JAMO R-300 User's Manual
Contents
1. R 300 WARNING Improper installation could result in damage to the re ceiver Read all instructions before installation Jano Lets get personal Introduction The R 300 has its electronics housed in a brass cylinder The front end of the unit is a small round lens This small receiver is designed to be placed in very tiny spaces One example is a small corner of an equipment cabinet or in the front baffle of the Jamo in wall speakers A single 2 inch hole will accommodate the R 300 The high sensitivity of this receiver gives you the ability to place the R 300 further away from the hand held remote increasing the placement options you have CONNECTING THE RECEIVER Use the supplied screw terminal block to extend cables to the connecting block red or white USING THE RECEIVER To use the system simply point the hand held remote control trans mitter at the window on the R 300 receiver and press the proper button The R 300 does not change the way your remote control works The hand held remote control transmitter for the stereo re ceiver will only operate the stereo receiver Likewise other trans mitters will only operate their companion devices The maximum distance between the transmitter and the R 300 re ceiver will be different for each transmitter and when used dir2. ectly with the controlled device The system may be left on continuously as it does not affect the normal operation of the remote controlled device and consumes very little power FEATURES Extremely small package only 2in 51mm deep Works in normal 3 wire mode Talkback green LED tests system for correct wiring as well as indicating infrared reception RF Grid included for EMI interference reduction The R 300 is available in two versions as follows R 300B Standard version with mini 3 conductor 18 feet ribbon cable and separate screw terminal block supplied R 300W Same as the R 300B except with white bezel SPECIFICATIONS Infrared modulation frequency bandwidth 30 100 kHz Nominal reception range gt 30 feet 9m Nominal reception angle 55 degrees off axis Cable requirements for long lengths three conductor 24 AWG 200ft 60m 22 AWG 600ft 180m 20 AWG 2000ft 600m 18 AWG 5000ft 1500m unshielded OK Maximum cable length 1 mile 1 6 km with 18 gauge Maximum current output 100 milliamps Maximum number of directly driven IR emitters Up to four connected in series Use Jamo Connecting Blocks for emitter expansion Power requirements 12 volts DC 10 mA Requires PS 1 power supply Dimensions Y2in 13mm diameter 2in 51cm deep The scope of the warranty The warranty period will come into force as from the purchase date stated on the invoice The warranty will apply for the
3. following period of time e 2years for electronics power supply amplifier etc 7 years for other parts cabinet speaker units etc In case of warranty inquiries please contact your dealer In case of request for service under warranty please enclose your original receipt Defects covered by the warranty Except for the defects stated below the warranty covers any production and material defects of the product Defects not covered by the warranty e Defects arising from accidents misuse normal wear and tear mis maintenance voltage variation overloading stroke of lightning and other force majeure events Defects arising from incorrect installation or operation Defects arising from modification repair attempt of repair by a non authorised service centre Defects arising from the use of non original spare parts Defects on products with altered or lacking series number Other defects due to conditions or circumstances beyond the supplier s control Transportation costs for servicing are not covered by the warranty The supplier is liable only to repair or replace defective parts or products A replacement cannot exceed the value of the product under warranty 69428 33 2000
Download Pdf Manuals
Related Search