Jensen BT360 User's Manual
Contents
1. ready to go You will not need to re pair your phone each time Bluetooth Car Kit User Manual Using the remote control The BT360 is operated using a wired remote control Play Pause FM Previous Song Next Song Volume up Volume Down Answer End Dial Last call Voice Dial Control Module Functions Volume Press during operation to increase or lower the volume Up Down Answer Dial Press to answer a call For call waiting press to answer a Last Call second call during a call Press again to return to the first call To redial the last number called press and hold End Press to reject disconnect a call Press and hold for two Voice Dial seconds to activate the Voice Recognition function After the tone say the name and the phone will automatically dial Note The voice dial function works only when the mobile phone supports this function OLED Display Display s caller ID FM Transmitter Frequency Pairing Information Paired Phone Name Status Play Pause FM Press to activate FM transmitter mode play or pause digital music stored on your A2DP phone Next Previous Press to play next or previous song Song Pairing phones To use a phone with your BT360 you must first pair the phone and receiver 1 DO NOT attempt to pair a phone while driving Park your car and with the ignition on proceed 10 Bluetooth Car Kit User Manual 2 Press and hold the A2. OF THIS OR ANY OTHER WARRANTY No person or representative is authorized to assume for the Company any liability other than expressed herein in connection with the sale of this product The company does not warrant that this product cannot be compromised or circumvented THE EXTENT OF THE COMPANY S LIABILITY UNDER THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT PROVIDED ABOVE AND IN NO EVENT SHALL THE COMPANY S LIABILITY EXCEED THE PURCHASE PRICE PAID BY PURCHASER FOR THE PRODUCT WITHOUT COST OF INSTALLATION Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damage so the above limitations or exclusions may not apply to you This Warranty gives you specific legal rights and you may also have other rights which vary from state to state Audiovox Electronics Corporation 20 Bluetooth Car Kit User Manual For Customer Service Visit Our Website At WWW audiovox com Product Information Photos FAQ s Owner s Manuals 2009 Audiovox Electronics Corp 150 Marcus Blvd Hauppauge N Y 11788 21
3. following Make sure that the cables can reach from the each component to the Junction Box If the cable is too short relocate the component Do not lengthen the cable The supplied microphone is uni directional For best results place the microphone in front of the person talking It has a reception angle of 60 degrees and is most effective within a 24 inch radius Installing the microphone amp speaker Find a suitable place for the microphone Remove dust and grease from the surface Remove the protective cover from the Velcro and press it firmly onto the bottom of the microphone Remove the protective cover from the other Velcro pad and firmly press the pad in place Attach the microphone Mount the speaker using two screws in a location that is not blocked and will allow the voice to be heard clearly Installing the remote control Find a suitable place for remote control that will provide the best visibility Remove dust and grease from the surface and firmly press BT360 control in place with the sticker pads provided Bluetooth Car Kit User Manual Getting Started Introduction The Bluetooth Wireless Car Kit is designed to help make your driving experience more convenient safe and provide you with years of trouble free use Product overview and features This Car Kit is designed to make driving your car and talking on the phone safer and easier It consists of an OLED display remot
4. this example phone B Resetting the Car Kit If for any reason you need to reset the BT360 back to the factory settings and delete all paired phones follow these instructions Master Reset gt 12 Bluetooth Car Kit User Manual The car kit only connects to one phone at a time However it can be paired with up to 4 phones Using Master Reset function will delete all pairings To reset press and hold the Volume up and down keys at the same time Continue holding the buttons until you hear a tone After master reset all the paired setting will be erased you can now pair your phone Transferring calls Call Waiting To transfer a call from Incoming Call 1 to Call 2 Call waiting press the answer key once during the Call to pick up the new incoming call and press the answer key again to switch back to Call 1 13 Note 1 The display will not show Incoming Call 2 during the call but you will hear a waiting tone so you remember there is another call waiting Note 2 To transfer a privacy call from your phone to the BI360 follow the instructions provided with your phone Setting the FM Transmitter Mode for A2DP a Press the Play Pause key for 3 seconds to enter the FM mode The control will display FM MODE Eg M1 88 1 FM MODE b Find a radio station on your car stereo that does not already have anything playing on it This will be the station you will set the BT360 to transmit the A2DP Mus
5. JENSEN BT360 Bluetooth Car Kit User s Manual Installation and User Manual Bluetooth Car Kit User Manual Preface This publication including all photographs illustrations and software is protected under international copyright laws with all rights reserved Neither this manual nor any of the material contained herein may be reproduced without the express written consent of the manufacturer Version 2 0 March 2009 Trademarks Other product names mentioned herein are used for identification purposes only and may be trademarks and or registered trademarks of their respective companies Limitation of Liability While reasonable efforts have been made to ensure the accuracy of this manual the manufacturer and distributor assume no liability resulting from errors or omissions in this manual or from the use of the information contained herein EE 1 identifying COMPOMCNtS ssc yeiedes vee e gege l Tnstallime the UNCON DO EE 2 ettlech eeneg eren 5 Haline themictophone ce Speak Cr siccsicsentssss ues iwidantetaaiad Seege EE 5 Mislim the Pemote COMO eeer ee ee 6 Product overview and Ee sacs tersdaal iiine TEn EE oxic ease 7 Using the remote control ccc ccccssecccesseeceessseecessseeeeesseeeeaes 9 Partin ne 10 Operation with multiple paired phones cccecsseeeeeceeeeeeeeeeeeaaeeeeeeeees 12 Resetips the Cark E 12 Transferring calls Call Wang 13 Setting the FM Transmitter Mode for A2DP ccc
