Ives 7215PT User's Manual
Contents
1. QZ Installation Instructions 7215PT 7226PT and 7227PT 3 4 Offset Intermediate Power Transfer Pivot Left hand installation shown VTL right hand opposite Right hand Left hand installation installation L Door leaf Prepare and mortise hinge stile of door and hinge side jamb to receive pivot set Determine pivot location using dimensions reverse side The pivots are handed and must match hand of door To determine hand of door and proper pivot position see diagrams above Install top and bottom pivot sets before installing intermediate pivot set Locate drill and tap 1 4 20 mounting holes for metal door or metal frame Locate and drill pilot holes for 14 wood screws for wood door or wood frame Drill and deburr 1 2 dia wiring access holes Be sure door is installed on top and bottom pivots and swings freely before proceeding Do not separate pivot leafs Pivot must be installed assembled Disassembling pivot leafs will void the warranty Open door about 90 Check to make sure that pivot fits freely into door and frame preps To avoid serious damage and or shortened life do not force pivot into prep Attach wires per project wiring diagrams Make wire connections with appropriate crimp splices or wire nuts Staggering the terminations for easier insertion of wires through the access hole in frame Insulate ends of all unused wires After all connections a2. re completed carefully fit wires through access hole in frame making sure that wires will not be cut or pinched Install pivot leafs to door and frame with 1 4 20 x 3 4 FHMS or 14 FHWS screws provided CAUTION Improper pivot set installation can lead to personal injury or property damage Follow all instructions carefully For questions contact Technical Support at 1 888 371 7331 aim Ingersoll Rand 27070 Rev 3 2006 Ingersoll Rand Company Limited Security Technologies It is very important for installer to verify that intermediate pivot point lines up with center line of top and bottom pivot points before final installation Both door and frame pivot leafs located from face of door Intermediate pivot should be evenly spaced between top and bottom pivots Heel edge of door must be beveled 1 8 in 2 Frame Leaf Door Leaf N P 9 16 Reference line ba i 14 mm X i m ea RN Face of t 4 x 3 8 ugor 716 10 mm 11mm 3 4 19mm gt ma x A r a E e SLAA TNA 5 16 t LA 8mm _ a Face of door O M imm on Right hand installation shown left hand opposite 2 070 00 27070 Rev 3
Download Pdf Manuals
Related Search