Ives 926 User's Manual
Contents
1. with short screws see Fig C or Fig D Open door and move hold open washer back of lugs on rod Closer is now ready to operate The closing speed may be regulated by turning adjusting screw see Fig E CONTROLLED LATCHING POWER FEATURE Installed as directed with the door bracket attached to the front hole of the door closer the by pass valve built into this closer will accelerate the closing speed of the door in the last few inches of travel This attachment position is recommended when the glass storm panel is in place if a smoother more quiet closing action is desired hold door open about 8 with hold open washer remove long connecting pin from door bracket and relocate in closer tube REAR hole This position is normally used when the screen panel is in place see Fig C or Fig D MULLION STRIP NEAR CENTER WHICHEVER IS DESIRED SEE THAT IT CLOSES FREELY FOR HEAD JAMB BRACKETS chech i type of Dackel be ga closed ot fod on top a Diacket and insert pn Spread spbi end shontly JAMB Short FIG B Connecting HOLD OPEN Pin i ADJUSTING SCREW H B IVES a Harrow Company 62 Barnes Park North P O Box 5035 Wallingford CT 06492 l Phone 203 294 4837 Fax 203 284 1460 MADE IN U S A2. he adjusting screw see illustration below Door Panel Door Frame Jamb If less closing power is required hold door open about 8 with hold open washer remove long connecting pin and relocate in rear hole C STEP 1 STEP 2 926 PNEUMATIC DOOR CLOSER OBSOLETE INSTALLATION INSTRUCTIONS Use of a little oil or soap THI CLOSER MAY BE INSTALLED ON RAIL AT TOP OF DOOR OR ON on threads makes driving screws much easier NOTE BEFORE INSTALLATION CHECK DOOR TO At desired height fasten jamb bracket to door Hdl with open side 1 4 from door as shown See ig A ee more latching force is desired jamb bracket may be moved up to 1 away from door NOTE Moving the jamb bracket further from door nominally reduces door opening Slide hold open washer on rod Using short connecting pin connect closer to jamb bracket Hold open washer should be positioned over lugs against closer tube as shown This will give proper tension for installation Do not change until installation is completed See Fig B Two styles of door brackets are made See Fig C amp Fig D Your closer comes with only one Attach door bracket to closer tube FRONT hole with long connecting pin see Fig C or Fig D With door tightly closed hold closer and door bracket against door in level position mark and drill two 1 8 pilot holes CAUTION Do not drill through door Fasten door bracket to door as shown
3. wee 6 PNEUMATIC DOOR CLOSER 926 PNEUMATIC DOOR CLOSER IVES 900 IVES bardware bas provided style and durability for American bomes Since 1876 Our commitment to qual ity makes IVES a name you can trust DOOR CLOSER FOR INSTALLATION ON RAIL AT TOP OF DOOR OR ON MULLION STRIP NEAR CENTER INSTALLATION INSTRUCTIONS NOTE Be sure door closes freely before installing TOOLS REQUIRED 1 8 drill bit Phillips screwdriver awl or pencil 1 Determine desired height Position jamb bracket 1 4 in from door and fasten to door frame see illustration below Open side of bracket must be facing screen or storm door Soe e Jamb Bracket SE Door Frame Jamb 2 Slide the hold open washer onto rod Use short connecting pin to connect closer to jamb bracket The hold open washer should be placed over lugs against closer tube see illustration below This will Provide proper tension for installation and should not be adjusted until installation is complete Lui Connecting J Hold Open 3 gt A A 3 Use long connecting pin to attach door bracket to closer tube Tightly close and latch door and hold closer and door bracket in level position Mark and drill two 1 8 diameter pilot holes Fasten to door with short Screws provided see illustration below Door Bracket of 4 Open door and move hold open washer behind lugs on rod The closing speed can be regulated by turning t
Download Pdf Manuals
Related Search