Jensen NAV-104 Installation Guide
Contents
1. 8 ao a To avoid shorts in the electrical system be sure to disconnect the negative battery cable before beginning installation NOTE Be sure to install the NAV104 in such a way that the SD Card is accessible after install allowing for the removal and insertion of the SD Card for future changes to map data or upgrades Compatible Head Units e VM9215BT e VM9225BT e Select Jensen Multimedia Head Units 128 90882. JENSEN NAV104 Installation Guide Insert one end of the SmartBus cable into the DATA BUS slot on the side of the NAV104 and secure it with an 11 mm 0 4 in screw provided Connect the other end of the cable to the NAV104 input on the back of your Jensen navigation ready head unit gps ANTENNA im ii ea Smartbus Cable with 11 mm 0 4 in Screw Where applicable secure the cable to the radio using an 11 mm 0 4 in screw VNNALNV Sd9 Jensen 1 0 DIN Head Unit Attach the GPS Antenna to the 7X N ANTENNA jack on the J side of the Some compatible head units have a cable to cable connection and do not require an anchor screw NAV104 PEA E _Mavios GPS Navigation System ca me a O oom R a P j I t GPS Antenna UAUA AAU iin bo A Cie elie lt NAV Bus CARD stops then release The card will lock firmly into eo OC place inside the SD Card Slot Parts List Vv NAV104 navigation module V Antenna with magnetic mount Four rubber feet to a
3. ffix to the bottom of the NAV104 in the recessed area near each corner SmartBus cable used to connect the NAV104 to the Jensen navigation ready radio 4y One 4 Gigabyte SD Card pre loaded with map navigation software Vv Two 11 mm 0 4 in screws for fastening the SmartBus cable to the radio and NAV104 Warnings Do not install components in areas which are susceptible to rain moisture direct sunlight extreme heat or cold excessive dust dirt or humidity Do not install the NAV104 where it will obstruct the driver s view or interfere with the vehicle s operating system or safety features air bags hazard light buttons etc Use only installation parts and hardware provided with the unit Use of other parts can cause malfunction and possible damage to your navigation system This product should only be installed in vehicles with a 12 Volt battery with negative grounding Check the battery voltage of your vehicle before installation Be sure to secure all wires cables away from the steering wheel shift lever and gas or brake pedal Do not cut the GPS Antenna Cable to shorten or lengthen it NAV104 Placement The NAV104 should be installed under the back or front seat It can also be installed in the trunk if necessary Do not install the NAV104 where it will come in contact with water or direct sunlight 5 L wA Hi F fF a a i T F 5 r P go poy a B Eo nt See s Bs ay Z 3 Yee E a i p F
Download Pdf Manuals
Related Search