or is not fully inserted into the lamp housing inside the television when the television is turned on the ON TIMER and POWER light will flash The 10 LEDs will light then turn off one each five seconds When all LEDs are off the television still will not display a picture To correct Reinstall the new lamp assembly Repeat the lamp instal lation steps taking care to observe all warnings Make sure when the lamp assembly is reinstalled it is inserted into the unit so it s
8. its FLAT inside the unit e If the ON TIMER light and or POWER light is flashing you need to reset the television Reset the television by unplugging the power cord from the AC outlet and then plugging the cord back into the outlet again a little later Filter not properly reinstalled If the filter assembly has not been correctly reinstalled or if the filter has been damaged the television will not turn on When the Power button is pressed the 10 LEDs will turn on then one will turn off every five seconds When three have turned off the television will then enter a cool down mode and the power will turn off To correct Check to see that the filter has been installed properly Repeat steps 1 to 5 and 8 to 10 You do not need to remove and reinstall the lamp If the television still does not turn on the filter may have been damaged Call a service technician for repair If the television does not work properly or displays a message not listed here call a technician for service JVE ___ Warranty For Canadian model televisions see the separate sheet for Canadian Warranty information JVC COMPANY OF AMERICA warrants this product and all parts thereof except as set forth below ONLY TO THE ORIGINAL PURCHASER AT RETAIL to be FREE FROM DEFECTIVE MATERIALS AND WORKMANSHIP from the date of original retail purchase for the period shown below The Warranty Period PARTS 1YEAR LABOR 1YEAR LAMP Sonso whichever comes fi
9. overed in the Owner s Manual normal maintenance including head cleaning Warranty _ JV 4 Damage that occurs in shipment due to an act of God and cosmetic damage 5 Signal reception problems and failures due to line power surge 6 Products used for commercial purposes including but not limited to rental 7 Lamp is covered for 6 months or 2000 hours from date of purchase whichever comes first Labor to replace lamp is not included upon expiration of the lamp warranty period 8 Accessories 9 Batteries except that Rechargeable Batteries are covered for 90 days from date of purchase There are no express warranties except as listed above THE DURATION OF ANY IMPLIED WARRANTIES INCLUDING THE IMPLIED WARRANTY OF MERCHANTABILTY IS LIMITED TO THE DURATION OF THE EXPRESS WARRANTY HEREIN JVC SHALL NOT BE LIABLE FOR THE LOSS OF USE OF THE PRODUCT INCON VENIENCE OR ANY OTHER DAMAGES WHETHER DIRECT INCIDENTAL OR CONSEQUENTIAL INCLUDING WITHOUT LIMITATION DAMAGE TO TAPES RECORDS OR DISCS RESULTING FROM THE USE OF THIS PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WARRANTY ALL EXPRESS AND IMPLIED WARRANTIES INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR PARTICULAR PURPOSE ARE LIMITED TO THE WARRANTY PERIOD SET FORTH ABOVE Some states do not allow the exclusion of incidental or consequential damages or limitations on how long the warranty lasts so these exclusions or limi
10. rst THIS LIMITED WARRANTY IS VALID ONLY IN THE FIFTY 50 UNITED STATES THE DISTRICT OF COLUMBIA AND COMMONWEALTH OF PUERTO RICO WHAT WE WILL DO If this product is found to be defective within the warranty period JVC will repair or replace defective parts at no charge to the original owner Such repair and replacement services shall be rendered during regular business hours by JVC authorized service centers Parts used for replacement are warranted only for the remainder of this Warranty Period Televisions with a screen size of 25 inches and larger are covered on an in home basis WHAT YOU MUST DO FOR WARRANTY SERVICE Either contact the selling dealer retailer or call 1 800 252 5722 to arrange in home service In home service will require clear access to the Television by the service technician WHAT IS NOT COVERED This limited warranty provided by JVC does not cover 1 Products which have been subject to abuse accident alteration modification tampering negligence misuse faulty installation lack of reasonable care or if repaired or serviced by anyone other than a service facility authorized by JVC to render such service or if affixed to any attachment not provided with the prod ucts or if the model or serial number has been altered tampered with defaced or removed 2 Initial installation installation and removal from built in entertainment centers and other mounting systems 3 Operational adjustments c
11. tations may not apply to you This warranty gives you specific legal rights and you may also have other rights which vary state to state JVC COMPANY OF AMERICA 1700 Valley Road DIVISION OF JVC AMERICAS CORP Wayne New Jersey 07470 http www jvc com REFURBISHED PRODUCTS CARRY A SEPARATE WARRANTY THIS WAR RANTY DOES NOT APPLY FOR DETAILS OF REFURBISHED PRODUCT WAR RANTY PLEASE REFER TO THE REFURBISHED PRODUCT WARRANTY INFORMATION PACKAGED WITH EACH REFURBISHED PRODUCT For customer use Enter below the Model No and Serial No which is located either on the rear bottom or side of the cabinet Retain this information for future reference Model No Serial No Purchase Date 1 0 Name Of Dealer Authorized Service Centers QUALITY JVC SERVICE HOW TO LOCATE YOUR JVC SERVICE CENTER TOLL FREE 1 800 252 5722 http www jvc com Dear Customer In order to receive the most satisfaction from your purchase please read the instruction booklet before operating the unit In the event that repairs are necessary please call 1 800 252 5722 or visit our website at www JVC com Remember to retain your Bill of Sale for Warranty Service Do not service the television yourself Caution To prevent electrical shock do not open the cabinet There are no user serv iceable parts inside Please refer to qualified service personnel for repairs Accessories To purchase accessories for your JVC product please call toll
Download Pdf Manuals
Related Search