6. MODE After upgrading please turn the unit off and on again by turning your Cars ignition on and off 18 Bluetooth Car Kit User Manual My mobile phone can t make a connection When my mobile phone is ringing and adjust the volume the call is disconnected My phone doesn t recognize my voice tags for voice recognition Note Not available on all phones Check your phone s user manual for availability Troubleshooting Make sure the bluetooth function on your phone is enabled Make sure the car ignition is on If on and no power check the fuses and wiring Reset the Car Kit and try again Turn your phone off and on again and try the proceedure for connection once more If your phone is very new check the support website for an upgraded software version With some phones adjusting the volume before the call is initaited will disconnect the call Wait until the call is answered then adjust the volume Re record voice tags using the method described in Notes on using Voice Recognition above Close your windows while using voice recognition Speak clearly in the same manner in which the voice tag was recorded 19 12 MONTH LIMITED WARRANTY Applies to Jensen Series Mobile Electronics AUDIOVOX Electronics Corporation the Company warrants to the original retail purchaser of this product that should this product or any part thereof other than transmitters under normal use and cond
7. cccccceeeeeeeeeeeeseeeeees 14 Last Number E E 15 VOICE DANNE espreita EE 16 kache tee 16 Notes ON USING VOICE recognition cceccceesssseeessseeeeceeeeeeeeeeaaaaeeseesseeeeeeeees 16 Updating the Bluetooth Software 17 TROUDICSMOOUNG EE 19 Waranty tal eld gate len E 20 il Bluetooth Car Kit User Manual Installation This section demonstrates how to set up and install the Bluetooth Wireless Car Kit into a vehicle Identifying components Unpack the Car Kit package and ensure the following items are included Remote Control Microphone Junction box Part 31102000 Part 31092440 Part 31102100 sry aa T ia Speaker Power Cable Fuse amp Hardware Set Part 31092430 Part 31092160 Part 31092010 Some items may vary slightly from the picture shown If any item is missing or damaged contact your dealer Installing the junction box This Car Kit is designed to work with a 12 24 volt vehicle power supply Refer to the following to install the junction box in a vehicle 1 Locate a suitable place inside the car to mount the junction box Select a dry place that avoids excessive heat and mechanical vibration Ideally the junction box should be hidden from view but still easily accessible Note Make sure that the cables are long enough to support the location of the junction box If the cables are not long enough do not lengthen the cables relocate the junction box 2 Use two screw
8. e control a uni directional microphone and a speaker When properly installed the Car Kit enables you to talk freely to the other party on your mobile phone The BI360 uses the latest Bluetooth Technology available and allows today s phones with A2DP music transfer the ability to play through your cars stereo without any connection to it The Car Kit is equipped with a mute feature which turns the volume of your car stereo down when you are using your phone This feature can be enabled by a trained installation professional See the selling dealer if you would like this feature installed The Bluetooth Car Kit is designed to function with many brands of mobile phones All features depend on your phones capability to use them For example your phone must have Bluetooth technology to use this car kit Not all phones have the same features or functions If you have a question about your phones features refer to the owners manual of your phone This Bluetooth Kit uses the latest Version of Bluetooth Software Version 2 1 In the case of an upgraded software version for new phones in the future you can obtain the software upgrade instructions and software at WWW JENSEN COM The BT360 is designed to be on when ever your car is turned on The feature allows AUTO PAIRING which means when you leave the vehicle and return as soon as you start the vehicle the BT360 will look for your phone re pair and the Hands free system will be
9. ic on so you can hear it on your stereo c To adjust the FM transmit frequency Hold the Play Pause key for another 3 seconds and then adjust to the same FM channel that you selected on your radio By pressing the forward and backward key and then press the End key to confirm the setting 14 Bluetooth Car Kit User Manual Eg PIE 3 secs gt Med or PRI to adjust gt E confirm d The BT360 can memorize 3 FM channels When playing music first enter the FM mode then press the Play Pause key one time to view the 3 set stations you have selected M1 M2 M3 NOTE The music will be muted automatically when a calls comes in Calls are heard only through the BT360 Speaker not the car speakers Last Number Re Dial Press and hold the Send key o to activate the last dial feature Eg Nokia N95 Last Dial 15 Voice Dialing Press and hold the End Key to activate the voice dial Eg Nokia N95 Voice Dial Note Voice dialing MUST be supported by your phone to use this feature Multimedia Function Using the Multimedia buttons to Play Pause Stop and jump to Next or Previous song Note For some mobile phones users will need to turn on the MP3 before BT360 can play the Media function Notes on using voice recognition Voice recognition is a feature of your phone which enables you to dial a number by simply saying a pre recorded voice tag Normally when you set a voice tag
10. itions be proven defective in material or workmanship within 12 months from the date of original purchase such defect s will be repaired or replaced with new or reconditioned product at the Company s option without charge for parts or repair labor To obtain repair or replacement within the terms of this Warranty the product is to be delivered with proof of warranty coverage e g dated bill of sale specification of defect s transportation prepaid to an approved warranty station This Warranty is not assignable or transferable This Warranty does not cover damage to the vehicle s electrical system or costs incurred for removal or reinstallation of the product This Warranty does not cover batteries nor apply to any product or part thereof which in the opinion of the Company has suffered or been damaged through alteration improper installation mishandling misuse abuse neglect accident or by removal or defacement of the factory serial number bar code label s This Warranty is in lieu of all other express warranties or liabilities ANY IMPLIED WARRANTIES INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY SHALL BE LIMITED TO THE DURATION OF THIS WRITTEN WARRANTY ANY ACTION FOR BREACH OF ANY WARRANTY HEREUNDER INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY MUST BE BROUGHT WITHIN A PERIOD OF 24 MONTHS FROM THE DATE OF ORIGINAL PURCHASE IN NO CASE SHALL THE COMPANY BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES FOR BREACH
11. nswer redial and VW End Voice dial buttons at the same time for 3 seconds until you hear a tone and the Display shows pairing 3 Be sure Bluetooth is enabled on your phone Follow the documentation provided with your phone to search for new devices 4 Select the BT360 from the list of Bluetooth devices on your phone 5 Enter the passcode 1234 when prompet on your phone 6 The Display on the BT360 will show the phone model or name and a connected sign when the pairing is established Eg Nokia N95 Connected Note You may follow the above steps to pair a second third and fourth phone Pairing a fifth phone will cause the first phone paired to be deleted II Operation with multiple paired phones When the ignition is turned on the BT360 begins to search for paired phones Priority is given to the most recently connected phone Example Phone A is connected first phone B is connected second and phone C is connected third If all three phones are in the car when the ignition is turned on phone C will establish a connection with the BT360 Note If phone C is turned off or if the person using it leaves the car and goes out of range the connection will be broken In order to establish another connection with one of the remaining phones press the answer redial button once or restart the ignition The BT360 performs another search and establishes a connection with the most recently connected phone in
12. s not included to fasten the junction box in place Cla lt q Bluetooth Car Kit User Manual Connecting the power supply The following illustration demonstrates how to connect the Car Kit s power cables to the vehicle s electrical system Yellow cable To car radio mute NPN 300m4 ee een Red cable Ne o battery 12 24 s Blue cable e To ignition Na Black cable NU Power cables Important The Blue cable must be connected to the 12 24 volt switched ignition to enable the Car Kit to go into standby mode Do not connect the Blue cable to the 12 24 volt constant connection Doing so may discharge the battery of the vehicle and prevent the Car Kit from being reset Connecting Components The following illustration shows where to connect the devices Do not connect the components until you have followed the next steps and have finalized your installation CONNECT THE POWER HARNESS LAST Speaker Microphone A Control Module Speaker Microphone unction box Control Module The control module should be located within reach and view of the driver For best reception the speaker should be mounted at least 80 cm 30 inches from the Car Kits microphone Ideally the microphone should be located in front of the user and above waist height Bluetooth Car Kit User Manual Installing the Components Before installing the components take note of the
13. you speak directly into the phone When accessing this feature with the Car Kit you may find it is necessary 16 Bluetooth Car Kit User Manual to re record the voice tag while you are in the car This will set not only the way you say the voice tag but also record a familiar background noise Since phones are in continual contact with the Car Kit it is possible to use the included Car Kits microphone to record the voice tag Locate the feature on your mobile phone and when prompted for the voice tag speak clearly from a comfortable position in the driver s seat Note Some phones have speaker independent voice recognition technology and do not require users to pre record voice tag Refer to your phones users manual for more specific information Updating the Bluetooth Software The BT360 has the ability to be upgraded to give you many years of use and to be compatible with newer versions of phones There is a complete manual that explains the upgrade process available at WWW JENSEN COM We do not recommend entering this mode without first downloading the upgrade information and reading it completely It is possible to render your car kit in operable if you do not complete this process correctly This would not be covered under warranty as it would not be considered a defect To enter upgrade mode hold the Volume UP and Down keys and then power on the BT360 The display will show BT Update 17 BT Update USB
Download Pdf Manuals
Related Search